Futek    Irvine, CA 92618
Mar 06, 2007 Scaleable to 5 digits, IPM500 Panel Mount Signal Conditioner with Digital Display supports sensors with TEDS ID recognition option per IEEE1451.4. TEDS option features auto-configuration, which minimizes error due to setup and re-installation. In addition to providing stable and regulated excitation voltage to sensor, unit also provides 0-10 Vdc and 4-20 mA analog output as well as RS232/RS485 and USB interface to be used with PLC, DAQ card, or computer.

Moore Industries International, Inc.    North Hills, CA 91343
Mar 06, 2007 BIMETAL Dual-Mode Remote Thermometer offers on-site indication of process temperature conditions while simultaneously providing mV or ohm signal proportional to temperature for input to another device. Solution requires no power supply at point of measurement and includes thermowell probe assembly, which contains RTD or thermocouple sensor and analog display that are NIST-traceable and can be calibrated in-field. Dials are available to indicate 0 to +250°F and 0 to +500°F ranges.

Accedian Networks Inc.    Dorval H9P-2V4  Canada
Mar 06, 2007 EtherNID(TM) Ethernet Demarcation Devices are available with Performance Assurance Agent(TM), which allows constant, in-service monitoring of Service Level Agreement (SLA) parameters. Silicon-based architecture lends to minimal latency and jitter, allowing it to yield precision measurements with 1 µsec resolution. With this solution, carriers and operators ensure SLAs throughout end-to-end path, 24/7, and have means with which to map-out network health.

New Wave Research    Fremont, CA 94539
Mar 06, 2007 As flexible analytical tool for range of materials, UP193-FX 193 nm short-pulse excimer laser ablation system is suited for bulk or micro-feature analysis and includes 13 pre-calibrated spot sizes with constant fluence. Use results in consistently smaller aerosol particles from all materials for optimal ionization and crater quality as well as minimal fractionation. System offers fully homogenized beam, wavelength coupling to ICP-MS, and up to 4 GW/cm² irradiance at sample.

Laurel Electronics, Inc.    Costa Mesa, CA 92626
Mar 06, 2007 Available with 3-terminal screw clamp connector for serial data I/O, Laureate(TM) TM2000 Series transmitters convert temperature sensor signal to linearized, accurate serial transmitter output. They accept outputs of types J, K, T, E, N, R and S thermocouples, as well as 100 W platinum RTD's with DIN alpha of 0.00385 or ANSI alpha of 0.003925. RS485 or RS232 signal levels are jumper selectable and can each be associated with Modbus protocol/Laurel ASCII protocol.

C & D Technologies    Mansfield, MA 02048-1151
Mar 05, 2007 Optimized for low-noise applications, ADSD-1420S and ADSD-1420EX are functionally complete, 14-bit resolution modules that provide 20 MSPS sampling rate and have no missing codes over full temperature range. Both dual-channel, 20 MHz models offer multiple functions in single package and are suited for time and frequency-domain applications.

ZK Celltest    Sunnyvale,, CA 94089
Mar 05, 2007 Cellular network optimization and drive test tool, ZK-SAMp, includes in-building feature that lets engineers perform walk-tests inside buildings and malls using portable unit. Product does not require laptop and powers up in 3 sec for instant data collection. Integrated Floor Plan feature allows building layouts, in JPEG format, to be imported onto display and used to identify specific points of walk. Collected data is stored on industrial-grade Compact Flash card.

AXSUN Technologies Inc.    Billerica, MA 01821
Mar 05, 2007 Handheld, battery-operated Anavo(TM) Analyzer features micro-optical platform that combines tunable laser technology, MEMS tunable filter, and wavelength and power calibration in single optical chip. On-board material libraries and analysis software enable instantaneous material identification. Analyzer is suitable for applications ranging from plastics and polymer recycling, to incoming raw materials inspection and field measurements in food and agriculture industry.

AW Company    Franksville, WI 53126
Mar 02, 2007 ClearView(TM) flow meter is designed with clear body for applications where it is important to observe fluid condition. Available in variety of sizes and porting options, including NPT and BSPP in brass or polysulphone, product offers measuring accuracy of ±5% FS and repeatability of ±1% FS. Two models are available: ClearView H2O for water applications, and ClearView + for oils and chemicals such as solvents and coolants.

Kittiwake Developments Ltd    West Sussex BN17 7LU  United Kingdom
Mar 02, 2007 Designed to analyze multiple oil breakdown characteristics, dual-purpose DIGI Test Cell can measure both Water in Oil and Total Base Number in one unit. Made with GRP casing, cell includes step-by-step instructions; built-in memory, which automatically records previous test results; and LCD display showing ppm, % water, or TBN. Non-slip twist grips ensure unit can be fully sealed when in use. With pre-programmed software, unit delivers results in 2 minutes.

ExonHit Therapeutics Inc    Gaithersburg, MD 20877
Mar 02, 2007 Human GW (genome wide) SpliceArray(TM) enables research and clinical communities to proceed with comprehensive analysis of human genome. It monitors 23,000+ human genes, covering 130,000+ expressed transcripts, and requires over 6 million probes to help elucidate diversity of human proteome. Able to detect all known and novel expressed transcripts, solution interrogates both exons and splice junctions to accelerate diagnosis of chronic diseases.

Sigma Aldrich Corp.    St. Louis, MO 63103
Mar 02, 2007 Offered in C18 and C8 stationary phases, Ascentis® Express HPLC Columns are designed to provide analysis speed and resolving power of sub 2 micron columns with 50% reduction in backpressures. Enabling technology is Fused-Core(TM) high-purity silica particles that measure 2.7 microns overall with 0.5 micron thick porous shell.

Mahr Federal Inc.    Providence, RI 02905
Mar 02, 2007 Offered in versions with 350 mm Z-axis and 180 mm X-axis or 500 mm Z-axis and 280 mm X-axis, MarForm MMQ 400 Formtester features fully motorized axes and selection of probes that promotes measuring flexibility. All motors and electronic components are thermally isolated, and solid construction with reinforced steel base minimizes susceptibility to external forces such as vibration. Part up to 132 lb can be measured, and no air supply is required.

Kistler Instrument Corp.    Amherst, NY 14228 2119
Mar 02, 2007 Designed for simultaneous calibration of up to 6 piezoelectric sensors for engine indication, system consists of solid metal block with sensor installation ports, pressure generator, reference sensor, and signal evaluation unit. Sensor manifold is equipped with thermostatically controlled heating and cooling system for calibration at temperatures from room temperature up to 250°C. When PiezoSmart® pressure sensors are used, calibration values are automatically stored on TEDS.

ENM Company    Chicago, IL 60646 6135
Mar 01, 2007 Triggered by external wire lead wrapped around spark plug wire, Series PT15E tracks true rpm and running time on all types of gasoline engines. RPM is displayed when engine is running, while hour usage, up to 9999.9 hr, is shown with 5 mm digits when engine is off. Completely epoxy-sealed unit uses solid-state technology and is powered by internal lithium battery. Offered in 3 styles, max monitor ranges are 13,000, 24,000, or 48,000 rpm.

Dwyer Instruments, Inc.    Michigan City, IN 46361
Mar 01, 2007 Featuring 3½-digit LCD display with choice of red, amber, or green segments, Series DPMA-5 accepts input signal from temperature, flow, level, or pressure transmitter. User-selectable engineering units are indicated on display. Decimal point position is field-selectable, and span and zero can be adjusted via trim pots located on rear of unit. Snap-in panel mount facilitates installation.

Agilent Technologies, Inc.    Santa Clara, CA 95051
Mar 01, 2007 Combining Agilent 6000 Series mixed-signal oscilloscope with DECOMPSYS BUSDOCTOR 2 protocol analyzer, Model N5432A provides time-correlated slot/segment boundary display of global FlexRay timing schedule. It allows automotive designers who use embedded microprocessors to verify proper signal integrity of their FlexRay signals and proper timing of time-triggered communication bus.

Agilent Technologies, Inc.    Santa Clara, CA 95051
Mar 01, 2007 Designed for electronics manufacturers, Agilent Medalist i3070 provides means to bring in-circuit testing to production line. Included VTEP v2.0 vectorless test technology incorporates Network Parameter Measurement technology targeted at defect detection on power and ground pins for connectors. In-circuit test system for PCB assembly facilitates development and debugging via GUIs suited for operators in fast-paced high-volume manufacturing environments.

Agilent Technologies, Inc.    Santa Clara, CA 95051
Mar 01, 2007 Agilent J7830A integrated test solution enables complete analysis of IP Multimedia Subsystem (IMS) and Unlicensed Mobile Access (UMA) networks in single protocol-analysis tool. Featuring scalable, distributable, and multi-user architecture, signaling analyzer provides complete decoding and filtering as well as an automatic call-trace engine with multiple protocol and interface correlation, graphical call sequence diagrams, and statistics in real-time.

Agilent Technologies, Inc.    Santa Clara, CA 95051
Mar 01, 2007 Single-box 8960 Wireless Communications Test Set provides benchtop solution for meeting user equipment (UE) design needs, including functional test and RF measurements for device validation, integration, and regression testing. Solution couples 7.2 Mbps HSDPA IP data connection with real-time 3GPP network emulation, including Inter-RAT voice and data handovers. Used early on in design cycle, it helps ensure UE design integrity throughout test and deployment cycles.