National Instruments Corp.    Austin, TX 78759-3504
May 03, 2012 Featuring unlimited mechanical lifetime, NI PXI/PXIe-2543 switch module gives RF test engineers solution with which to optimize routing of RF signals up to 6.6 GHz. Solid-state architecture provides long life and integrated PXI triggering provides fast and repeatable measurements. Suited for multisite test, this 6.6 GHz dual 4x1 multiplexer, intended for high-density RF switching, features 50 ohm termination on all channels.

PESA Industries, Inc.    Huntsville, AL 35805
Apr 25, 2012 Available in 22 configurations, easyPORT Throw Down Converter Boxes are based on 4-port utility switch, which incorporates standard SFP-type pluggable module card cages that can be populated to support any combination of I/O signals, including HDMI/DVI, 3G-SDI, ASI, NTSC/PAL, and IP-to-ASI conversion. All video formats are transcoded or converted internally, and signals can be distributed over several possible transmission paths, including coax, fiber, and CATx for IP.

PESA Industries, Inc.    Huntsville, AL 35805
Apr 06, 2012 Based on E-DXE Enterprise Data Exchange Engine, 24-bit, 96 kHz DRS Series uses high-speed multiplexing technology for signal distribution. DXE frame provides all essential signal processing features, including input sample rate conversion, input gain, and phase inversion. DRS Series-C uses internal control card to support 64 mono I/O in 1 RU frame, while DRS Series-M supports four 512 x 512 I/O frames and DRS Series-E supports up to five 1,536 x 1,536 I/O frames.

XKL, LLC    Redmond, WA 98052
Apr 05, 2012 Featuring 1RU form factor, 100G DWDM Universal Starter Kit will boost optical channel rates to 100G per lambda. Design supports 10G and 100G on client side; 100G optical transport systems are designed to deploy as requirement for higher bandwidth applications and to aggregate internal service elements within carrier networks. For WAN and backbone regional networks, spectral efficiency is important in system engineering design.

Broadcom Corp.    San Jose, CA 95110
Dec 27, 2011 Comprised of BCM8414 demultiplexer for receiving data and BCM84142 multiplexer for transmission, 40G PHY Chipset leverages CMOS technology for 40G optical transmission using DQPSK modulation. Product integrates more than 20 Gbps IOs, which promotes developing devices that will support 100G optical transmission. Chipset's 2 x 23 Gbps to SFI-5.1 demux provides 2 receivers for data recovery on I and Q channels, while fully integrated multiplexer and precoder accept SFI-5.1 data.

Pickering Interfaces Inc    GRANTS PASS, OR 97526
Dec 08, 2011 Available in un-terminated 4-way or 6-way multiplexer configurations, Model 40-874 supports 1 or 2 microwave switches in 2 slots of 3U PXI. Each configuration is available with 6, 26.5, or 40 GHz specified frequency range. Two-slot PXI occupancy allows test system designers to solve dense microwave switching problems. Compatible with any PXI compliant 3U PXI chassis, Model 40-784 is supported by Pickering Modular LXI chassis' for Ethernet-based control applications.

Exar Corp.    Fremont, CA 94538
Jul 25, 2011 Designed to help future-proof networks, Model MXP2(TM) ASSP is targeted at ROADM/DWDM and Edge Aggregation platforms in OTN transport applications. Device enables development of any service-any port line cards and consolidation of service specific muxponders into single universal design. Eight watt, 2 x 10G single chip solution includes G.709 features such as ODU0, ODUflex, and GMP, enabling services to be mapped to size appropriate OTN containers and multiplexed in single multiplexing stage.

Quarch Technology Ltd    Scotland Unit 3A  United Arab Emerites
Jul 06, 2011 With QTL1390 4-to-8 SAS/SATA 6 Gbps Multiplexer and QTL1443 1-to-8 USB 3.0 SuperSpeed Multiplexer, users can remotely and automatically switch connections between multiple host and target ports. Transparent to hosts and attached devices, switches include signal forwarding capability that allows users to observe high-speed data from multiple paths using protocol analyzer. Programmable signal conditioning allows equalization and de-emphasis to be applied on individual ports.

GAO Tek Inc.    Toronto M1B2K4  Canada
Apr 29, 2011 Designed to handle video signals from multiple security cameras simultaneously, 16-channel DM2116 splits monitor into various display areas. Unit features 50 fields/s in PAL mode and 60 fields/s in NTSC mode, with input of 16 loops BNC, 1.0 Vp-p 75 W and output of 1 loop, 1.0 Vp-p 75 W. Real-time multiplexer, compatible with RS232 or RS485 interfaces, includes video loss alarm, video motion alarm, and external alarm with programmable duration from 2-999 sec.

Pickering Interfaces Inc    GRANTS PASS, OR 97526
Apr 12, 2011 Available in 2 different versions based on electro-mechanical relays, Model 40-755 Multiplexer Module supports up to 10 off SP4T RF switches. High-density version occupies 1 slot of 3U PXI chassis and uses high-density multi-way connector that is suitable for switching frequencies to 500 MHz. Using SMB connectors, higher frequency version is suited for switching signals to 1.8 GHz.

Vishay Intertechnology, Inc.    Malvern, PA 19355 2143
Apr 08, 2011 Qualified to MIL-PRF-38535, hi-rel DG408 connects one of 8 inputs to common output determined by 3-bit binary address. This 8-channel, single-ended, analog multiplexer features 44 V max supply rating, on-resistance of 100 W, and charge injection of 20 pC. Enable pin allows multiple devices to be used together to increase number of input signals per application. Offered in 3 military package options, product is optimized for high-speed data acquisition and audio signal routing.

CCTV Camera Pros    Boynton Beach, FL 33426
Mar 17, 2011 Provided with power supply and IR remote control, VM-16RT offers 16 channel BNC video inputs, 16 BNC loop out, and 4 channel audio RCA inputs in addition to 1 BNC Monitor, 2 BNC video outputs, and 1 RCA Audio Out. Supported video display modes include 8, 9, and 16 camera/channel grid; single, split, and quad screen view; sequence rotation; picture in picture (PIP); and dual PIP. Compatible with NTSC and PAL video formats, video mux also offers image freeze and selectable image zoom area.

OFS, Specialty Photonics Division    Avon, CT 06001
Mar 11, 2011 Coherent Mixer, a key component required at signal receiver in optical digital coherent scheme, is integrated with polarization multiplexer/demultiplexer, resulting in compact device that eliminates characteristics degradation at connected part. Designed for ultra-high bit rate 100 Gbps digital coherent transmission, device features loss uniformity of 1 dB or better, low skew of 1 psec or better, and polarization extinction ratio of 18 dB or higher.

CCTV Camera Pros    Boynton Beach, FL 33426
Feb 28, 2011 Supporting 4 channels of video input via BNC connectors and 4 audio inputs via RCA, Model VM-Q401A enables users to switch video screen modes for up to 4 cameras using wireless remote control. Unit can also serve as video multiplexer for VCR-based surveillance systems that need to process video signal for VCR. Processor supports quad, split, and single screen video modes as well as sequence rotation, picture-in-picture mode, and dual PIP.

Linear Technology Corp.    Milpitas, CA 95035
Dec 20, 2010 Respectively multiplexing 2 and 4 channels, LTC4312 and LTC4314 provide enable pins to connect upstream I²C bus to any combination of downstream busses or cards. Both foster I²C address expansion by providing ability to address one of multiple identical devices, resolving address conflict issues. Additionally, bidirectional capacitive buffering allows extension of I²C bus size beyond 400 pF specification and prevents signal corruption during live board insertion/removal.

Aeroflex    Irvine, CA 92618
Jul 23, 2010 Operating from 5 V supply, models UT16MX110, UT63MX111, and UT63MX112 feature asynchronous parallel LVCMOS, synchronous parallel LVCMOS, and LVCMOS SPI(TM) interfaces, respectively. Models UT63MX113/UT63MX114, operating from 5 V single and +3 V dual analog supply, offer asynchronous/synchronous parallel LVCMOS interfaces. Other models include UT63MX115 with LVCMOS SPI, UT63MX116 with asynchronous parallel LVCMOS/CMOS, and UT63MX117 with LVCMOS SPI Interface/CMOS SPI interfaces.

ComNet    Danbury, CT 06810
Jul 05, 2010 Environmentally hardened and suitable for use in unconditioned roadside or out-of-plant installations, ValueLine FVT/FVR812 transmits 8 channels of digitally encoded video, along with 2 channels of bi-directional data, and 1 bi-directional contact closure over single optical fiber. Unit is compatible with NTSC, PAL, and SECAM video transmission protocols and supports bi-directional RS232, 422, and 485 data. Bi-Color LED indicators provide status of system, video, and data.

GAO Tek Inc.    Toronto M1B2K4  Canada
Jun 25, 2010 Operating over wavelength of 1,510-1,610 nm with 20 nm channel spacing, Coarse Wavelength Division Multiplexer maximizes existing fiber optic infrastructure by transmitting multiple wavelength signals through same fiber optic cable. Unit enables dual fiber strand to support multiple network topologies and data rates. Encapsulated within non-flux metal bonding micro optic packaging, CWDM has epoxy-free optical path and offers stable performance in demanding environments.

ComNet    Danbury, CT 06810
Jun 16, 2010 ValueLine FVT/FVR412 transmits 4 channels of video utilizing digital encoding and decoding along with 2 channels of bidirectional data over one single- or multi-mode optical fiber. Environmentally hardened product, compatible with NTSC, PAL, and SECAM video transmission protocols, supports bidirectional RS232, 422, and 485 (2- and 4-Wire) data. Plug-and-play design facilitates installation, and no electrical or optical adjustments are required.

Pickering Interfaces Inc    GRANTS PASS, OR 97526
Jun 11, 2010 Suited for bulk testing of USB devices, model 40-737 uses USB Type B connector on common and USB Type A connector on 8 channels, allowing users to directly connect using industry standard USB leads. Each path is capable of supporting USB1.1 or USB2.0 with negligible impact on cabling distance supported by USB devices due to wide differential bandwidth. USB powered devices requiring highest permitted current are supported through use of low impedance power connections.