Hitachi Global Storage Technologies
San Jose, CA 95193
Jul 22, 2008 Offered in capacities from 80-320 GB, Travelstar(TM) 7K320 features SATA 3 Gbps interface, average latency of 4.2 ms and average read time of 12 ms. Bulk Data Encryption option is also available (exclusively with SATA 1.5 Gbps interface) for increased data security. This 2.5 in., 7,200 rpm mobile hard drive provides 400 g shock protection and is optimized for acoustics, producing 2.5 Bels when idle and 2.8 Bels during nominal operation.

Hitachi Global Storage Technologies
San Jose, CA 95193
Jul 22, 2008 Available with 3 Gbps SAS or 4 Gbps FC interface, Ultrastar(TM) 15K450 uses PMR technology to deliver 450 GB storage capacity for mission-critical server and storage applications. This 15,000 rpm hard drive offers average seek times down to 3.3 msec and average latency of 2 msec. While fluid dynamic bearing motors minimize acoustic rating (3.7 Bels typ), Rotational Vibration Safeguard technology anticipates and counteracts disturbances stemming from multi-drive configurations.

Leadis Technology, Inc.
Sunnyvale, CA 94085
Jul 22, 2008 Suited for power-sensitive applications with headphone output, LDS9505 and LDS9504 incorporate Gmax(TM) technology for Class-G amplification and offer 5.5 mW/channel power dissipation to promote battery run-time. Adaptive Rail Amplifier and other technologies eliminate pop and click as well as zipper-noise concerns. Requiring 4 mW quiescent power, standalone products are capable of up to 63 mW in single-ended stereo and 106 mW in mono BTL output, with SNR of 102 dB.

Leadis Technology, Inc.
Sunnyvale, CA 94085
Jul 22, 2008 PureTouch(TM) LDS6010 and LDS6040 integrate haptics driver, designed to heighten responsiveness of tactile effects, for use with mobile phone touch-input controls. Driver supports ERM (eccentric rotating mass) and LRA (linear resonant actuator) vibration motors. Compatible with Immersion Corporation VibeTonz® advanced haptic platform for mobile phones, controllers feature 15 touch sensor inputs, consume less than 200 µW in full power mode, and have 1.8 V operating voltage.

Magma Design Automation Inc.
Santa Clara, CA 95054
Jul 22, 2008 Featuring physical optimization capabilities, Hydra(TM) takes timing, power, congestion, and area into consideration and generates implementation-ready floorplan. Floorplan synthesis and hierarchical design planning product combines automated chip planning, automated partitioning and physical block shaping, top-level clock-tree generation, and time budgeting for block-level implementation. Fully automated, shape-aware, and congestion-aware macro placer enables optimal placement.

NEC Electronics
Santa Clara, CA 95050
Jul 22, 2008 Based on enhanced multimedia architecture platform, EMMA3SL/HD(TM) and EMMA3SL/SD(TM) enable users to build STBs and DTVs with H.264 video compression standard. Former supports HD video broadcasts, while latter supports SD broadcasts. In addition to H.264-compliant video decoder, devices combine all key functions needed to receive and decode digital broadcasts. Other features include audio DSPs, EHCI-compliant USB 2.0 host controller, and IEEE 802.3/802.3u/802.3x-compliant Ethernet MAC.

Analog Devices, Inc.
Norwood, MA 02062-9106
Jul 22, 2008 Based on iMEMS® Motion Signal Processing(TM) technology, ADXL001 industrial vibration and shock sensor helps monitor equipment performance and reduce downtime due to unforeseen system failures. It is capable of early detection of motor-bearing vibration and irregularities up to 22 kHz, allowing continuous monitoring to be performed without interrupting normal equipment operations. Product is available in 3 FS dynamic ranges of ±70, ±250, and ±500 g.

Vishay Intertechnology, Inc.
Malvern, PA 19355 2143
Jul 22, 2008 Supplied in 2 x 2 x 0.8 mm PowerPAK® SC-70 package, SiAx1xDJ series comes in various configurations: single, single plus Schottky, and dual devices in n-channel and p-channel as well as n- and p-channel complementary pairs. Voltage ranges are available from 8-30 V with on-resistance values down to 0.011 W at 4.5 V. Halogen-free and RoHS-compliant, products are suited for load switching and battery charging applications in portable devices.

Oki Electric Industry Co., Ltd.
Tokyo 105-8460  Japan
Jul 22, 2008 Compatible with slide and touch sensors, SDK for ML67Q5250 is comprised of evaluation board to develop fingerprint authentication systems and software. Fingerprint authentication LSI enables match-on-device, while touch sensor and driver software import fingerprint image. Interface helps connect desired sensor, and other applications can be developed using included I/O drivers and authentication libraries. Debugging can be done by connecting ARM-compliant JTAG ICE interface.

SatCon Technology Corp.
Cambridge, MA 02142 1221
Jul 22, 2008 Suited for commercial and large-scale grid connected photovoltaic power systems, PowerGate® Plus 75, 100, and 135 kW models are certified to UL1741-2005 standards and have California Energy Commission (CEC) efficiency rating of 96.0%. Products, optimized for energy harvesting and longevity, feature G90 galvanized steel enclosure, DSP control, as well as HMI with sunlight-visible display and membrane keypad.

Silicon Laboratories
Austin, TX 78727
Jul 22, 2008 Occupying 200 mm², Si823x ISOdriver Series integrates 2-channel isolator and dual driver into single chip. High-side, low-side, 4 A units feature propagation delay of 50 ns, optimizing timing margins and control response. Because devices are designed in CMOS, they do not suffer from performance drift over time and temperature. Integrated under-voltage lock-out circuitry prevents erroneous FET driver switching when input voltages are low during system start up/shut down.

Synopsys, Inc.
Mountain View, CA 94043 4033
Jul 22, 2008 DesignWare® System-Level Library features transaction-level models (TLMs) for PowerPC®, MIPS, and DesignWare IP, which are written in SystemC to work in any IEEE 1666-compliant simulation environment. TLMs enable users to build virtual platforms for early software development, hardware/software co-design, architectural exploration, and system verification. Virtual I/O capability allows communication over host Ethernet or USB connection of computer executing virtual platform.

Transistor Devices, Inc.
Cedar Knolls, NJ 07927
Jul 22, 2008 Designed for use with remote, outdoor cabinets, 1U Power Center helps manage site performance by providing -54 V power, rated up to 1,000 W, and signals for flush fans, door alarms, and other environmental controls. Single rack unit offers 2 hot-pluggable 500 W rectifiers that convert 90-276 Vac into DC, which is distributed through up to 10 GMT fuses. Connection to external battery has optional circuit breaker and low voltage disconnect for optimizing safety and performance.

Blasters, Inc.
Tampa, FL 33637
Jul 22, 2008 Available as truck-mount or tractor-mount system, Liquidator(TM) incorporates Vacuum Recovery Box with angled floor and self-dumping vibrator designed to optimize operation. Custom designed system delivers waster blast pressures from 20,000-40,000 psi for paint line removal, rubber removal, curbing compound removal, and coating removal from various asphalt and pavement surfaces on roadways, parking lots, and airport runways and taxi ways.

ATC-Diversified Electronics
Lancaster, PA 17601
Jul 22, 2008 DIN rail mounted DLA Series 3-Phase Monitors protect equipment from adverse conditions such as phase loss (single phasing), undervoltage (brown-outs), and phase reversal (improper sequence). DTA Series Multifunction Time Delay Relays combine multiple timing functions and ranges into one DIN rail-mount package. Both are suited for users and OEMs in water, food, and automation industries.

Cornerstone Automation Systems, Inc.
Prosper, TX 75078
Jul 22, 2008 Designed for rejecting cartons from roller and belted conveyors, SortMaster 130 HS is offered in widths from 12-36 in. and handles products up to 36 in. long and weighing up to 75 lb. This pusher sorter, suited for applications requiring 30+ cartons/min, handles up to 60 products/min and does not require existing conveyor to be cut for installation.

AFC Industries, Inc.
College Point, NY 11356
Jul 21, 2008 Featuring fold-down keyboard tray with damper and VESA-compliant monitor holder, i-Center accommodates any standard computer and turns empty wall space into work area. Workstation has laminated front and side wall, which can be specified to match room and mounts with grommet holes to allow cabling. Removable front panel with security screws prevent theft.

Mitee-Bite Products Inc.
Center Ossipee, NH 03814
Jul 21, 2008 Measuring 10 mm high and utilizing ½-13 cam screw, Series-9 Clamps are manufactured so each clamping surface is 1 mm greater in distance from centerline then previous surface. By rotating hex, clamps can hold parts that vary up to 6 mm. Clamps come in 4 different sizes for total adjustment of 24 mm without changing to different hole location. Available with smooth or serrated clamping edges, heat treated hexes are suited for clamping castings and rough cut stock.

Elco Enterprises, Inc.
Jackson, MI 49201
Jul 21, 2008 Utilizing wire feed sensor and controller, Wizard View(TM) Wire Central DAQ System monitors critical welding wire usage information - quantity left in drum, speed of travel - measured in US or metric units. Elimination of constant manual inspections automates weld wire usage information monitoring. Alerts notify operator when wire has stopped moving, when pre-set amount of wire is left in drum, and when wire is not within programmable wire feed speed window limits.

Hawk Measurement America
Phoenix, AZ 85009
Jul 21, 2008 Suited for blocked chute detection in bulk material conveying and transfer systems, Gladiator Series uses microwave energy to detect blockage of path between sender and receiver. Systems can be configured as remote - where controller drives sender and receiver, or integral with stand-alone sender and receiver, depending on user requirements and access to sensing positions. Switches include Modbus communications as standard, and have options for other protocols.