Tru-Connector Corporation    Peabody, MA 01960 5099
May 01, 2003 Series BMMA consists of sub-miniature BMA connectors with push-on blind mate interfaces. Inner conductors and insulators are mechanically captivated to prevent RF leakage. Connectors are suitable for dc to 28 GHz applications, provide 50 Ohm impedance, 675 VRMS dielectric withstanding voltage, 5,000 megohms min insulation resistance, and -90 dB RF leakage. They have 303 SST bodies, beryllium-copper center contacts, PTFE insulators, and operate over -65°C to +125°C range.

Detroit Precision Hommel    Rochester Hills, MI 48309
May 01, 2003 Automotive Roughness Measuring System consists of part-specific holding fixture mounted to granite plate, and measuring head with user-selectable measuring stylus mounted to traveling vertical column. Totally automated, CNC system checks and verifies surface roughness and contours of internal engine components. It provides detailed measurement reports to document part quality and allow immediate comparison of measured values to database.

Greene, Tweed & Co.    Kulpsville, PA 19443 0305
May 01, 2003 WRâ„¢ 575 is made from carbon fiber composite material that assures corrosion and heat resistance, and reduces need for maintenance, even in extreme conditions. Material is suitable for sleeves, rings, and thrust pads used in gas turbines, steam turbines, hydroelectric turbines, centrifugal pumps, and gearboxes.

Nexen Group, Inc.    Vadnais Heights, MN 55127
May 01, 2003 Model SC100 provides excitation and signal processing to amplify two low voltage sensor signals to industry standard voltage and current levels for further use in process and monitoring applications. Unit supports differential and single-ended signal sensors. Excitation voltages are adjustable and bipolar. Outputs can be scaled to any engineering unit using onboard zero and span potentiometers. Model SC100 interfaces with PLCs, PCs, indicators and other process controls.

Hendrickson International    Woodridge, IL 60517-4904
May 01, 2003 COMPOSILITE-2â„¢ measures 23.5 in. from front edge of hanger to centerline of axle. It provides 9 in. of lift, total axle travel of 13.5 in. and wheel cut of 28°. Bronze bushings at kingpin connection extend life of knuckle assembly. Stabilizer utilizes cover to protect rod from dirt and debris throughout travel. Zero torsion bushings spin freely to eliminate bushing windup. In-line air springs remove risk of possible driveline interference.

TURCK, Inc.    Plymouth, MN 55441
May 01, 2003 Closure Caps, for minifast products, protect unused ports on junction boxes or cordsets. Available in nickel-plated brass or stainless steel, 7/8–16UN threaded closure caps are offered with or without lanyard for male and female applications. Made of nylon-coated stainless steel cable, lanyard does not provide place for unwanted debris to collect and is finished with eye for receptacle applications or loop for cordsets.

Calex Mfg. Co., Inc.    Concord, CA 94520
May 01, 2003 Consisting of 12 models with input ranges from 18–36 and 36–75 Vdc, LT converter family offers 3 regulated positive output voltages ranging from 5–1.5 V. Each output is rated at 10 A, with up to 75 W max power rating for all 3 outputs combined. Housed in ½ brick case measuring 2.4 x 2.28 x 0.53 in., series has 430 kHz switching frequency and is isolated input to output at 1544 Vdc. Remote ON/OFF is offered for power sensitive applications.

Great Lakes Chemical Corp.    West Lafayette, IN 47906 0200
May 01, 2003 DURAD® 40, DURAD®48, and DURAD® 60 trialkyl phosphate anti-wear and extreme pressure additives provide phenol-free solutions that synergize effectively with sulfur carriers and do not readily hydrolyze or interact with other additives. Suited for oil applications, aqueous applications, and applications where high anti-wear performance is needed, low-viscosity, ashless liquids are compatible with mineral and synthetic oils and do not contain chlorine or sulfur.

ExxonMobil Coal & Minerals Co.    Houston, TX 77063 2005
May 01, 2003 Synessticâ„¢ Alkylated Naphthalene (AN) Blendstocks are class of API Group V category fluids manufactured to deliver hydrolytic, thermal, and oxidative stability. Suited for applications from compressor oils and hydraulic fluids to high-temperature greases, low- and high-viscosity configurations offer additive solubility, compatibility with various elastomers, and non-emulsive properties. Stable products require no special equipment for safe handling/storage.

Ircon Inc.    Niles, IL 60714
May 01, 2003 Torpedo Car Inspection System provides thermal inspection of exterior shell of torpedo cars. Thermal Fingerprinting feature identifies each car and links it with its temperature profile information by capturing raised or painted lettering on shell via thermal imaging cameras. Trend algorithm mathematically factors out external effects, while ability to connect 2 thermal imaging cameras with software enables full inspection of each torpedo car.

Linear Technology Corp.    Milpitas, CA 95035
May 01, 2003 Offered in current and voltage modes, LTC3722 zero voltage switching, phase shifted controller is suited for isolated offline and distributed power supplies from 200 W up to several kw. It offers fixed frequency operation with current mode and adaptive zero voltage delay control. Controller also provides closed-loop control method, adaptive/manual delay control, adjustable synchronous rectification timing, adjustable max ZVS delay, and programmable slope compensation.

Foundry Networks, Inc.    San Jose, CA 95164-9100
May 01, 2003 BigIron® MG8â„¢ 10-Gigabit Ethernet (10GbE) switch is based on Terabit-capacity Ethernet switching architecture powered by Terathonâ„¢ ASIC chipset. Layer 3 backbone switch offers 1.28 Terabits of total, non-blocking, switching capacity and wire-speed forwarding in all 32, 10-Gigabit Ethernet ports, for 480 million total packets/sec of Layer 2/3 switching performance per system. Implementation of RFC 3176 (sFlowâ„¢) enables wire-speed traffic monitoring on every port.

National Semiconductor Corp.    Santa Clara, CA 95051-0695
May 01, 2003 Models LP3883/2/1 CMOS dual-input, voltage regulators enable high efficiency linear conversion from 1.8–1.5 V and 1.2 V for notebook and set-top box applications, while consuming low quiescent current of only 3 mA. Power input may be fed independently from high current supply facilitating conversion from input rails of less than 2.5 V. Dropout voltage for Models LP3883/2/1 is typically 210 mV/110 mV/75 mV at 3 A/1.5 A/0.8 A.

Foundry Networks, Inc.    San Jose, CA 95164-9100
May 01, 2003 BigIron® MG8â„¢ backbone switch and NetIron® 40Gâ„¢ metro router incorporate Terabit architecture, which supports more than 1 Terabit of switching in every system and leverages fourth generation Terathonâ„¢ ASIC chipset. Both deliver wire-speed performance, Layer 2/3 switching, and routing capabilities. Terathon ASIC packs more than 80 million transistors utilizing 0.18-micron silicon technology and delivers 1.28 Terabits of system switching capacity.

Cygnal Integrated Products, Inc.    Austin, TX 78746-6564
May 01, 2003 Model C8051F305 incorporates 8051 CPU with 2 K bytes Flash and 256 bytes RAM. Product also offers UART, SMBus®, Analog Comparator, and 3 x 3 mm Micro Lead-Frame Package. On-chip debug circuitry facilitates full-speed, in-system debug features such as single-stepping, breakpoints, and modifying registers and memory. Consumer applications range from print toner cartridges to radio controlled toy cars.

Texas Instruments, Inc. (TI)    Dallas, TX 75243-4136
May 01, 2003 Model AR7 is built with 130 nm copper CMOS process that supports system-on-chip integration of analog circuits with digital logic. Chip combines MIPS 32-bit RISC processor, DSP-based digital transceiver, ADSL analog front end including line driver and receiver, power management, and hundreds of passive components onto single piece of silicon. Programmable digital filters in receive section make it highly adaptable and supportive of all ADSL standards.

GE Company, GE Industrial Systems    Plainville, CT 06062
May 01, 2003 Bathroom Fan Line includes low-noise fans, full-featured fans with lights, nightlights, and heaters, and fans with decorative touches. Units help provide proper ventilation needed to remove humidity, air pollutants, smoke, and fumes to ensure comfort in residential applications.

GE Company, GE Lighting    Cleveland, OH 44112
May 01, 2003 Pro-Tec 3000 offers wide range of management and monitoring capabilities, enabling measurements such as number and timing of faults detected, current value at time of fault, and cause of fault. Lighting operators can reduce diameter of cable required, and increase distances between relays. Repair requirements can be pinpointed rapidly, reducing downtime and improving public safety.

GE Power Systems    Atlanta, GA 30339
May 01, 2003 Smallworld Design Managerâ„¢ v2.2 automates and manages end-to-end engineering design processes. It includes incremental job completion functionality, allowing for completion of any number of sub-designs throughout entire state model, while maintaining identity and integrity of original design job for proper archiving. With ability to divide overall project into several planning scenarios or incremental designs, utilities can better manage large planning and design jobs.

Sandmeyer Steel Co.    Philadelphia, PA 19116
May 01, 2003 Plates made of 17-4 PH grade stainless steel are offered in thicknesses of 3/16 through 2 in. in nearly any shape or configuration. 17-4 PH is a precipitation hardening stainless steel which combines high strength, hardness, and corrosion resistance in mechanical components, aerospace, offshore applications, pulp and paper, and food industry.