Ophir-Spiricon Inc.
Logan, UT 84321
May 01, 2008 Enabling quantitative measurement and viewing of CO₂ beams, II-VI-CO2-58 Industrial Laser Beam Analyzer diagnoses faults and corrects issues related to beam stability, alignment, tuning, and optimization. With ability to handle up to 10 kW of power, portable device features 58 mm clear aperture that enables users to measure large laser beams. Laser beam profiling system is designed to work with Pyrocam(TM) III beam profiling camera that delivers 1,000:1 linear dynamic range.

A2 Technologies, LLC
Danbury, CT 06810
Apr 29, 2008 Designed for lubrication analysis in various power industry systems, PAL instruments quantify water levels from 50-5,000 ppm in oils with accuracy of better than 5%. Products utilize Fourier Transform Infrared (FTIR) method, which requires no hazardous reagents. In addition to measuring water level, systems immediately yield amount of oxidation and nitration byproducts present as well as amount of anti-oxidation, anti-wear, and extreme pressure additives that remain in lubricant.

Berkeley Varitronics Systems
Metuchen, NJ 08840-1217
Apr 29, 2008 Helping carriers optimize signals, WiMAX Testing Kit is suitable for 700 MHz, 2.5 GHz, and 3.5 GHz networks. Gator(TM) Class A stimulus transmitter provides CW radio beacon for proposed tower site, while YellowFrog(TM) 2 power meter validates RF output levels at transmitter antenna end. With Coyote(TM) dual-band modular receiver, users can perform drive-studies, walk-about, or in-building studies. Geo-coded, drive-study data can then be post-processed using Forecaster(TM) site survey mapping software.

Tektronix, Inc.
Beaverton, OR 97077
Apr 24, 2008 DPO3000 Digital Phosphor Oscilloscopes provide triggering and decode support for most serial buses. At 5.4 in. deep and 9 lb, portable devices utilize Wave Inspector(TM) navigation and search controls as well as USB host on front panel, Ethernet and USB device port on rear, and TekVPI(TM) probe interface. They are available in 6 models, ranging from 100-500 MHz, providing 2.5 GS/sec sampling with greater than 5x oversampling on all channels, each with 5 M record length.

Industrial Tomography Systems Plc
Manchester M3 2BA  United Kingdom
Apr 24, 2008 Suited for engineers operating in petrochemical and mining sectors, Model z8000 high speed electrical tomography instrument can capture online data at 1,000 fps to enable measurement of rapid 2-phase flow in any pipe or vessel. Unit can continuously scan across any volume, and provides picture of what is going on inside process. Instrument is suitable for multi-phase systems, such as measurement of flowing oil water systems and hydraulic conveying of slurries.

MaxCyte, Inc
Gaithersburg, MD 20878
Apr 23, 2008 Used for reagent-free preparative transfection based on flow electroporation technology, ITF Inline Transfection System is sterile, closed system available for drug discovery and screening applications. Validated and scalable platform enables transient transfection of any kind of cell or cell line with any molecule at scales ranging from micro-liters to liter volumes. It can be used to transfect 10⁵-10⁷ cells in seconds and up to 10¹⁰ cells in under 30 min.

GOW-MAC Instrument Co.
Bethlehem, PA 18017 8986
Apr 22, 2008 Featuring built-in signal amplification and filament protection circuit, Series 100TCD offers application-specific system configurations for analysis of industrial and specialty gases used in various applications. Product is offered as 19 in. rack- or benchtop-mountable unit and incorporates flow system comprised of pneumatically controlled, automatic gas sampling valves; independent flow controls for each column; and laminar flow design.

Larson Davis, Inc., A PCB Group Co.
Provo, UT 84601
Apr 21, 2008 Offered as HIPPA-compliant, Internet-based service or on-site application, CORTI® can be used as part of Hearing Conservation Program to lower employee risk of noise-induced hearing loss. With 5 years of known good data, audiometric trend analysis can be executed, which establishes baseline program performance. Software not only manages employee exposure and audiometric records, it applies analysis algorithms that generate key performance metrics for benchmarking and improving effectiveness.

Agilent Technologies, Inc
Santa Clara, CA 95051
Apr 21, 2008 Generating realistic mixes of triple play traffic, Model N5557A uses integrated Agilent J6900A triple play passive analysis tool for independent data collection, performance, and QoE analysis around critical system components, delivering instant and holistic insight of complete network system. With integrated software, it offers real-time MOS and MDI measurements on per stream/call basis and can decode/view/listen to any voice/video stream in test traffic.

Smartronix Inc.
California, MD 20619
Apr 18, 2008 Housed in impact-resistant ABS case, battery-powered LinkUp? utilizes LEDs for instant basic connection status and LCD display to provide more detailed link analysis. Auto-negotiation capabilities can be scrolled through, and Power-Over-Ethernet voltages can be read. LinkBlink test allows link light on hubs and switches to determine wired port numbers, while data packet loopback test can find failures in pre-run cabling by sending actual data through cables.

Saelig Co., Inc.
Pittsford, NY 14534
Apr 17, 2008 With 12 bit resolution, 20 MS/sec sampling rate, 5 MHz bandwidth, and high-speed USB 2.0 interface, Model PS3425 4-channel PC oscilloscope can capture and display extremely detailed waveforms. It features differential inputs for measuring signals that are not referenced to ground, maximum common- and differential-mode ranges of 400 V, and PicoScope6 software. Scope has time-base range of 500 ns to 5 s per division, and 512 kS memory that enables capture of 26 ms of data.

Picarro Inc.
Sunnyvale, CA 94085
Apr 17, 2008 Used for trace HF (hydrogen fluoride) detection, real-time gas analyzer can measure down to 10 ppt concentrations in ambient air and does not require frequent calibration. It is based on Wavelength-Scanned Cavity Ring Down Spectroscopy technology; offers cross-talk immunity from any other ambient gas component, including varying moisture levels; and can be operated remotely with sampling rates as fast 1 Hz, producing drift-free data with up to 4 digits of precision.

Malvern Instruments Ltd
Malvern Worcestershire WR14 1XZ  United Kingdom
Apr 16, 2008 Parsum IPP-70 is offered with Option 1, which allows for provision of Installation/Operational Qualification (IQ/OQ) documentation together with verification kit for checking measurement accuracy, while Option 2 offers unit with polished contact surfaces and includes material traceability documentation. Suited for pharmaceutical applications, probe delivers size and velocity measurement for particles, granules, and pellets from 50-6,000 microns in dia.

JDSU
San Jose, CA 95131
Apr 16, 2008 Performing monitoring and troubleshooting at network edge, Model DTS MVP-200 helps ensure quality digital video service for cable, broadcast, and terrestrial operators. Test processes at edge include those for Digital Program Insertion, ad splicing, rate shaping, grooming, MPEG remuxing, encryption, and modulation.

Thermo Fisher Scientific
Waltham, MA 02454
Apr 15, 2008 Offered as complete benchtop solution, ARL QUANT'X Energy Dispersive X-ray Fluorescence system facilitates accelerated qualitative and quantitative, non-destructive elemental analysis of samples of any size, shape, and state. UniQuant® XRF analysis package, included, uses 8 filters to collect emission lines and excite every sample for unambiguous results for all elements. It can also acquire complete spectral profiles and correct all possible overlaps and background effects.

MOCON
Minneapolis, MN 55428 1010
Apr 11, 2008 Measuring 19 x 14.25 x 5.25 in. and weighing less than 20 lb, Series 9000 Total Hydrocarbon Analyzer has active range from less than 10 ppb on high sensitivity version and up to 100% as methane on percent level version. Standard outputs include alarm and fault relays, 0-20 mA or 4-20 mA analog, or RS-232/Ethernet. FlowGuard electronic control of fuel/air and sample delivery to flame ionization detector, with automatic ignition, ensures safety.

Wayne Kerr Inc.
Woburn, MA 01801
Apr 08, 2008 Suitable for wide variety of applications, Wayne Kerr 6500 Series Precision Impedance Analyzers feature touch-screen user interface with drop down menus and Windows® compatible data format for subsequent analysis. Offered in 7 models for characterizing components/devices from 20 Hz up to 120 MHz, they can perform measurements in 55 msec with 0.05% accuracy and 1 mHz resolution. Fully programmable over GPIB, units incorporate USB/PS2 ports, and can be remotely controlled via LAN.

SPM Instrument Inc.
Marlborough, CT 06447
Apr 08, 2008 Intellinova® online system measures shock pulse using True SPM® Method and uses SPM Spectrum(TM) for in-depth bearing analysis. EVAM® analysis combines vibration time record analysis and vibration spectrum analysis with machine specific statistical evaluations to supply machine condition data, while 2-channel simultaneous vibration measurement allows root cause analysis. System is comprised of industrial enclosure, Commander Unit, and up to 4 shock pulse, vibration, and/or analog measuring units.

videoNEXT
Chantilly, VA 20151
Apr 07, 2008 Applied in real-time or in forensic search, v-IQ(TM) recognizes abandoned objects, velocity and count of objects, access control tailgating, directional violations, zone of protection violation, and camera-to-camera object hand off. Open, standards-based software works with almost any IP, digital, or analog camera; runs on Intel or compatible server; and uses existing security and data infrastructure. It features full policy-level administration and high-availability Storage Volume Manager.

Omega Engineering, Inc.
Stamford, CT 06907
Apr 03, 2008 Utilizing white light polarization interferometry technology, handheld Model FOH201 provides temperature, pressure, and strain measurements. It includes rugged casing and rubber boot, which provide protection against intensive handling and harsh environments. Compatible with all Omega® WLPI optic sensors, portable CE-compliant meter comes with standard ±5 V analog output and RS232 communication port for real-time data acquisition.