Picarro Inc.    Sunnyvale, CA 94085
Sep 07, 2007 Field-deployable EnviroSense 3000i helps scientists observe and understand earth's carbon cycle in order to investigate global climate change. Employing Cavity Ring-Down Spectroscopy (CRDS) technology, real-time ambient gas monitor measures atmospheric levels of methane and carbon dioxide with ppb sensitivity and water vapor with ppm sensitivity. Features enable unit to maintain linearity, precision, and accuracy over changing environmental conditions, with minimal calibration.

Agilent Technologies, Inc.    Santa Clara, CA 95051
Sep 07, 2007 Offering BNC connectivity to 2 instruments, Model E5818A LXI enables precise synchronization over LAN for LXI Class C and GPIB instruments. Using IEEE 1588 precision time protocol synchronization, it provides synchronization accuracy of up to 13 nsec, and time stamping of up to 5,000 events. Unit features LXI peer-to-peer and multicast communication abilities that improve test time when heavy data exchanges occur between devices. Device can be configured using standard Web browser.

Dytran Instruments, Inc.    Chatsworth, CA 91311
Sep 07, 2007 Model 3088C high temperature, charge mode accelerometer has nominal sensitivity of 10 pC/g and upper frequency range of 5,000 Hz. Hermetically sealed unit features 10-32 side connector, 10-32 tapped hole, and all stainless steel construction. Device has hex x height of .625 x 1.07 in. and weighs 42 g.

Sensor Electronics Corp.    Minneapolis, MN 55436
Sep 06, 2007 Coupling SEC 3000 Sensor with SEC 3100 Transmitter, Gas Detection System reacts instantly to dangerous gas levels, protecting areas where flammable or poisonous gases are potential danger. Transmitter shows actual gas levels in ppm or % LEL on digital screen, while memory stick logs permanent record of gas levels, remembering times, concentrations, trouble signals, and service interruptions. At setpoint, integral relays can trigger alarms, turn on supply/exhaust fans, or shut down lines.

Mainstream Engineering Corp.    Rockledge, FL 32955
Sep 06, 2007 Developed for HVAC trade as 3 oz aerosolized can with 4 in. long nozzle extension, QwikDectector-HE(TM) can save lives by early detection of leaks due to defects caused by corrosion, expansion/contraction cracks, or manufacturer error that exposes occupants to CO. It penetrates heat exchanger fissure as small as 24/1,000 in. after one 5 sec spray into drilled 1/8 in. furnace plenum hole. Unit pinpoints openings within heat exchanger whether or not they are leaking at time of test.

Orange Research, Inc.    Milford, CT 06460
Sep 06, 2007 With 10,000 psi line pressure ratings, differential pressure gauges measure differential pressures on liquids in ranges from 0-5 in. H₂O to 0-1,000 psid. They have pressure bodies machined from solid blocks of metal and piston sensor assembly that withstand severe environments and high pressures. NEMA 4x rated units are available with dials up to 6 in. dia in black or white, and porting connections including medium pressure, high pressure, NPT, BSP, MS, and SAE.

IDO SECURITY INC    New York, NY 10004
Sep 05, 2007 Complementary to walk-through, whole body metal detectors at airports, MagShoe(TM) adds clear response to shoe screening at ground level. Portable, shoes-on detector not only scans footwear for weapons, but also scans portion of lower extremities, optimizing screening effectiveness while speeding process and minimizing passenger inconvenience.

Cholestech Corp.    Hayward, CA 94545
Sep 05, 2007 LDX System gives physicians one test to obtain laboratory-accurate results for lipids and alanine aminotransferase (ALT). Tests are performed prior to treatment to establish baseline level and periodically thereafter to monitor drug effectiveness and determine appropriate therapeutic course of action for patients. Instead of sending samples to off-site labs, results can be obtained in 5 minutes with 1 fingerstick.

Phoenix America, Inc.    Fort Wayne, IN 46804
Sep 05, 2007 Intended for lower-resolution industrial applications, Model P9112 functions as incremental angular position encoder when used with 5/8 in. multi-pole magnet target wheel which can be custom configured for wide variety of shaft sizes and styles. Industrial grade tachometer/encoder comes with 1 in. dia bolt hole pattern, 2-channel quadrature output, and no moving parts. Rugged unit operates in dirty environments.

Cemtrex Inc.    Farmingdale, NY 11735
Sep 05, 2007 Eliminating need for transferring measuring gas to analyzer through chiller sampling system, Model ZSS Tunable Diode Laser (TDL) based laser gas analyzer facilitates continuous measurements of ammonia, hydrogen chloride, and nitrogen oxides in flue gases emitted from power plants and incinerators. It comes in dust-resistant construction and can be installed before bag filter where gas sampling could not be conducted previously.

FasTest, Inc.    Roseville, MN 55113-1317
Sep 04, 2007 Featuring chamfered seal design, MITC Series Twistmate is designed to seal and test threaded ports on round parts such as regulators, bowl filters, and tanks. With full flow design that minimizes production losses from scrap, retesting, and rework, connector seals threaded ports without wrenches or thread sealant with twist-in motion. Device is available for 1/8 and 1/4 in. NPT threads and as plug, non-swivel, or swivel connector.

Dytran Instruments, Inc.    Chatsworth, CA 91311
Sep 04, 2007 Suited for modal analysis, NVH, Squeak & Rattle, and general purpose vibration applications, 3214A Series Single Axis Cubic Accelerometer features ultra low noise electronics and all titanium construction. Cubic design allows for adhesive mounting on multiple mounting faces and unit includes 10-32 mounting hole. It is available in sensitivities of 10, 100, and 500 mV/g.

Photonic Products, Ltd.    Huntington Beach, CA 92647
Sep 04, 2007 Pocket sized FFD100 Fibre Fault Detector visually finds discontinuities that result in signal loss, and aids end-to-end fiber identification within bundle. It uses high visibility 635 nm red laser diode with CW operation to locate faults up to 5 km. Measuring 162 mm and weighing 70 g, unit features Universal Adaptor and accepts all standard 2.5 mm optical connector types for single and multimode operation.

Balluff, Inc.    Florence, KY 41042-0937
Sep 04, 2007 Available in compact 34.5 x 29.3 x 15 mm T-style housing, Series BOS 11K includes diffuse, retro-reflective, polarized retro-reflective, and thru-beam styles. Ultrasonically welded IP67 housing features diagnostic LEDs as well as highly visible 360° LED window for troubleshooting. Designed to be used with BMS mounting system, unit can be positioned almost anywhere at any angle in tight locations, common in flexible packaging, tabletop, and general conveyor applications.

Dwyer Instruments, Inc.    Michigan City, IN 46361
Aug 31, 2007 Featuring 316 SS diaphragm that is non-clogging and damage resistant to floating solids, Model PBLTX is designed to measure height of liquid above its position in tank, sump, or pit. It is UL approved intrinsically safe for wastewater applications that demand this rating per local codes and regulations. Standoff plate enables unit to be dropped to bottom of tank at 0.25% accuracy. Transmitter is suited for level monitoring in lift stations and industrial sumps.

Banner Engineering Corp.    Minneapolis, MN 55441
Aug 31, 2007 Offering cutoff range of 50-250 mm, WORLD-BEAM® QS18LAF250 delivers background suppression sensing, and has narrow effective beam with 1 mm spot size, making it suited for small-object detection and precise position control. Cutoff point is adjusted using 5-turn adjustment screw on sensor top. In addition to sealed housing and LED status indicators, sensor features reduced excess gain from 0-20 mm, making it less sensitive to lens contamination in industrial environments.

NetQoS EMEA    Theale Reading RG7 4SA  United Kingdom
Aug 31, 2007 NetQoS® VoIP Monitor helps gauge how well VoIP systems are delivering end-user services and pinpoints causes of quality issues. With call setup and call quality metrics, network-based VoIP solution links quality of experience to network performance to facilitate troubleshooting without server agents or probes. System tracks actual end user call quality, provides alerts on call performance issues, and isolates cause of VoIP problems to network source.

Challenge Electronics    Deer Park, NY 11729
Aug 31, 2007 Housed in miniature, lead-free and RoHS compliant package, Model CSET05A provides 83 dB of sound at 4,000 Hz, while Model CSET05B outputs 82 dB signal at 10 cm and 4,000 Hz. Both surface mount units function across operating temperature range of -30 to +85°C. Operating voltage is 2-4 Vo-p with nickel alloy N50 vibrating diaphragm. Featuring 5.0 x 5.5 mm footprint, Model CSET05A is 3.0 mm high ±0.2 mm and Model CSET05B is 2.5 mm high ±0.2 mm.

SICK STEGMANN, INC.    Dayton, OH 45413
Aug 30, 2007 Designed to mount directly to conveyor belt without mechanical accessories, DKV 60 Incremental Measuring Wheel Encoder is based on Mini-Disc technology, which includes track radius of 2 mm, permitting integral scanning of entire code disc and eliminating eccentricity errors of code disk, ball bearings, and shaft. Encoder features IP65 protection with compact design that is resistant to high levels of shock and vibration.

Renishaw, Inc.    Hoffman Estates, IL 60192
Aug 30, 2007 Mounted to any rigid machine surface, single-head TRS2 detects range of solid center tools within 1 sec (typ). In-cycle, 3.27 x 1.50 x 2.87 in. unit combines laser source and Toolwise(TM) electronics technology, which recognizes reflected light patterns to distinguish good tools from broken ones. Detection range is 13-80 in., and system can process tools as small as 0.2 mm while screening out chip and coolant misreadings. Monitoring is available at 3 tool rotation speeds.