Tiax LLC    Cambridge, MA 02140
Jan 16, 2013 Used to detect and preempt short circuits, lithium-ion battery safety sensor system provides early warning of developing hazardous conditions inside lithium-ion cell. Technology employs sensors in combination with proprietary signal processing algorithms and works for any lithium-ion battery chemistry. In lithium-ion cell packs, system is effective over range of temperatures as well as in automotive duty cycles and does not require changes in cell design.

LIMO    Dortmund   Germany
Jan 16, 2013 Custom micro-optics focus blue and other single laser diodes beam to size of 40 x 40 µm². Available with or without housing, laser diodes promote flexible use for custom optics. Micro-optics applications for laser manufacturers can include pumping solid-state crystals and fiber coupling.

Atmel Corporation    San Jose, CA 95131
Jan 16, 2013 Offered with 512 KB and 1 MB embedded Flash memory options in BGA and QFP packages, SAM4E series features floating point unit (FPU), safety and security features, as well as such communication links as Ethernet IEEE1588 MAC, USB 2.0, and dual CAN. Processing power is optimized via max operating frequency of 120 MHz, FPU, and integrated cache providing zero wait state flash access at full speed. Other features incldue 2 independent 16-bit ADCs.

Bell Howell Mailing Systems Div.    Durham, NC 27713
Jan 16, 2013 With no liner waste to discard, ParcelMgr™ gantry-style, top-apply labeling solution is green and efficient. Linerless print-and-apply labeling technology, while promoting throughput and efficiency, allows system to produce varying length labels on demand and eliminates need for multiple dedicated systems. System delivers throughput required by distribution center and logistics managers to keep up with parcel processing growth.

Johnson Controls GmbH    Burscheid 51399  Germany
Jan 16, 2013 Leveraging dual voltage architecture, 48 V Micro Hybrid battery system would employ lead-acid battery and 48 V Lithium-ion battery to enable optimization of energy generation and consumption. While 48 V battery would support higher power loads, such as electric air-conditioning, active chassis technologies, and capture of direct regenerative power energy braking, 12 V battery would continue to provide power to vehicle starter, interior and exterior lights, and entertainment systems.

Renco Electronics, Inc.    Rockledge, FL 32955
Jan 16, 2013 Designed for AC power line filtering and EMI suppression in switch-mode power supplies, RL-9250 can operate from -40 to +105°C and supports custom engineering. Surface mount common mode choke, offering inductance values from 0.075–12.0 mH and dielectric withstanding voltage rating of 2,000 Vac line-to-line, is engineered to function in diverse environments.

Columbus McKinnon Corp.    Amherst, NY 14228
Jan 15, 2013 Designed to fit all trailers and all standard landing gear, Sixth Wheel Ratchet enables truck operators to use ergonomically correct posture, utilizing body weight while minimizing muscle exertion to reduce risk of injuries. Made from hardened steel, self-locking security pin and cap can only be removed by using heavy-duty shop equipment.

Eastman Machine Company    Buffalo, NY 14203
Jan 15, 2013 Suited for use with conveyor and static cutting systems as well as manual cutting machines, LeatherPRO™ offers digital defect marking and allows up to 2 operators to simultaneously mark imperfections on hide. System can handle up to 6 defect types and 6 pattern quality zone types. Defects are marked with projected virtual lines using light pen, eliminating chalk and tape residue. Maximum yields are accomplished via digital hide database, sorting algorithms, and ability to nest for long periods.

Charles Ross & Son Company    Hauppauge, NY 11788
Jan 15, 2013 Multi-purpose HSM-100LCI-T is offered with interchangeable mixing attachments. With 16 in. clearance under mixing attachment and 12 in. distance between feet (base) enable use with different size vessels, mixer is capable of such tasks as powder wet-out and dispersion, deagglomeration/particle size reduction, solubilization, emulsification, and homogenization. Unit has Type 316 stainless steel wetted parts, variable speed control, and color touchscreen.

Pepperl+Fuchs    Twinsburg, OH 44087
Jan 15, 2013 With 8 mm dia, NBB1.5-8GM16-E2 short barrel sensors include PNP NO and NC versions. Model NBB1.5-6,5S16-E2 short barrel sensors have 6.5 mm smooth barrel and operate in PNP NO mode. They feature 16 mm cylindrical stainless steel housing and deliver 1.5 mm sensing range with 6,000 Hz switching frequency. Model NBB0,8-F141-E2 square profile inductive sensors have 25 mm, nickel-plated brass housing with 5 mm square profile. They have 0.8 mm sensing range and switching frequency of 10 KHz.

Hunter Foundry Machinery Corporation    Schaumburg, IL 60196
Jan 15, 2013 Based on Venturi principle, JetSlinger™ accelerates sand into cope and drag flasks on Hunter XL automated matchplate molding machines. Device creates vacuum and jet exhaust, drawing sand mixture through array of nozzle assemblies built into manifold mounted directly below Fillaerator blades and then slinging sand into flask. With perpendicular fill, impact-assisted device produces molds with optimized surface quality, owing to powered pre-compaction of sand.

Adhesives Technology Corp.    Pompano Beach, FL 33064
Jan 15, 2013 With cure time under 20 min, Crackbond CSR exhibits strength of 4,900 psi in 1 hr. Viscosity allows deep penetration into concrete cracks, enabling high-strength structural repair. Self-leveling material, which may be used down to 0°F, consists of resin and hardener uniformly dispensed from dual cartridge system and mixed simultaneously through mixing nozzle. Uses include repairing spalled floor joints and concrete on bridge and parking decks as well as repairing floors.

Prysmian Fiber Cable - a Division of the Prysmian Group    Claremont, NC 28610
Jan 15, 2013 With buffer tube bend radius of 20 mm and fiber bend radius of 7.5 mm, bend-tolerant LT2.0 BBXS outside plant loose tube cable enables more cables to be placed in duct. Design enables use of smaller reels and promotes handling efficiency in field. Up to 456 fibers fit in 1 in. duct, and ITU G.652.D- and G.657.A2-compliant cable is backwards compatible with existing single-mode fibers. Product is also compliant with North American cable standards GR 20 and RUS / RDUP PE 90.

Fulham Worldwide    Hawthorne, CA 90250
Jan 15, 2013 Compatible with LED and fluorescent technology, plug-and-play HorseSense™ system installs into existing fixtures in individual rooms and does not require any commissioning; drivers/ballasts are factory-addressed. Energy conservation opportunities are possible via occupancy sensing, dimming, and multi-scene control. Addition HorseSense controller, software, and commissioning enables larger areas can be controlled, such as floors, non-adjacent rooms on floors, or entire multi-floor building.

Balluff, Inc.    Florence, KY 41042-0937
Jan 15, 2013 With 0.1° accuracy and 0.01° resolution, liquid-based BSI Inclination Sensors detect deviations from horizontal axis over full 360°, contact-free and absolutely. Capacitive sensors are suitable when inclination angles need to be precisely detected or rotary movements must be constantly tracked. Featuring IP67-rated metal housing and temperature range of -40 to +85°C, sensors are suited for wind power stations, solar-thermal power plants, oil/gas production plants, and medical technology.

Z-Communications, Inc.    San Diego, CA 92126
Jan 15, 2013 Operating from 470–520 MHz with 100 kHz step size, Model PCA0495B-LF provides phase noise of -97 dBc/Hz at 10 kHz offset and can be programmed through 3-wire serial interface. Device delivers typical output power of 4 dBm into 50 Ω load while operating off single supply voltage of 3.3 Vdc and consuming 25 mA of current. Housed in 0.50 x 0.50 x 0.13 in. package, synthesizer features spurious and 2nd harmonic suppression of -65 and -10 dBc, respectively, and operating temperature of -40 to 85°C.

Harting KGaA      Germany
Jan 14, 2013 Supporting data rates up to 100 Mb, fully screened Han® Megabit Module suits applications in industry and railway technology. Aspects of assembly and size foster use, and 2 data cables can be connected per module. Screening design is independent of that of housing, and Han D crimp contacts can be installed into inserts and arranged for optimal accessibility. These Cat. 5e products accommodate stranded wires from 0.14–2.5 mm² and cable diameters from 5–12 mm.

Lincoln Electric Co. Inc., The    Cleveland, OH 44117
Jan 14, 2013 Suitable for shipbuilding, offshore, construction, and pipe welding operations, Activ8™ is available in One-Pak® configuration that includes Magnum® PRO Curve™ 300 gun and 15 ft cable. Feeder is designed for 8 in. spools and is compatible with any DC CV and/or CC power source. Rated at 330 A at 60% duty cycle, Active8™ feeds self-shielded FCAW or FCAW-G and GMAW gas-shielded wires at 50–800 ipm. It handles GMAW wires from .023–.052 in. dia and FCAW wires from .035–5/64 in. dia.

Huntkey Enterprise Group    SHENZHEN   China
Jan 14, 2013 Equipped with auto-sensing night light, 1 Watt Wireless Charging LED Light is designed to turn on immediately after blackout. Unit features 5 LEDs and 3 modes of illumination. High mode uses all 5 LEDs, while Middle mode uses 3 LEDs and Low mode uses only center LED. Powered by rechargeable lithium batteries, torch light is placed in charger which is plugged directly into socket. When fully charged, it will turn off automatically.

Artel, Inc.    Westbrook, ME 04092 2026
Jan 14, 2013 Designed for use with MVS® Multichannel Verification System, 100% DMSO-based Sample Solutions will provide users with ability to measure accuracy and precision of volumes of DMSO dispensed into microwell plates. First in line of solutions simplifies volume verification process for users of sub-µL liquid handling instruments, and will help ensure validity of high-throughput screening assay results.