Harting KGaA      Germany
Jul 28, 2008 With Field Termination Panel Feed-Through M12 Connector, user can choose between IDC termination by use of HARAX® contact blades, or standard crimp termination. Special tools are not necessary when HARAX® product has been chosen, and wide range of shielded cables fit design. D-coded versions for Ethernet applications are offered as well as A-coded panel feed-through connectors.

Tecate Industries    Poway, CA 92064
Jul 28, 2008 Offered to facilitate packaging and integration of Maxwell Technologies' MC Power Series Boostcap® ultracapacitors, PowerBurst® MCI Integration Kits allow design engineers to create test modules for proof of concept testing. Interlocking end cap system enables modules to be assembled using snap-together feature. Provided with all hardware and instructions required to build 2-, 4-, or 6-cell modules, kits include PCBs with voltage management circuitry, buss bars, washers, and retaining nuts.

DATAMARS INC.    Peachtree City, GA 30269
Jul 28, 2008 Designed for manual sorting operations, PersonalChip RFID Laundry Tag operates on principle of multi-read high-frequency radio waves, which can be read through non-conductive material. Passive transponder transmits code, which identifies item without risk of error. Measuring 11 mm in diameter x 2 mm thick, chip can be read at distance of 20 cm and resists harsh environments of laundry processes, including sterilization and temperatures from -40 to +120°C.

Vertilon Corporation    Westford, MA 01886
Jul 28, 2008 Model SIB164 provides mechanical and electrical interface between Hamamatsu H7546B 64-anode photomultiplier tube (PMT) and 64 channel DAQ system. Charge signals from high-speed events are detected by PMT mounted on SIB164 and sent over specialized cables to DAQ system. When used with IQSP582 PhotoniQ system, SIB164 achieves single photon sensitivity at rates exceeding 200,000 events/sec. Board also incorporates last dynode preamplifier and 3 types of on-board pulse discriminators.

ACT/Technico    Warminster, PA 18974-3531
Jul 28, 2008 Offered in convection- and conduction-cooled configurations, solid state Flash PMCStor uses USB flash disk controller; memory is organized as array of 4 flash banks with throughputs of 15 MB/sec per array when seen as individual USB drives, or up to 30 MB/sec as single drive in RAID mode. Module includes wear leveling, write protect and error detection, and bad block correction. Three high-speed USB ports allow for additional memory access.

Z-Communications, Inc.    San Diego, CA 92126
Jul 28, 2008 Featuring 2nd harmonic suppression of -28 dBc, UHF-Band Model CLV0795E-LF operates from 797-803 MHz with tuning voltage of 1-4 Vdc and typical tuning sensitivity of 18 MHz/V. Unit delivers typical output power of -6.5 dBm at 5 Vdc supply while drawing 23 mA over temperature range of -30 to 85°C. Housed in MINI package measuring 0.50 x 0.50 x 0.22 in., RoHS-compliant VCO is suited for cellular and satellite communications applications.

Z-Communications, Inc.    San Diego, CA 92126
Jul 28, 2008 Operating at 3,539-3,549 MHz with, Model CRO3544A-LF features typical phase noise of -111 dBc/Hz at 10 kHz offset and tuning sensitivity of 7 MHz/V. Device delivers typical output power of 3.5 dBm at 5 Vdc supply while drawing 20 mA over temperature range of -40 to 85°C. Housed in MINI package measuring 0.50 x 0.50 x 0.22 in., RoHS-compliant VCO features 2nd harmonic suppression of -20 dBc and is suited for satellite communications and fixed wireless applications.

Z-Communications, Inc.    San Diego, CA 92126
Jul 28, 2008 Covering bandwidth between 0.5-4.5 V, S-Band Model CRO3628A-LF features phase noise performance of -105 dBc/Hz at 10 kHz offset and typical tuning sensitivity of 20 MHz/V. Unit guarantees output power of 4.5 ±3.5 dBm at 5 Vdc supply while drawing 22 mA over extended operating temperature of -40 to 85°C. Housed in MINI package measuring 0.50 x 0.50 x 0.22 in., RoHS-compliant device is suited for satellite communication applications.

Z-Communications, Inc.    San Diego, CA 92126
Jul 28, 2008 Suited for satellite communications and other telecommunications applications, PSA1200A-LF Phase Locked Loop (PLL) module delivers phase noise of -103 dBc/Hz @ 10 kHz offset and is designed to perform at frequency of 1,200 MHz. RoHS-compliant solution, supplied in 0.63 x 0.86 x 0.14 in. PLL-24 package, has supply voltage of 5 Vdc, offers typical power output of 0 dBm, and consumes 33 mA (typ) over 0 to +60°C range. Typical 2nd harmonics suppression is -15 dBc.

Ideal Industries, Inc.    Sycamore, IL 60178
Jul 28, 2008 Combining 7 testers into one portable device, SecuriTEST PRO allows one technician to verify and troubleshoot complete CCTV system. Video and sync testing assures each camera is set to its correct video output level, built-in digital multimeter is included for testing electrical signals, and audio input enables audible assessment via integral speakers or 2.5 in. color LCD. Tester supports 20+ PTZ camera protocols and can wire map UTP cables as well as generate video test patterns.

Kaeser Compressors, Inc.    Fredericksburg, VA 22404
Jul 28, 2008 Designed for minimal maintenance, direct drive series features Sigma Profile airend, Sigma Control, and one-to-one direct drive technology. Oversized airend connects directly to motor via maintenance-free coupling for zero-loss transmission efficiency. Cooling air flow design minimizes noise levels, and series is fitted with separator system for minimal oil carryover. Models are available with ratings from 25-450 hp, flows from 72-2003 cfm, and pressures to 217 psig.

Weed Instrument Co., Inc.    Round Rock, TX 78680
Jul 28, 2008 Designed for harsh environment of autoclave steam sterilizers, Model 3312B uses cable material that withstands moisture intrusion during pressure and vacuum cycling, and meets USP Class VI requirements for use in sanitary environments. Material has low memory and, thus, resists kinking. Available in variety of sheath and lead-wire jacket diameters, RTD comes in sharp-pointed version for insertion into rubber-capped vials, small bottles in tray washers, and sterile bags.

Cherry Electrical Products    Pleasant Prairie, WI 53158
Jul 28, 2008 Providing protection against dirt and moisture, J84-2120 Series is suited for applications ranging from clean manufacturing facilities to in-vehicle computing. Units feature backlit keys with 4 levels of brightness and integrated pointing device in 11.4 wide x 6.4 in. high package. CLEAN key disables key functions during cleaning process to prevent accidental data transfer and ensure cleaning and infection control procedures can be carried out without disruption to operations.

Stencil Ease    Old Saybrook, CT 06475
Jul 28, 2008 Available in 4, 6, 8, 10, 12, and 18 in. sizes, Quadra Lock interlocking stencils are comprised of letters, numbers and spacers that fit together like puzzle pieces to form words, phrases, and numbers for industrial marking and parking lot applications. All characters are pre-spaced to facilitate alignment and can be painted via roller/brush or sprayed with any paint, ink, or stain. Uses include curbs, parking lots, sidewalks, and containers.

Del City    Menomonee Falls, WI 53051
Jul 28, 2008 Rated to meet SAE Class 1 vehicle requirements as well as SAE J845 specifications, LED directional lights feature 42 LEDs encased and securely sealed in epoxy material. Self-contained electronic control lets lights be wired directly to 12 V power switch, eliminating need for installation of driver compartment control box. Surface mount light can be installed on any flat surface, while grommet-mount versions can replace existing oval directional lamps.

Kingbright Corporation    City of Industry, CA 91789
Jul 28, 2008 Operating at forward current up to 150 mA, Ultra-Bright 0.5 W SMD LEDs come in blue, white, warm white, green, yellow, and red as well as RGB Full Color option at 120 mA per channel. Viewing angle is 120°, and package design is optimized for heat dissipation. Built-in zener diode withstands ESD voltage up to 8,000 V. IR reflow solderable and automation friendly, series is designed for automatic pick-and-place mounting process.

DDP Supply    El Segundo, CA 90245
Jul 28, 2008 LED light engine is 3.8 W, 100 lumen forward-fit solution that delivers 5,100K light evenly over 120° area. Exhibiting 26 lumen/W efficacy and low thermal resistance of 40°C/W, product provides appropriate amount of energy-efficient light at proper viewing angle for landscape and walkway lighting applications. Product manages heat to maintain longevity of LED lights and can be designed to meet design requirements such as specific color and brightness levels.

RIDGID    Elyria, OH 44035
Jul 28, 2008 With grooving capacity of 1¼ to 6 in. pipe, Model 975 offers auto tracking technology that keeps pipe engaged to groove rolls throughout grooving process. Combo groover provides accurate grooves on schedule 10 and 40 steel, stainless steel, aluminum and PVC pipe, and permanently fixed, depth-setting gauge allows for quick, repeatable setup. Weighing 26 lb, rugged design includes heavy-duty bearings and heat-treated top plate. Groover can also be mounted to RIDGID 300 power drive.

Papailias, J. G., Co., Inc.    Northvale, NJ 07647
Jul 28, 2008 Constructed with die cast anodized aluminum parts, Series SLEX-100 and REX-100 provide lighting and viewing through single port. Both corrosion-resistant electric lighting fixtures are listed to UL-844 and C-UL/CSA C22.2 No 137. They use high-intensity halogen lamps to provide bright, glare-free illumination of normally closed containers. Lens is finely ground borosilicate glass that mates with machined seat in body of fixture to form seal.

Ideal Shield, LLC    Detroit, MI 48209
Jul 28, 2008 Made of schedule 80 and schedule 40 pipe sleeved in OSHA Yellow ¼ in. HDPE tube, Ideal Shield® Protective Guardrail System can withstand multiple hits from 12,000 lb forklift traveling 8 mph. Design eliminates need for scraping and painting of guardrail while also helping to prevent personnel injury, equipment repairs, and downtime. Delivered fully assembled, product is offered in standard or custom lengths and heights with plate or core installation.