Samtec, Inc.
New Albany, IN 47151 1147
Sep 26, 2008 HSF8 Series Rugged High Speed Flex Jumpers offer choice of mating HSEC8 Series Micro Edge Card connectors in vertical, horizontal, or edge mount designs on .8 mm pitch. They include 14 and 32 differential pairs (7 and 16 signal pairs/side) and 20 and 50 signal single-ended pins (10 and 25 signal pins/side). Jumpers are offered in standard lengths of 5 and 10 in.

LSI Corp. of America
Minneapolis, MN 55441
Sep 26, 2008 Based on 65 nm process technology, TrueStore® RC8900 iterative decoding read channel provides data transfer rates up to 4.0 GHz, while TrueStore PHY8900 offers compatibility with 6 Gb/s SAS and SATA, as well as 4.25 G Fibre Channel protocols. With adaptive equalization, receiver allows restores of noisy data without errors. Debugging is enabled with test features including firmware-controllable signal analyzer, which allows HDD makers to observe, debug, and clean up signals.

Z-Communications, Inc.
San Diego, CA 92126
Sep 25, 2008 Operating in L-band from 1,430-1,930 MHz with tuning voltage range of 2-9 Vdc, RoHS-compliant V674ME03-LF features typical phase noise of -94 dBc/Hz @ 10 KHz offset and typical tuning sensitivity of 102 MHz/V. It delivers typical output power of 5 dBm at 10 Vdc supply while drawing 33 mA (typ) over -40 to +85ºC range and comes in 0.50 x 0.50 x 0.13 in. MINI package with low shield measuring. Typical 2nd harmonic suppression is rated at -15 dBc.

Z-Communications, Inc.
San Diego, CA 92126
Sep 25, 2008 Operating in S-band from 2,190-2,330 MHz with tuning voltage range of 0-5 Vdc, RoHS-compliant V630ME09-LF features typical phase noise of -98 dBc/Hz @ 10 KHz offset and typical tuning sensitivity of 65 MHz/V. It delivers typical output power of 4 dBm at 4.5 Vdc supply while drawing 14 mA (typ) over -40 to +85ºC temperature range. VCO features typical 2nd harmonic suppression of -12 dBc and comes in 0.50 x 0.50 x 0.22 in. MINI package. It is suited for automated surface mount assembly and reflow.

Advanced Analogic Technologies Inc.
Sunnyvale, CA 94085
Sep 25, 2008 Integrating 1.7 A and 800 mA buck converters, Model AAT2789 consolidates power management functions for WLAN products, GPS devices, smart phones, and other handheld devices. Two-channel synchronous step-down converter operates from 2.7-5.5 V, making it suited for portable systems powered from single-cell Li-Ion battery or consumer equipment using 3.3 or 5 V bus. Housed in 3 x 4 mm TDFN package, converter includes soft start as well as over-temperature and current limit protection circuits.

Bookham, Inc.
San Jose, CA 95134
Sep 25, 2008 Enabling expansion of SFP-based board design performance, transceiver can deliver output power from +3 to +6 dBm, has channel spacing of 100 GHz, and offers full C and L band coverage. Optical engines consist of Bookham Avalanche Photodiode (APD) Receiver and buried-heterostructure directly modulated laser. Able to achieve uncompensated reach of 400 km at 2.5 Gbps, solution can operate in high-noise, amplified environments and multi-span links for metro networks.

Murata Electronics North America, Inc.
Smyrna, GA 30080
Sep 25, 2008 Utilizing wirewound technology and advanced ferrite materials, LQH55P series compact power inductors produce inductance from 1.2-22 µH with currents as high as 2.9 A. It is suited for power line filtering with regard to DC/DC converter applications for portable equipment such as digital cameras, hard disk drives for laptops, and other consumer electronics products. Available in 5.8 x 5.2 mm package, product offers both low DC resistance and low power loss.

Oki Electric Industry Co., Ltd.
Tokyo 105-8460  Japan
Sep 24, 2008 Including 2 W output filter-less Class-D speaker amplifier and 16-bit DA converter, model ML26211 incorporates LoudSound technology to increase volume and improve sound quality for small speakers, such as those in portable navigation devices. LSI also includes ALC/limiter, serial audio interface, volume, mute function, sampling frequency range of 8-48 kHz, and clock frequency of 11.2896-54 MHz. Device is available in 2.5 x 2.0 mm 20-pin W-CSP and 4 x 4 mm 24-pin QFN packages.

Micrel Inc.
San Jose, CA 95131
Sep 24, 2008 Operating at 2 MHz, MIC4724 non-synchronous PWM buck regulator addresses need for higher operating/transient voltage for 5 V bus while minimizing footprint requirements. Internal compensation allows for accelerated transient response and use of small LC components. Integrated p-channel MOSFET enables chip to deliver up to 3 A, where designers can realize over 94% efficiency, and also eliminates need for sense resistor to provide current limit. Output voltage is adjustable down to 1 V.

Fujitsu Computer Products of America, Inc.
Tokyo 105-7123  Japan
Sep 24, 2008 Using rare-earth magnet technology, Mag EraSURE ME-P3 Version 2 completely erases sensitive data embedded several layers down that might not have been deleted using conventional methods on hard disk drives, tapes, and other storage devices. Unit eliminates need to remove drive from canister before degaussing it, and enables users to comply with HIPAA, SOX, PCI, and DSS and regulations. Mag EraSURE ME-P3 also meets Department of Defense requirements for destroying magnetically recorded data.

Tyco Electronics Corp.
Harrisburg, PA 17105-3608
Sep 24, 2008 Threaded for panel mounting with coupling nut, PCB Sealed Industrial Ethernet Connector uses through-hole mounting with 2 plastic legs, providing additional mechanical retention before and after soldering. Industrial, rugged, and modular RJ-45 connector includes IP67 sealing and quick-connect bayonet coupling that meets IEC 61076-3-106 Variant 1 specifications. Offered in polarized housing that can prevent mis-mating, it can withstand harsh environments.

Crystek Corp.
Fort Myers, FL 33907
Sep 23, 2008 With control voltage range of 0.5-4.5 V, Model CVCO55CXT-5340-5390 features phase noise of -102 dBc/Hz at 10 kHz offset and output power of +3.0 dBm. Available in industry-standard 0.5 x 0.5 in. SMD package, it has input voltage of 5 V with maximum current consumption of 25 mA, -30 dBc second harmonic suppression (typ), and pulling and pushing of 0.50 MHz and 1.50 MHz/V, respectively. Unit suits digital radio equipment, fixed wireless access, and base stations.

Actel Corp.
Mountain View, CA 94043 4655
Sep 23, 2008 Based on ProASIC®3 architecture, radiation-tolerant 600,000-gate RT3PE600L and 3 million-gate RT3PE3000L support power supplies ranging from 1.2-1.5 V. Reprogrammability of devices facilitates prototyping and eases hardware timing validation while offering critical immunity to radiation-induced configuation upsets. Model RT3PE600L is available in 484-pin CCGA and LGA packages, while RT3PE3000L comes in both 484- and 896-pin CCGA and LGA packages.

Atmel Corp.
San Jose, CA 95131
Sep 23, 2008 Supplied in 4 x 4 mm MLF28 package and designed for portable electronics products, AT42QT1060 integrates 6 channels of touch sensing with ability to drive up to 7 low-current LEDs directly through PWM output function. Capacitive guard channel helps prevent false triggering and uses Adjacent Key Suppression(TM) to ensure only intended key is activated by touch of finger. Operating from 1.8-5.5 Vdc, chip consumes under 1 uA (standby), and GPIO expansion can be achieved via spare IC pins.

Ultrasonic Power Corp.
Freeport, IL 61032
Sep 23, 2008 Offered in 2 versions, UPC Model 5300 suits manufacturers of ultrasonic cleaning systems that may have limited generator mounting space. Users can specify 2 separate operating frequencies - 25, 40, 68, 132, or 170 kHz - for 1,000 W generator (500 W each) at 120/240 V and 3 for 1,500 W generator (500 W each) at 240 V. Respectively measuring 5.25 x 13.75 x 12.5 in. and 5.25 x 13.5 x 13.5 in., both 1,000 and 1,500 W generators come with power intensity and sweep frequency controls.

Fairchild Semiconductor
San Jose, CA 95134
Sep 22, 2008 Model FAN7387 high-voltage gate driver (HVIC) is suited for ballast, SMPS, and half-bridge inverter applications. It features high-side driver operation with negative Vs swings up to -9.8 V and 220 µA quiescent current to enable low power consumption in standby mode. IC utilizes lead-free (Pb-free) terminals and is characterized for moisture sensitivity in accordance with Pb-free reflow requirements of J-STD-020 IPC/JEDEC standard.

Spectracom Corp.
Rochester, NY 14623
Sep 19, 2008 With Model EB03 Epsilon Board, hundreds of transmitters can be monitored and configured regardless of their geographic location. Suited for digital broadcast single frequency networks as well as WiMAX infrastructure, compact unit offers fully integrated GPS synchronization solution. RoHS compliant device can also use external 1PPS or 10 MHz as its reference in place of GPS, and switches automatically from one reference to another while minimizing phase jump.

Lumex Inc.
Palatine, IL 60067
Sep 18, 2008 Including capabilities of through-hole, leaded T-5 mm epoxy lens LEDs, Series SML-H1505xxx-TR OctoLEDs have off-the-board height of 0.43 in. and footprint of 0.24 x 0.24 in. Available on standard 24 mm tape for automatic insertion, RoHS compliant OctoLEDs can withstand soldering temperatures of up to 10 sec at 255ºC. Units are available in full range of colors including red, yellow, green, blue, or white with variety of lens finishes, offering different viewing angle options.

STMicroelectronics
GENEVA   Switzerland
Sep 18, 2008 Model STV0903 single-channel satellite TV demodulator operates with 600 mW STV6110A silicon tuner and meets requirements of DVB-S2 standard for broadcast applications, enabling use with H.264/MPEG-4/VC-1 decoders. Packaged in 14 x 14 mm 128-pin LQFP, set-top box chipset consumes 1.2 W and is supported by ST application program interface. Both devices support QPSK (quadrature-phase-shift-keying) and 8PSK modulation as well as both DVB-S and DVB-S2 processing.

Texas Instruments, Inc. (TI)
Dallas, TX 75243-4136
Sep 18, 2008 Supporting RF antennas as small as 38 x 28 mm, RF-HCT-WRC5-KP221 secure multi-purpose contactless chip/module combines security with flexible and configurable memory that supports up to 5 applications on one contactless card or token. This ISO/IEC 14443 Type B chip offers dynamic encryption via NIST-approved Triple DES and SHA-1 crypto-algorithms as well as ANSI X9.63 based session key security. Also, 128-bit unique session key is generated for each transaction.