Maxim Integrated Products    Sunnyvale, CA 94086
Oct 18, 2011 Supplied in 8-pin SOIC package, MAX16841 fixed-frequency LED driver for retrofit lamps provides flicker-free dimming from maximum light intensity down to zero intensity with both leading-edge (triac) and trailing-edge (transistor) dimmers. Constant frequency control optimizes efficiency at both low (100-120 Vac) and high (220-230 Vac) AC line voltages. Operating from 90-265 Vac input, driver prolongs life of LED lamps because it can operate without electrolytic capacitors.

Varedan Technologies    Torrance, CA 90503
Oct 14, 2011 Enabling OEM designers to accommodate range of motion applications, VSA series offers various power ranges and package options: DC powered module, AC powered stand-alone, and multi-axis baseplates. These are designed to drive 3-phase brushless motors, single-phase brush-type motors, and voice coils. Powered from 20-340 Vdc or 80-240 Vac source, products can provide up to 15 A continuous and 30 A peak. Operational modes include 2-phase external commutation, position, velocity, or torque.

Texas Instruments, Inc. (TI)    Dallas, TX 75243-4136
Oct 14, 2011 Respectively supplied in 16-pin SOIC and TSSOP, LM3448 and TPS92070 are phase-dimmable, AC/DC LED lighting drivers intended for solid-state lighting applications. THe LM3448 adaptive, constant-off time AC/DC constant current LED regulator integrates 600 V MOSFET and is optimized for 2-8 W dimmable LED lighting drivers, and the TPS92070 flyback AC/DC constant current LED driver controller is optimized for 6-20 W dimmable LED lighting drivers. Both products feature various protection options.

MagnaChip Semiconductor    Cheongju-si,Chungbuk   Korea (south)
Oct 14, 2011 Used as power conversion part for Switched-Mode Power Supplies where flyback topology is adopted, MDx Series 650 V MOSFETS are typically used for LCD-TVs and LCD monitors which require high-speed switching. In mission critical situations, use of power supplies which incorporate 650V HV MOSFET is essential to securing stable and regulated supply of power, particularly in countries that experience frequent power supply disruptions.

Ironwood Electronics, Inc.    St. Paul, MN 55121
Oct 14, 2011 Designed for 42.5 x 42.5 mm package size, Model SG-BGA-6348 operates at bandwidths up to 8 GHz with less than 1 dB of insertion loss. Socket dissipates 35 W with active heat sinking and features contact resistance of 20 mW per pin, 0.01 pF capacitance to ground, and current capacity of 2 A per pin. Mounted on target PCB with no soldering, socket is constructed with screw mounting and has temperature range of -35 to +100°C.

STMicroelectronics    Lexington, MA 02421
Oct 14, 2011 Implemented in 65 nm CMOS process, ST-MIT voltage-scalable microprocessor SoC suits applications with limited power budget and time-varying processing loads. Power consumption is 10.2 pJ/cycle at 0.54 V, and SRAM memory cells can operate at 0.4 V. Memory-access power consumption is further reduced via latch-based instruction and data caches at first level of hierarchy. Additional features include on-chip ULP clock generation, analog-to-digital conversion, and peripherals.

Texas Instruments, Inc. (TI)    Dallas, TX 75243-4136
Oct 14, 2011 Equipped with high-frequency VCO and programmable output dividers, Model LMK03806 simplifies timing architectures in wired and optical communications line cards by simultaneously synthesizing 7 independent frequencies on 14 outputs. Each output clock is programmable in LVDS, LVPECL, or LVCMOS format. Housed in 9 x 9 mm, 64-pin LLP, Model LMK03806 offers sub 50 fs rms jitter at 312.5 MHz output frequency, optimizing bit error rate and carrier-to-noise ratio performance.

Power Sources Unlimited, Inc.    Wrentham, MA 02093-2210
Oct 13, 2011 Offering up to 92% efficiency, Unipower BLUEstreak products feature integral active output ORing circuit, Class B filter, PMBus serial communications, and automatic load sharing. Power modules can also be used with 1U/1RU 19 or 23 in. Power System Rack, with output capacity up to 8,000 W. Power Racks can be stacked to provide expanded total DC power system capability up to 32 kW or 2,000 A. Available output voltages are 12, 13.6, 24, 27.2, 48, and 54.4 Vdc and +5 and 12 V standby.

M/A-COM Technology Solutions, Inc.    Lowell, MA 01851
Oct 13, 2011 Integrated into phase lock loop using divide-by-2 output, Models MAOC-009871, MAOC-009872, and MAOC-010334 feature frequency ranges of 9.2-10.2, 11.0-11.8, and 8.4-9.25 GHz with phase noise of -113, -112, and -115 dBc/Hz at 100 kHz offset, respectively. Units are packaged in lead-free, 5 mm, 32-lead PQFN package and operate with case temperature at or below +85°C. Applications include point-to-point radio, point-to-multipoint radio, and communications systems.

austriamicrosystems AG    Schloss Premstaetten A 8141  Austria
Oct 13, 2011 Using 12 x 11 cross-plexed technique, Model AS1130 drives 132 LEDs, each with 8-bit dimming control and no external resistor required. Eight-bit analog current control allows fine tuning of each current source to compensate for different brightness of different colors, or to adjust white balance on RGB LEDs. Operating from 2.7-5.5 V over temperature range of -40 to +85°C, IC incorporates 36 frames of memory for small animations or for use as buffer to minimize host processor load.

DATEL    Mansfield, MA 02048
Oct 13, 2011 Comprised of 12-bit current output DACs with TTL/CMOS-compatible inputs and 100 MHz conversion rate, DAC-12100 series suits applications such as radar, signal reconstruction, waveform generators, and communications equipment. Glitch energy characteristic of 3.0 pV-s minimizes generation of switching noise, and complementary current outputs of 0 to -20.48 mA can directly drive 50 ohm loads. Dynamic performance, to Nyquist at fOUT of 2.02 MHz, provides SFDR specification of -85 dB.

Vishay Intertechnology, Inc.    Malvern, PA 19355 2143
Oct 13, 2011 Comprised of 12 models (600 and 650 V) based on Super Junction Technology with max on-resistance from 64-190 mohm at 10 V and current ratings from 22-47 A, E Series promotes power density and efficiency as well as reduction of gate drive loss. On-resistance helps conserve energy in high-power, high-performance switch mode applications, and design withstands energy pulses in avalanche and commutation mode with limits through 100% UIS testing.

Advanced Power Technology    Bend, OR 97702
Oct 13, 2011 Catering to miniaturization needs of embedded systems, SmartFusion® cSoC Series is available in CS288 288-ball chip scale package measuring 11 x 11 x 1.05 mm. Devices feature 100 MHz ARM® Cortex-M3(TM) 32-bit microcontroller sub-system with up to 500 K gates of FPGA. Available in commercial and industrial temperature grades as well as leaded and lead-free packages, SmartFusion® cSoCs provide 135 user IOs, 10/100 Ethernet, and external memory controller with I2C, SPI, and UART interfaces.

JKL Components Corp.    Pacoima, CA 91331-2376
Oct 13, 2011 Available on reels for automatic placement to PCBs for rails in LCD lighting or rear and edge illuminated panels, ZSM Series includes models in topview and sideview packages with profiles as low as 0.6 mm and outputs as high as 13,700 mcd. Size and optical range suited for, among other applications, LCD backlighting. PCB assemblies for backlighting can be supplied using variety of components for color matching, brightness uniformity, and performance.

Atmel Corporation    San Jose, CA 95131
Oct 13, 2011 Housed in XDFN package measuring 2 x 1.5 x 0.37 mm, Model ATA5577M1 consists of 363-bit read/write 100-150 kHz transponder IDIC® designed for small tag applications, including animal ID ear and bolus tags, standard key fobs, and clamshell cards for access control. Two coil wires can directly be soldered onto pads of package and mounted or glued onto antenna coil. Since chip has 330 pF on-chip capacitor trimmed to ±3%, antenna coil is only external component required to form trimmed LF-RFID tag.

JVD Inc    San Jose, CA 95131
Oct 13, 2011 Capable of supplying small to medium quantities, JurASIC Parts Program focuses on bringing obsolete and NLA (no longer available) Analog ICs back into production to meet needs of older commercial and military applications. Process information and masks sets can be obtained from original manufacture, or parts can be re-engineered from scratch. To ensure compatibility, engineers analyze behavior of original designs and incorporate even small abnormalities they may contain into reproduction.

RF Industries    San Diego, CA 92126 4202
Oct 12, 2011 RFA-4013-WB adapter kit offers means to bridge type N devices to 7-16 DIN interfaces. White Bronze plating, which is tarnish free and exhibits optimal electrical performance as well as minimal passive intermodulation, withstands multiple mating cycles. All six white bronze 7-16 DIN adapters contained in this foam-lined, zippered kit are machined from brass and feature Teflon® insulation and silver-plated contacts.

J.W. Speaker Corporation    Germantown, WI 53022
Oct 12, 2011 Featuring 14-diode light pattern, Model 7150 produces bright, white light with 3,000 effective lumens. Aluminum die-cast housing and solid state electronics make lamp suitable for applications that require resistance to shock and vibration. Available in 12 and 24 V versions, Model 7150 comes in flood, spot, and trap lens configurations.

Crestron Electronics, Inc.    Rockleigh, NJ 07647
Oct 12, 2011 Used in commercial environments where multiple speakers need to be run from one amplifier, convection-cooled AMP Series helps meet energy savings objectives without sacrificing audio performance. Each channel is selectable for 210 W @ 4 ohms or 120 W @ 8 ohms and isolated 120 W at 70 or 100 V. Delivering low-noise, low-distortion performance, amplifiers have automatic shut-off and turn-on functionality and suit background music, AV presentation, paging, and public address applications.

Taiyo Yuden (USA), Inc.    Schaumburg, IL 60173
Oct 12, 2011 Measuring 26 x 20 mm with max height of 0.9 mm, Model PAS2126FR2R5504 is suited for pulse current discharge of LED flash, which enables clear photographic images at low light conditions. Device features 0.5 F capacitance, 80 mW max impedance, and rated voltage of 2.5 V. In addition to mobile phones, smartphones, digital still cameras, and digital camcorders, capacitor is suited for portable printers and scanners as well as SSD's UPS applications.