Fisnar Inc.    Wayne, NJ 07470
Dec 03, 2002 Model DV509 dispenses medium/low viscosity fluids while keeping wetted parts separated from operating air supply. Micro shot sizes are possible using screw adjuster. Valve is opened by air pressure pulse supplied by valve controller. Assisted by heavy duty spring, diaphragm is returned to closed state for immediate shut off. Valve provides 200 cycles/min and withstands constant 24 hr production cycling.

Caddock Electronics, Inc.    Riverside, CA 92507
Dec 03, 2002 Type USG resistors offer temperature coefficient of 10 ppm/°C from -40 to +85°C, ref to +25°C for minimal start-up drift and stability over wide temperature range. Standard tolerance is ±0.10% in Standard Resistance Values from 50–200 Meg. Typical resistance change after 1000 hr at full rated voltage is 0.025%; max change is 0.05%. Applications include high voltage power supplies for electron microscopes, semiconductor manufacturing equipment, and spectrographic equipment.

Solartron Mobrey    Houston, TX 77084
Dec 03, 2002 Quad-stream Model 1540 monitors, routes, and reports gas flow volume, energy, mass, and rate by time. It is easily user-configured, displaying forward and reverse volume flows, mass flows, and energy values for each stream and for total station. Unit can be used with turbine, orifice, ultrasonic, Venturi and V-cone flowmeters. HART and 4-20 mA analog, pulsed, and digital Modbus communications ensure compatibility with field instruments and gas chromatographs.

TTI, Inc.    Williston, VT 05495
Dec 03, 2002 Model TPI-40 provides fine tuning adjustments and adjustable stroke, allowing user to generate, without exceeding, desired pressure or vacuum. Output pressure is 600 psi and output vacuum is 0 to -28.5 in. Hg. Pump is made of nickel-plated brass and clear anodized aluminum. It is suitable for use with electronic calibrators, digital indicators, analog gauges, pressure transmitters, transducers, and relief valves.

Precision Multiple Controls Inc.    Midland Park, NJ 07432
Dec 03, 2002 Stake-supported Model BT10-HS signaling and warning device combines battery-powered baton with tubular, metal shaft and quick-release clamps. Whether in flashing or steady-on mode, baton's 10 LED lights can be seen from up to ½ mile. In operation mode, 13 in. lighted length of baton extends above 15 in. stake. In storage mode, baton mounts parallel against stake. Weatherproof signaling device requires 2 D-cell batteries to provide 300+ hr of continuous flashing operation.

Advantech Technologies, Inc.    Irvine, CA 92618
Dec 03, 2002 NS Geodeâ„¢ GX1 x86-based Single Board Computer utilizes SyncFlash® non-volatile memory, which has DRAM-like internal architecture and replaces flash or ROM typically used to store operating code. It reduces need for redundant DRAM because code is not duplicated in DRAM for optimal performance. Instructions are directly executed from flash. SyncFlash has 64-bit data bus that supports burst-read operations at max speeds of 133 MHz. SBC runs Windows CE.

Wieland Electric Inc.    Burgaw, NC 28425
Dec 03, 2002 DIN-rail mountable dipos Series transmits thermocouple sensor signals with isolation from resistive, inductive, or capacitive interference. Modules are coded for error-free installation and sealed to prevent unauthorized access. Housings are 12.5 mm wide and available in spring and screw-clamp versions. Units provide 4 kV insulation voltage and include circuit status LEDs, zero/span adjustment, cold junction compensation, and interval jumpering for power bussing.

National Instruments Corp.    Austin, TX 78759-3504
Dec 03, 2002 Vision Builder for Automated Inspection can integrate image acquisition, machine vision inspection, decision making, and I/O control into manufacturing test application. Built-in I/O capabilities allow user to control serial lines and static digital I/O modules and interface to external devices including strobes, cameras, and PLCs. Decision making and data logging functions let engineers store images and inspection data based on predefined criteria.

National Instruments Corp.    Austin, TX 78759-3504
Dec 03, 2002 Model PCI-7342 integrates with data acquisition and vision systems. Users can configure 2 axes for stepper or servo motors while utilizing linear interpolation for multi-axis movement, 32 bits of digital I/O for high-speed capture, and RTSI bus for real-time synchronization. Motion Assistant point-and-click interface generates LabVIEW code allowing PCI-7342 to seamlessly integrate motion control into automated test and machine control applications.

Emerson Process Management    Knoxville, TN 37932
Dec 03, 2002 Züllig COSMOS-25 provides suspended solids measurements. Able to be used in open channels or basins and pipelines, its multi-beam technology renders product less vulnerable to measurement discrepancies.

Emerson Process Management    Knoxville, TN 37932
Dec 03, 2002 Rosemount® Model 485 Annubar® product line permits use of differential pressure instrumentation for flow measurement. Frontal slot design extends across entire pipe diameter, sampling 80% of fluid profile. Model 3051SFA ProBar®, with Model 3051S transmitter, provides user-configured flow units, low flow cut-off, and custom process alerts. Model 3095MFA Mass ProBar flowmeter, with Model 3095 Multivariable transmitter, enables accurate mass flow output from 1 pipe penetration.

Advanced Photonix, Inc.    Camarillo, CA 93012
Dec 03, 2002 Hybridized with 1 Megohm gain transimpedance amplifiers, 100 element photodiode array utilizes opaque polymer coating process to create mask that blocks any light outside pixels. Mounted on 1 PCB, each detector element is connectorized to TIA using AC coupling scheme to automatically filter out signals due to DC ambient light levels. Nominal specifications include pixel size of 0.045 x 0.050 mm with 0.055 mm pitch. Operating spectral range is 350–1100 nm.

Rez-Solutions    Lakewood, NJ 08701
Dec 03, 2002 Two-component, 100% solids, pigmented, polyurethane-base Soft Floor Systems are suitable for balconies, ramps, locker rooms, hospitals, and skating rinks. Soft Floor 6000 is topped with polyurethane or pigmented Polyurea. It can be applied between 10 and 250 mils in one pass without bubbling due to out gassing. Soft Flake 6001 is broadcast with colored vinyl flakes and top coated with clear urethane. Soft Grip 6002 is broadcast with pigmented rubber fines for non-skid safety surface.

ATI Technologies, Inc.    Thornhill, ON L3T7N6  Canada
Dec 03, 2002 FIRE GLâ„¢ X1-128MB, based on FGLâ„¢ 9700 visual processing unit, and FIRE GL Z1, harnessing FGLâ„¢ 9500 VPU, support OpenGL® 2.0, Microsoft® DirectX® 9.0, and AGP 8X. Support of AGP 8X offers 2-way, high-speed interface between graphics subsystem and workstation at 2.0 GB/sec. X1-128MB provides 8 parallel rendering pipelines, allowing creators to preview finished scenes of cinematic quality in real time. Both boards include Right Hemisphere® software to accelerate production pipeline.

SE Relays LLC - Magnecraft Brand    Northfield, IL 60093
Dec 03, 2002 Two-pole, double-throw Series 711, with 12 A contacts, is available in standard AC or DC input voltages. LEDs indicate if input is powered, and will show current contact positioning. Contacts stay in last energized position, with no external power required, indefinitely until re-application of input voltage generates a change in position. Two optional snap-on adapters allow relay to be flange or DIN-rail mounted, either standing on end or lying on side.

eNGENUITY Technologies, Inc.    Montreal, QC H4P 1T7
Dec 03, 2002 STAGE v4.1 includes Digital Feature Analysis Data (DFAD) support, allowing flexible customization of DFAD map presentations. Visual quality of graphics that can be drawn include perception of depth and 3D-like objects. Product also offers native Distributed Interactive Simulation (DIS) support, making STAGE 4.1 independent of third party DIS solutions. Batch-mode simulation provides operational analysis and mission rehearsal.

Adhesive Technologies, Inc.    Hampton, NH 03842 1995
Dec 03, 2002 Formula 650 packaging hotmelt is suited for carton closing applications and applications involving wax-coated cardboard and paper. Medium compression setting formula has heat resistance of 120ºF and viscosity of 2,125 cps. Ring and ball softening point is 185ºF, and open time is 50 sec. Wax Pack is manufactured in 1¾ x 1¾ in. slugs and meets FDA CFR 175.105 requirements for intermittent food contact.

Imaging Technology Inc.    Bedford, MA 01730
Dec 03, 2002 iGauge can start, load, or import previously configured solutions; adjust sensor focus, brightness, and contrast; and calibrate to real-world coordinates. Images/inspection parameters are recorded for process debug and analysis. It provides measurements to within 1/10th of 1 pixel on fixed or rotationally oriented parts, automatically compensating for lighting and contrast variations as well as lens and perspective distortion. Unit executes up to 1,800 measurements/min.

COOP Consulting LLC    Reston, VA 20190
Dec 03, 2002 myCOOP(TM) v2.1 utilizes Web-based collaborative portal technology. It includes AutoPlan(TM), which allows creation of continuity plans for smaller facilities by filling out 1 survey, and Notify(TM), which pushes short lists of immediate response tasks to recovery teams on Blackberry or similar devices. Browser access provides continuity planning views and functions, including document management, contact lists, surveys, discussions, links, search, and tasks.

Sato America, Inc.    Sunnyvale, CA 94089
Dec 03, 2002 With no wired connections, unit allows user to locate and/or relocate printers, while providing all features of Ethernet-connected print server and WPCPlusâ„¢ (Web-Based Printer Control Plus). WPCPlus allows for control of printer settings and status, real-time error and status notification, and access from anywhere via Internet. Plug-in interface card can be field installed in seconds on all e-printers that use plug-in interface cards.