Pentek Inc.
Upper Saddle River, NJ 07458
Jun 13, 2008 Built on XP Pro workstation with 17 in. LCD, RTS 2721 features 2.4 TB disk storage via 13, 2.5 in. HDDs: one handles OS, others act as dual RAID arrays dedicated for real-time recording/playback. Solution digitizes 2 analog input signals at sample rates to 125 MHz, handling IF input signals with center frequencies to 300 MHz or baseband signals to 60 MHz. With programmable decimation factors from 2 to 32,768, digital downconverter output signal bandwidths can range from 8 kHz to 60 MHz.

Agilent Technologies, Inc
Santa Clara, CA 95051
Jun 13, 2008 With nonlinear vector network analyzer capability, PNA-X Microwave Network Analyzer can measure calibrated amplitude and cross-frequency relative phase of measured spectra from 10 MHz to 26.5 GHz. Requiring minimal external hardware, NVNA software converts 4-port PNA-X into high-performance nonlinear analyzer, providing nonlinear component characterization, nonlinear scattering parameters called X-parameters, and nonlinear pulse envelope domain capabilities.

Teltronics, Inc.
Sarasota, FL 34243
Jun 11, 2008 Detecting impairments before they impact customers and end users, Intelligent Service Level Management (iSLM) Solution includes Nortel CS1000 Monitor and one IP telephony switch-agnostic Voice Quality probe (VQProbe(TM)). Nortel CS1000 Monitor Probe receives, captures, processes, tracks, displays, and reports performance metrics in Nortel IP Telephony environment. VQProbe enables proactive monitoring of real-time and completed voice calls to ensure optimal performance.

Antx, Inc.
Austin, TX 78720
Jun 10, 2008 Combining GPS, GSM, CDMA cellular or Satellite modem, CAN bus communication, and alarm notification, Messenger includes firmware that supports satellite communication to back-end Internet-based applications. OEM unit monitors Parameter Group Numbers using J1939 protocol at rates up to 1.25 Mbit/sec. Housed in water-tight enclosure, Messenger connects to diagnostic port on diesel engine-based equipment to monitor rpm, engine hours, oil and coolant temperatures and pressures, and fuel level.

SICK, Inc.
Minneapolis, MN 55438
Jun 05, 2008 Providing pass/fail output, Inspector Vision Sensor verifies completeness and quality of product regardless of angle/orientation as it comes down line. Unit features 384 x 384 resolution, IP 67 metal housing, and integrated dome light that delivers high quality images even on glossy and reflective surfaces. Applications include verifying label position, date code presence and cap inspection in packaging, as well as bowl feeder inspection and verification of part assembly.

ThinkCP(TM) Technologies
Irvine, CA 92606
May 29, 2008 Using ThinkTankQ(TM) ORTEN-MP, administrators can identify, document, and mitigate security breaches or denial-of-service attacks as they first occur. System consists of 2U enclosure with 1-4 Multi-Core AMD® Opteron processors, 128 GB memory, 6 TB SATA2 storage via 6 hot-swappable drive bays, redundant power supplies, and 2 GigE ports. Integrated InterMapper 5.0 software lets users monitor networks in real-time, 30-second or faster user-defined intervals from geographical mapping perspective.

3M Company / Electronic Products Division
Austin, TX 78769
May 29, 2008 Incorporating voiceband spectrum analyzer, Dynatel 965AMS provides graphical representation of voiceband frequency spectrum, enabling technicians to identify noise sources that contribute to metallic noise or power influence readings. Live differential TDR option allows outside plant technician to capture baseline trace on troubled pair then view live trace as stress voltage is applied. Optional all-in-one modem module provides VDSL2, ADSL2+, ADSL2, ADSL, and Ethernet connectivity.

Audio Precision, Inc.
Beaverton, OR 97075
May 28, 2008 Suited for R/D engineers and production technicians, APx525 and APx520 offer one-click measurements, automated measurement sequencer, and continuous sweep technology that can derive 14 measurements in 7 sec. Model APx525 has 2 balanced and 2 unbalanced analog I/O in addition to 192K DIO, while APx520 has equal performance and as many analog connectors but no DIO. Both can generate signals down to 0.1 Hz and enable CMRR measurements in accordance with IEC60268 section 14.15.1.

Saelig Co., Inc.
Fairport, NY 14450
May 20, 2008 Able to measure dc currents from mA to several kA, KLARI-CORD2 16-bit module can simultaneously measure voltages and temperatures using external sensors. Offered in 85 x 110 x 35 mm IP65 metal housing, it tests and records vehicle power consumption and battery charge data at ambient temperatures ranging from -40 to +85°C. Power consumption is under 3 mA (12 V supply voltage, 1 measuring cycle/sec.) Unit has USB mini plug, with CAN, RS232, and power supply being fed via 15-pin Sub-D plug.

Ztec Instruments Inc.
Albuquerque, NM 87109
May 19, 2008 Available in 2-channel models as well as 4-channel model, ZT4210 series, 300 MHz oscilloscopes offer up to 1 GS/sec real-time sampling and up to 256 Msample record length. Devices calculate over 40 waveform parameters related to voltage, time, and frequency characteristics. They also accept wide range of voltage levels, handling up to ±300 V CAT II direct inputs. Drivers and programming support are available for various programming environments.

Aspex Corp.
Delmont, PA 15626
May 16, 2008 Combining optics of scanning electron microscope with elemental analysis capabilities of energy dispersive spectrometer, Metal Quality Analyzer(TM) dynamically scans steel specimens collected from ladle or final product, then counts, sizes, and identifies impurities that can lead to caster clogging, wasted material, and furnace downtime. Results are delivered in minutes, and data from reports can be used to continuously monitor and improve steel making practices.

Emerson Process Management / Process Liquid Division / Uniloc Division
Irvine, CA 92606
May 16, 2008 Rosemount Analytical® Model 1056-HT and 1056-DP are 4-wire, dual-input analyzers that feature, respectively, complete HART® and Profibus® DP digital communications. HART-enabled analyzer allows remote calibration, continuous monitoring of 4 live process variables, and configuration from AMS® Suite or DeltaV(TM) host applications, legacy DCS, or SCADA systems. Diagnostics allows plants to estimate life of in-process sensors and perform required maintenance on timely basis.

Animazoo UK Ltd.
Brighton BN41 1WF  United Kingdom
May 15, 2008 IGS-190H (Hybrid) inertial gyroscopic-ultrasonic tracking motion capture system features ExacTrax, which includes scalable configuration of 1 Sonar Processing Unit (SPU) per 4 sonar sensors. It is offered in 20-sensor/5 SPU configuration. Animazoo Jump Injector editing and auto-cleaning tools are also included and system has temperature factoring feature. Sonar emitter fits onto back of suit and basic 20 sensor system can cover 6 x 6 m space.

Ophir-Spiricon Inc.
Logan, UT 84321
May 15, 2008 Model BA150 Industrial Laser BeamAnalyzer system incorporates USB 2.0 silicon CCD camera with beam analysis software to monitor all key laser beam parameters for 1,064 nm pulsed and CW industrial Nd:YAG, diode, and fiber lasers up to 150 W. Parameters including beam profile, average laser power, energy per pulse, pulse rate, and temporal pulse width. All measurements are made independently of laser power supply and can be output to PC.

Agilent Technologies, Inc.
Palo Alto, CA 94303
May 12, 2008 Designed for PCIe 2.0 E2960B Series analyzers, N4241F Flying Leads Probe 2.0 allows access to PCIe 2.0 links with no designed-in connectors at both 2.5 and 5.0 Giga Transfer/sec rates, which is essential for debugging embedded designs. Probe amplifier is outside probe tip, ensuring probe tip size is kept to minimum to address space constraints and thermal concerns. Unit can be used to probe link widths from x1 to x8 PCI Express, and 2 probes can be combined for x16 analysis.

Mountz, Inc.
San Jose, CA 95112
May 09, 2008 Operating with HSD sensor controlled hand torque multipliers, Portable Torque Meter (PTT 2000) facilitates and expedites process of setting up and running auditing tool tests as well as transfer, analysis, and storage of test data for QC documentation. Hand-held unit, designed for torque/angle analysis and data collection, is suited for checking/auditing pipe flanges, pressurized connections, and other critical fastened joints. Up to 5,000 readings can be stored.

JDSU
San Jose, CA 95131
May 09, 2008 Model OCC-55 Smart Optical Channel Checker is designed for CWDM system installation, upgrades, and troubleshooting. It operates in 1,260-1,620 nm range, and can analyze all 18 CWDM wavelengths in terms of individual power level and display measurement results in bar-graph or tabular mode. CWDM analyzer deploys USB interface that, when used in combination with OFS-355 software, provides customized reports which can be downloaded from OCC-55 to any PC.

Kason Corporation
Millburn, NJ 07041
May 07, 2008 Vibroscreen Gap-Free Classifier offers non-metallic material contact surfaces and quick-cleaning features designed to eliminate contamination of ultra-pure products. This 60 in. dia unit is configured with 3 screening decks for removing oversize particles and de-dusting material, while separating on-size material into 2 size fractions. Other features include gap-free screen frames, quick-release U clamps, radius corners, domed lid, and continuous ground and polished welds.

GOW-MAC Instrument Co.
Bethlehem, PA 18017 8986
May 07, 2008 Optimized for ppb analysis of non-corrosive and corrosive gases such as air, Ar, and He, 19 in. rack mount compatible Series 200DID is computer controlled using keypad with vacuum fluorescence graphical display. It features 24/7 continuous, unattended operation, packed/micro-packed columns, automated valve control, isolated, discrete 4-20 mA outputs, and manual/automatic operation modes. Self-contained instrument eliminates need for any chromatography software.

Perytons
Nes Ziona 74100  Israel
May 01, 2008 Multi-antenna multi-channel 802.15.4/ZigBee analyzer, based on Integration Associates EZLink 802.15.4 USB dongles, can analyze and track multiple network sessions that coincide in time. Using multiple Integration USB dongles as RF/PHY front-end, analyzer utilizes antenna diversity for optimal sensitivity and fidelity. Tool for on-site debugging, where various devices are operating in same unlicensed band, helps developers shorten development and integration time.