Test & Measuring Instruments

Sensors Monitors & Transducers, Test & Measuring Instruments

Leak Noise Logger integrates correlation capabilities.

September 30, 2016

Installed magnetically on pipe fittings throughout distribution system, Permalog PCorr+ enables water suppliers to locate leaks in water network via remote noise sampling and listening. Alarm state activates if leak noise is identified, radio signal is transmitted to indicate leak condition, and correlation mode lets users calculate precise location of leak. Otherwise, data is gathered... Read More

Test & Measuring Instruments

High-Voltage Oscilloscope Probe is fiber-optically isolated.

September 29, 2016

Optimized for measurement of small signals floating on HV bus in power electronics designs, HVFO probe features optical isolation between probe tip and oscilloscope input. This reduces adverse loading of DUT while also reducing noise, distortion, ringing, overshoots, and transients on measured signal. Architecture consists of single laser and fiber optic cable providing optical isolation... Read More

Optics & Photonics, Test & Measuring Instruments

Measurement System determines grade of coal and coke.

September 28, 2016

By measuring intensity of light reflected from microscopic sampling area, 508 Coal™ Vitrinite Reflectance Measurement System determines amount of vitrinite in coal blend, thermal maturity, and value for coking. This ensures that coal blends used in energy generation are optimum and consistent. In addition, system can be used to acquire fluorescence and reflectance spectra of geological samples... Read More

Electronic Components & Devices, Test & Measuring Instruments

Precision MEMS Oscillators aid telecom, networking timing market.

September 28, 2016

Designed to solve problems in telecom and networking equipment, Elite Platform™ Super-TCXOs™ and oscillators bolster communications equipment performance, reliability, and QoS even when environmental stressors are present. These precision devices are based on DualMEMS™ architecture with TurboCompensation™, which further includes TempFlat MEMS™, 100% accurate thermal coupling, and... Read More

Laboratory and Research Supplies and Equipment, Sensors Monitors & Transducers, Test & Measuring Instruments

Wireless IoT Sensors enhance water monitoring capabilities.

September 28, 2016

Powered by user-replaceable C lithium battery, Telog® 41 Series uses low-power, Long-Range (LoRa®) wireless communications to remotely measure and monitor water, wastewater, and groundwater systems, including water pressures, flows, levels and rainfall volumes. These IoT sensors, as part of smart water infrastructure, communicate data using LoRaWAN technology to Telog software at... Read More

Laboratory and Research Supplies and Equipment, Test & Measuring Instruments

Smart Analyzer supports point-of-care applications.

September 28, 2016

FDA-cleared and CE-compliant, Diazyme Smart 700/340 Analyzer measures multiple parameters, including diabetes, renal function, inflammatory markers, and cardiac markers. Instrument incorporates barcode reader, touchscreen, and RFID card. In addition to providing automated integrity check with each test, analyzer identifies lot expiration date, indicates number of tests remaining, and permits... Read More

Test & Measuring Instruments

Detecting DC Motor Failure Using a Data Logger

September 27, 2016

DC motor failure is disastrous for factories and plant processes in every industry. To help prevent costly process delays, you can use a data logger to measure Temperature, Voltage/Current and other parameters. At CAS DataLoggers we provide the versatile and rugged dataTaker data loggers for these applications. Call our Application Specialists at 800-956-4437 for more info. DataTaker Features:... Read More

Sensors Monitors & Transducers, Test & Measuring Instruments

Digital Force Gauges help manufacturers optimize packaging.

September 27, 2016

With ±0.1% accuracy, PCE-DFG Series can measure both tensile and compressive forces. Models offer ranges/resolutions of 0–5 N/0.0005 N, 0–10 N/0.001 N, 0–20 N /0.005 N, and 0–500 N/0.05 N. Each gauge has sampling rate of 2,000 Hz, storage rate of 1 Hz, and 3 modes of measurement: peak, auto peak, and track. Equipped with 160 x 128 dot matrix LCD, gauges offer 6 units of... Read More

Controls & Controllers, Test & Measuring Instruments

Mass Flow Meters and Controllers suit high pressure systems.

September 26, 2016

Operating on systems up to 320 psia, MQ Series Flow Meters and MCQ Series Mass Flow Controllers measure mass flow rate, volumetric flow rates, and pressures. Units provide 10 ms sensor response speeds and sub-100 ms control response times. Preloaded with up to 98 on-board gas calibrations, instruments feature multivariate interface displays, as well as serial and analog connections. Each comes... Read More

Computer Hardware & Peripherals, Electronic Components & Devices, Test & Measuring Instruments

PC-Based Test Scope supports signature analysis.

September 26, 2016

Based on 2-channel 200 kHz oscilloscope sampling at 2 MSa/s, Syscomp SIG-101 Signature Analyzer includes 12-bit arbitrary waveform generator and 8-bit digital I/O port. Waveform generator can be used to create swept, stationary, or noise test signals, or provide PWM outputs. Combined, oscilloscope and waveform generator provide Vector Network Analysis, yielding Bode plots that graph frequency... Read More

Sensors Monitors & Transducers, Test & Measuring Instruments

Precision Pressure Transmitter provides CANbus outputs.

September 26, 2016

Supplied in welded, hermetically sealed, stainless steel housing measuring less than 1 in. diameter, Model EPT1005 is available with pressure ranges from 1–20,000 psi. Electronically compensated unit is designed for use in rugged environments with temperatures from -40 to +250°F. Utilizing piezoresistive silicon sensor technology, transmitter provides hysteresis and repeatability of... Read More

Computer Hardware & Peripherals, Sensors Monitors & Transducers, Test & Measuring Instruments

Label Inspection System integrates with thermal printers.

September 23, 2016

Available as integrated solution within Printronix® T8304 and T8308 thermal label printers, LVS-7510 Print Quality Inspection System provides 5.4 in. or 8.5 in. read head for scanning label widths from 4.1–8.5 in., as well as stop motion unit, print control unit, and light tower for triggering alerts or printer actions when errors are detected. Machine vision tools—including barcode... Read More

Electrical Equipment & Systems, Electronic Components & Devices, Test & Measuring Instruments

U.S. Army Awards Nuwaves Engineering 2016 SBIR Phase I Contract for Development of Tactical Aircraft Transponder Simulation System

September 23, 2016

NuWaves Partners with ViaSat to Accurately Simulate the RF Signal Environment MIDDLETOWN, Ohio – NuWaves Engineering, a veteran-owned small business providing advanced radio frequency (RF) and microwave solutions, today announced a Small Business Innovation Research (SBIR) Phase I contract with the U.S. Army’s Redstone Test Center (RTC) to research and develop a Mode 5 Identification Friend... Read More

Test & Measuring Instruments

RF Upconverter supports 2 MHz to 3 GHz systems.

September 22, 2016

Accepting user-programmable IF input signal from 2–70 MHz, Model RF2-3000UCV1 delivers RF output at any user-programmable frequency between 2 MHz and 3 GHz, with tuning resolution of 5 kHz. Multi-octave device has 50 dB of attenuation control with incremental steps of 0.5 dB. Housed in 1.0 x 2.5 x 3.5 in. ruggedized aluminum enclosure, upconverter operates at 6 Vdc and features SMA RF... Read More

Test & Measuring Instruments

U.S. Navy has selected the TEGAM Model R1L-D1 for a Special Test Requirement of the Nuclear Navy

September 22, 2016

High Accuracy Micro Ohmmeter and RTD Meter has the Longest Rechargeable Battery Life with a rugged MIL-PRF-28800F Class 3 rating Geneva, OH – TEGAM, Inc., a leading supplier of test and measurement equipment, is proud to announce that the U.S. Navy has selected the TEGAM Model R1L-D1 Portable Micro-Ohm and RTD Measurement Bridge to fulfill a special test requirement of the nuclear Navy. ... Read More

Cleaning Products & Equipment, Material Handling & Storage, Test & Measuring Instruments

VAC-U-MAX Exhibits Pneumatic Conveying Systems for Batch & Continuous Processing, and Dust Collection & Cleaning Solutions for Powders and Combustible Dusts at IBIE 2016, October 8-11, Las Vegas Convention Center, Las Vegas, NV, Booth 3314

September 22, 2016

BELLEVILLE, NJ USA – VAC-U-MAX announces exhibition at IBIE 2016, October 8-11, Las Vegas, Nevada, Booth 3314, exhibiting the latest advances in food processing automation solutions for bulk-ingredient transfer. VAC-U-MAX food-ingredient handling systems convey over 10,000 various powders, flakes, flavorings, extracts, additives, granular materials, nuts, extruded foods, and other dry food... Read More

Sensors Monitors & Transducers, Test & Measuring Instruments

Corrosion Meter provides rebar assessment.

September 22, 2016

Based on half-cell method, Profometer Corrosion provides optimized workflow for rod and wheel measurements. Wheel electrodes allow fast on-site testing, while dual-core processor enables data acquisition and real-time control over measurement procedure. Packaged in rugged housing for harsh environments, product has illustrative touchscreen that supports 2D grid views, assisted workflow, and... Read More

Automatic ID, Test & Measuring Instruments

Power Analyzer measures RF power from 9 kHz to 70 GHz.

September 22, 2016

Leveraging Shockline technology, frequency-selectable Power Master MA24507A addresses test requirements for millimeter wave applications, including test of 802.11ad, Wireless HD, and E-band products, at every stage of product lifecycle. Ultraportable size enables placement directly at signal source, including on-wafer measurements. With spans from 1 kHz to full span over entire frequency range,... Read More