Transducer Interface Boards

Computer Hardware & Peripherals, Test & Measuring Instruments

COM Express Module supports data-centric applications.

November 12, 2015

Measuring 125 x 95 mm, Model PCOM-B634VG utilizes Intel® Xeon® Processor D-1500 Family, which integrates up to 8 CPU cores, each with three 1.5 MB cache, of up to 12 MB in total. Module provides one PCIe x16 and eight PCIe x1 channels, one standard GbE interface plus two 1/2.5/10 GbE Intel® Ethernet interfaces in C/D pin row. Three SODIMM memory slots support dual-channel DDR3L-1600 or DDR4-2400 configurations with max capacity of 128 GB and ECC support. Read More

Computer Hardware & Peripherals, Test & Measuring Instruments, Electrical Equipment & Systems

Power Interface Boards support VITA 62 power supplies.

November 12, 2015

Available in 3U and 6U heights in either single or dual PSU formats, Pixus VITA 62 Power Interface Boards feature header for voltage sense and IPMB for VITA 46.11 system management or other IPMI-based options. Units have several power bugs for 3.3, 5, and 12 V power as well as 26-pin header that accommodates general purpose I/O signals from PSUs. To optimize chassis cooling, breakaway tabs at bottom of board allow optional blockage of airflow. Read More

Electronic Components & Devices, Computer Hardware & Peripherals, Test & Measuring Instruments

Evaluation Boards support SuperSpeed USB-to-FIFO bridge ICs.

September 16, 2015

Measuring 78.7 x 60 mm, UMFT600A and UMFT601A each have high speed mezzanine card interface with 16-bit and 32-bit wide FIFO buses respectively. UMFT600X and UMFT601X have dimensions of 70 x 60 mm and incorporate field-programmable mezzanine card connectors, again with 16-bit and 32-bit wide FIFO buses. Compatible with USB 3.0 SuperSpeed, USB 2.0 High Speed, and USB 2.0 Full Speed data transfer, modules support 2 parallel slave FIFO bus protocols with achievable data burst rate of 400 MB. Read More

Computer Hardware & Peripherals, Test & Measuring Instruments, Electronic Components & Devices

DAS Interface Trays promote wireless/broadband device performance.

May 21, 2015

Offering PIM ratings as low as -160 dBc, configurable Distributed Antenna System (DAS) interface trays improve signal strength and alleviate issues caused when large numbers of people try to send/receive messages, calls, and data in densely populated area. Interface trays, compliant with multiple carrier and neutral host requirements supporting frequency bands from 380 MHZ to 6 GHz, provide single connection point when using single or multiple base stations. Read More

Computer Hardware & Peripherals, Test & Measuring Instruments

VME Interface Board supports radar video applications.

April 20, 2015

Combining Intel® Core™ i7-based single board computer and radar video processing capabilities on single-slot 6U VME module, Cougar 2 accepts both analog and digital radar signals. Dual-channel unit supports wide range of radar interfaces including radar video, triggers, and azimuth turning data. Module eases integration of radar video capture, conversion, and mixing into deployed vessel tracking, airborne target tracking, and airport ground movement applications. Read More

Test & Measuring Instruments, Computer Hardware & Peripherals

Interface Board provides controls with PROFINET-IO option.

January 12, 2015

Certified by PROFIBUS user organization, PROFINET-IO interface board (ID 825866-02) provides those interested in conversationally friendly TNC controls more options. Board provides device files in GSDML format and can be connected as consumers within PROFINET-IO’s provider-consumer (master-slave) concept. Product is not suitable for isochronous real-time applications (Conformance Class C), and IOconfig v3.0 or higher PC software is required to configure bus systems that can be connected to TNC. Read More

Test & Measuring Instruments, Computer Hardware & Peripherals, Software

DCMSYS Interface enhances medical facility data flow.

December 8, 2014

Accommodating medical facilities of any size, WebBridge allows any native or Web-based, third-party application to upload any non-standard data to DCMSYS Enterprise Imaging Suite and Vendor Neutral Archive. Users can connect to DCMSYS product suite to access patient data, search studies, link data to appropriate study, as well as store, modify, share, and connect to any repository. Data may be retrieved in presentation-ready format, as specified by requester, or in native DICOM format. Read More

Test & Measuring Instruments, Computer Hardware & Peripherals

Multifunction Interface Board adds I/O options to serial devices.

December 2, 2014

Designed to mount on rear panel of host chassis with connectors protruding through rear panel, Model 9006 adds Ethernet, GPIB, and USB interfaces to RS-232/-485 serial devices. All interfaces are IEEE-488.2 compliant, respond to 488.2 Common Commands, and provide GPIB-like functionality to extent possible with interface protocol. Ethernet port supports VXI-11 and raw socket protocol as well as internal HTML Web server. All settings are saved in internal flash memory. Read More

Test & Measuring Instruments, Computer Hardware & Peripherals, Communication Systems & Equipment

PCIe Interface Board adds up to 19.2 Tflops of compute power.

November 26, 2014

Using Intel® Silicon Photonics technology, High Density Compute Accelerator enables x8 PCIe 3.0 operating at 64 Gbps to be transmitted over MXC passive optical cables. Half-height, half-length adapter card also supports PCIe sideband signals and Spread Spectrum Clock Isolation. Supporting up to 16 Intel® Xeon Phi™ Coprocessors, appliance can be attached to up to 4 servers for hundreds or thousands of additional compute cores. Each connection operates at PCIe x16 3.0 with speeds up to 128 Gbps. Read More

Test & Measuring Instruments, Computer Hardware & Peripherals

CAN Cards for PCI Bus support up to 4 high-/low-speed channels.

November 7, 2014

Modularly expandable CAN-IB300/PCI and CAN-IB400/PCI let users connect computer to CAN-system for control applications and perform analysis, configuration, and troubleshooting. While CAN-IB300/PCI is passive card, active CAN-IB400/PCI has 32-bit MCU system that enables intelligent handling and active filtering of messages sent and received on card. Interfaces can be equipped with up to 4 LIN or K-Line interfaces as well as customer-specific interfaces upon request. Read More

Test & Measuring Instruments, Computer Hardware & Peripherals, Electronic Components & Devices

Daughter Cards enable comprehensive external interfacing.

November 4, 2014

Available in 6 models, Arduino-compatible VM800P PLUS Boards are based on FT800 EVE graphic controller devices, in which display, audio, and touch functionality are integrated onto single chip. Boards also incorporate 8-bit ATMEGA microcontroller and TFT display with 3.5, 4.3, and 5.0 in. sizes available. Using 1 or 2 Micro-MaTch miniature connectors to interface with VM800P, daughter cards allow expansion of boards’ I/O capabilities so they can be implemented into wide range of applications. Read More

Test & Measuring Instruments, Computer Hardware & Peripherals, Green & Clean

Evaluation Module suits video and data display applications.

September 2, 2014

Featuring standard HDMI interface and plug-and-play functionality, DLP® LightCrafter™ Display 2010 Evaluation Module allows quick assessment of DLP Pico™ 0.2 in. TRP WVGA display chipset. Ultra low power chipset, rated at 180 mW, consists of DLP2010 digital micromirror device, DLPC3435 display controller, and DLPA2005 power management/LED driver. Evaluation module includes 50-pin board-to-board connector that enables interface with broad range of optical engines. Read More

Test & Measuring Instruments, Computer Hardware & Peripherals

Rugged 3U VPX Carrier Cards aid PMC or XMC integration.

July 30, 2014

Used for interfacing PMC or XMC module to VPX computer system, VPX4810 and VPX4812 route power and interface bus signals to plug-in mezzanine module through VPX card slot connector. Both have 8-lane PCIe bus Gen 2 interface and support any standard IEEE-1386.1 module for flexibility to address I/O signal processing tasks. While VPX4810 has 64 I/O lines (P14, VITA 46.9) supported via P2 VPX connector, VPX4812 I/O is supported via P16 XMC connector. Read More

Test & Measuring Instruments, Computer Hardware & Peripherals, Electronic Components & Devices, Green & Clean

Data Processing Board routes 4 low latency signals to RTM.

May 23, 2014

Supplied in double module, mid-size format, Model CM045 meets MicroTCA.4 specification with rear I/O interface. Board features 16 GB of DDR3 memory, 8 SFP+ ports via front panel,  and Kintex-7 FPGA with x4 PCI Gen 3 signaling across fat pipes. Board is suited for several High Energy Physics applications such as cavity field stabilization and standing-wave linear accelerators, as well as other systems requiring high speed DSPs and low latency. Read More

Test & Measuring Instruments, Computer Hardware & Peripherals, Controls & Controllers

DAQ Boards are designed for OEM and embedded applications.

May 19, 2014

Featuring header connectors for facilitated integration into OEM applications, multifunction USB DAQ boards come in 6 models that offer up to 500 kS/s sampling, 8 or 16 DIO, and up to 2 analog outputs. Software support includes out-of-the-box DAQami and TracerDAQ® for data logging and display along with support for Visual Studio® and Visual Studio® .NET, DASYLab®, NI LabVIEW™, and MATLAB®. With UL for Android™ support, users can develop DAQ applications that run on tablets and smartphones. Read More

Test & Measuring Instruments, Computer Hardware & Peripherals, Green & Clean

Carrier Hub enhances MicroTCA-based systems.

May 6, 2014

Along with 40 GbE option, synchronous Ethernet, and advanced clocking/GPS capability, UTC004 MicroTCA Carrier Hub (MCH) provides PCIe Gen 3, SRIO Gen 2, and crossbar switch (CBS) option. Latter allows any fabric to be utilized, including custom solutions. Module enables flexible master/slave clock and time synchronization to multiple clocking standards, features quad PLL clock network synchronizer, and supports JTAG Virtual Probe for remote programming or debugging. Read More

Test & Measuring Instruments, Computer Hardware & Peripherals

COM Express Type 6 Carrier Cards aid SFF systems development.

March 31, 2014

Used in SFF computing systems that require -40 to +85°C operation and shock/vibration immunity, ACEX-4600 carrier cards provide rugged host for Type 6 CPU and PMC/XMC modules. There are three models available to host basic size COM Express module and, optionally, one or two PMC/XMC modules for FPGA or I/O processing tasks. All models include 2 mini-PCIe slots, and mezzanine module slots are located on opposite side of CPU module to maintain compact footprint. Read More

Test & Measuring Instruments, Computer Hardware & Peripherals

Two-Port 40 GbE Fiber QSFP+ Adapter increases network speed.

February 13, 2014

Designed with 40G Ethernet technologies compliant with IEEE 802.3ba standard, NIP-86020 delivers high-bandwidth and Ethernet connectivity for performance-driven server and storage-intensive applications. Adapter leverages Mellanox® Connectx-3 Ethernet controller, supports dual fiber QSFP+ ports, and provides IPv6 offloading, IEEE 1588 precision time protocol circuitry synchronization performance, RDMA over Converged Ethernet (RoCE), and Jumbo Frame functions. Read More

Test & Measuring Instruments, Computer Hardware & Peripherals, Communication Systems & Equipment

USB/RS-232 Serial Adapter enhances Android device connectivity.

February 5, 2014

By using Android Open Accessory protocol to make Android device recognize onboard USB port as RS-232 port, ANDROID-232 lets users control legacy RS-232 devices directly from Android devices and vice-versa. This industrial- and military-grade, 2-way data port supports serial data rate up to 921.6 kbps (max of 115.2 kbps without flow control), and onboard circuitry provides power to charge Android device while connected. USB serial interface board is rated for -40 to +85°C operation. Read More

Test & Measuring Instruments, Computer Hardware & Peripherals

Interface Board controls RS-232 and RS-485 Modbus RTU devices.

February 4, 2014

With Model 9009, temperature chambers and other Modbus controlled slave devices can be controlled from Ethernet, GPIB, or USB source or test system. Board's Ethernet port supports VXI-11 and raw socket protocol, Modbus TCP/IP conversion, and internal HTML web server. Modbus TCP/IP packets are directly converted into Modbus RTU packets. With Control Page, WebServer lets user enter commands from any web browser. Model 9009 does all Modbus RTU packet formatting and handles response packets. Read More