Meggitt Sensing Systems (Endevco Corp.)    San Juan Capistrano, CA 92675
May 12, 2010 Available in 1/8, ¼, and ½ in. dia, Endevco® prepolarized condenser measurement microphones are offered in free-field, pressure, low-cost array, and random incidence types. All microphones are constructed with stainless steel protective grid case and housing, as well as special stainless steel alloy diaphragm, to suit variety of application environments. Models are offered as stand-alone units, or in microphone and low-noise preamplifier combination with iTEDS on-board memory storage.

Ophir-Spiricon Inc.    Logan, UT 84321
May 12, 2010 Extending low measurement capability to NIR range, covering from 800-1,800 nm, PD10-IR-pJ energy sensor is able to measure very low energies, either single shot or repetitive, up to 10 kHz. Device uses 5 mm aperture germanium photodiode to measure pulse energies in 200 pJ to 20 nJ range, with lowest possible energy measurement as small as 30pJ. They are designed for commercial and military applications, such as telecommunications and remote sensing.

PKP Process Instruments, Inc.,    Hudson, MA 01748
May 11, 2010 Available for pipe sizes of 1-2 in. with turndown ratios of up to 50:1, DR05 sensors measure flow of water and substances similar to water. Polypropylene pipe fitted with paddlewheel extends into area of flow and is set into rotation by flowing liquid. Rotary motion, sensed by Hall sensor, is output as series of pulses converted into 4-20 mA analog signal or into 2 limit contacts by optional electronics. Wetted materials include a PP housing, ECTFE rotor, and ceramic axels and bearings.

Eyasco, Inc.    Aptos, CA 95003
May 11, 2010 Portable, fully-automated QuB can be deployed to remotely monitor resources and collect data for watershed, flood protection, agriculture, or land use purposes. It can accommodate wide variety of sensors, runs on either AC or DC power, and can be configured to power on/off when only specific measurements are required. Featuring built-in communications and data management capabilities, system can be networked and integrated with SCADA systems.

Canfield Connector    Youngstown, OH 44514
May 10, 2010 Featuring all-encapsulated body covered by metal housing, Series 8E IP67-rated linear actuator magnetic sensor is resistant to shock and vibration and operates over -10 to +70°C range. Switch is available in reed or electronic versions, and electrical connection is made via 9 ft PVC or 8 mm quick connect male pigtail. Mounting styles are available for tie rod or round type linear actuators, and size of sensing area depends on size and strength of magnet and thickness of cylinder wall.

Stellar Technology, Inc.    Amherst, NY 14228
May 10, 2010 Model GT32XX is rugged, all-welded stainless steel sensor that operates over -65° to +250°F temperature range. It has static accuracy of ±0.25% BFSL and voltage, current, and/or digital output signal, while pressure ranges are available from 0-30,000 psi through 0-100,000 psig/a. Burst pressure is 2x FSO or 150,000, whichever is less. Integrating with bayonet-style electrical connector, unit installs via AE F250C fitting up to 60,000 psi and AE F312-C fitting from 75,000-100,000 psi.

EAO Switch Corp.    Milford, CT 06460
May 10, 2010 Multi-tone Switch Module for Series 56 pushbuttons is pre-programmed with Persons of Reduced Mobility Technical Specification for Interoperability (TSI PRM) suitable tone sequences for door opening, door closing, and orientation signal to help disabled users. Product operates with wide range of nominal voltages between 12-110 Vdc(±30%). Volume control box allows remote adjustment of volume in 1.5 dB steps between 66-90 dB to achieve 70 dB (± 2d B) prescribed by TSI PRM.

Canfield Connector    Youngstown, OH 44514
May 07, 2010 Able to sense position of pneumatic cylinders with magnetic pistons, Series 8D features all encapsulated design with metal over housing that protects internal components from harsh environments. Units have 9 ft PVC or 8 mm quick connect male pigtail and come in broad range of clamping styles for sensing round or tie rod type linear actuators. Operating from -10 to +70°C, sensors meet NEMA 6/IP67 specifications and include indicator light that shows switching condition.

Canfield Connector    Youngstown, OH 44514
May 07, 2010 Available in reed or electronic versions, Series 9H consists of profile mounting type switches that fit in 4 x 4 mm square groove, which is designed into aluminum extrusion type linear actuators. Units are available with 9 ft PVC or 8 mm quick connect male pigtail. Operating from -10 to +70°C, sensors meet NEMA 6/IP67 specifications. Sensitivity and orientation is 40 gauss parallel for electronic version and 60 gauss parallel for reed version.

Solartron ISA    Durham DL4 1LH  United Kingdom
May 07, 2010 Seastream(TM) Cone flowmeter is designed for water depths down to 5,000 m, operating pressures of up to 15,000 psi, and line sizes from 2-8 in. It features SST Series of differential pressure transmitters with accuracy of ±1%. Water injection, gas lift, and inhibitor injection applications are supported.

All Sensors Corp.    Morgan Hill, CA 95037
May 07, 2010 Utilizing open bridge configuration, measuring 2 x 2 mm square, MEMS Piezoresistive Low Pressure Sensing Die is suited for high volume applications requiring pressure measurement to as low as ¼ in. of water full scale. By utilizing boss-less structure, position sensitivity is minimized to 0.1% in. H₂O/g. Applications include HVAC variable air volume controls, automotive fuel vapor recovery systems, medical air flow, and portable/handheld devices.

Dwyer Instruments, Inc.    Michigan City, IN 46361
May 07, 2010 Featuring polycarbonate enclosure with vented design, wall mount Series RHP-W is available with integral LCD or remote display that can be ordered for building balancing or LEED validation. LCD indicates ambient temperature and either humidity or dew point, which are measured using capacitive polymer sensor that recovers from 100% saturation. Humidity and dew point can have current or voltage output, while optional temperature output can be current, voltage, RTD, or thermistor.

MEDER electronic, Inc.    West Wareham, MA 02576
May 07, 2010 Model LS03-NN features conical running up thread NPT that facilitates and accelerates assembly without any locknut. Available as Form A (NO) and Form B (NC) sensor must be mounted horizontally for best results. Dimensions and density help product survive rough conditions and applications such as tank controlling, specifically fluid level control within containers and/or vehicles. Plastics design allows for usage in water conditions as well as oily or chemical realities.

Samsung Electronics Co., Ltd.    Seoul 100-742  Korea (south)
May 07, 2010 Designed to fit into 6.5 x 6.5 x 4.5 mm module, S5K4E2 is ¼ in., 1.4 micron, 5 megapixel chip with extended depth of field IP for crisp, sharp images. It supports barcode and business card scanning as well as capture of clear video images at up to 15 fps at full resolution. For 6.5 x 6.5 mm fixed focus camera modules, S5K5CA is 1/5 in., 1.4 micron, 3 MP imager that combines image signal processor (ISP) with CMOS image sensor into one SoC. It also offers 720p HD video capabilities.

Rohrback Cosasco Systems    Santa Fe Springs, CA 90670
May 07, 2010 Suited for use in oil and gas refineries, Double Block and Bleed Service Valve has secondary ball/sealing surface to retain pressure in event that first ball or sealing surface is damaged. Unit features 4130 alloy steel body, 17-4 PH stainless steel ball, fluoroloy stem and seals, and Viton O-ring. Operating at temperatures up to 450°F, NACE-compliant valve has rotating base and provides mechanical operation, eliminating need for compressors and local power source.

Precision Filtration Products    Pennsburg, PA 18073
May 06, 2010 Designed for use in industrial environments, WS09 series is used for measuring dissolved water content in hydraulic, lubricating, and insulating fluids. Sensing probe gets directly immersed in fluid, and readings are shown on LCD screen. While water content output can be displayed in percent saturation or PPM, temperature is displayed in °C or °F. Portable water sensor offers plug-and-play connectivity and can be used as key component in predictive maintenance of plant machinery.

Pepperl + Fuchs, Inc.    Twinsburg, OH 44087 2245
May 05, 2010 Operating in temperatures from -40 to +100°C, MNI40 Incremental Rotary Encoders deliver resolution up to 3,600 pulses/revolution at speeds up to 30,000 rpm. Magnetic, noncontact devices include 2-color LED display and have zero-contact connection between encoder sensor and elastomer-coated magnetic wheel, which enables measurement of speed without ball bearings. Sensing electronics are housed in IP67-rated, compact enclosure. Units also include self diagnostics.

Dwyer Instruments, Inc.    Michigan City, IN 46361
May 05, 2010 Series BYDS Bypass Damper Switch is designed for use with 3-wire floating-point damper actuator that controls static pressure on zone control systems requiring motorized bypass damper. Unit sends 24 V to actuator to drive it open when static pressure increases, and will stop once pressure reaches set point. Green LED indicates when damper is in open position or being driven open. Tubing and 2 static pressure probes are included.

STMicroelectronics    Lexington, MA 02421
May 04, 2010 Model STM8T141 touch sensor controller chip that is designed for main power-on/off control or to trigger wake-up from battery-saving sleep modes. Drawing current as low as 11 µA from battery, 3 x 2 x 0.6 mm, 8-pin unit monitors single touch-sensing electrode embedded on control panel or outer casing of device. It supports proximity sensing, for control without direct contact from user, and driven electrode-shielding wire, which protects against noise from external sources.

Gurley Precision Instruments    Troy, NY 12181
May 04, 2010 Available in both shaft and blind hollow-shaft configurations, A08/R108 series offer incremental (to 4,096 counts) and absolute (up to 12-bits) position information. Products offer several mounting and interface options and support radial/axial load of 3 N as well as optional temperature range of -40 to +85°C. Output options include RS-422 differential line driver for incremental applications or SSI with gray-code or natural binary where absolute feedback is required.