STMicroelectronics    Lexington, MA 02421
Jan 23, 2012 Supplied in 2 x 3 x 0.8 mm package, STC3105 measures battery voltage and current to increase handheld electronics' battery runtime and lifespan. IC uses open-circuit voltage and coulomb-counter methods to estimate battery capacity as well as supervise and track charge/discharge status. Drawing 60 µA typ, product also features power-saving mode and programmable alarm output. Latter can alert system when battery state of charge is below certain level without involving system MCU.

Intelliconnect USA, LLC    Crossville, TN 38571
Jan 23, 2012 Qualified to withstand immersion at 60 ft for 4 hr in mated or unmated condition, Pisces IP67 and IP68 waterproof connectors can be hermetically sealed for high pressure environments. Waterproof RF connectors are available for coaxial, triaxial, and twinaxial waterproof connector groups. Standard models include high-frequency waterproof connectors, to commercial and MIL standards, including SMA, TNC, N, SMB, and push-pull connector types. Operating range is -65 to +165°C.

iStor Networks, Inc.    Irvine, CA 92618
Jan 23, 2012 Producing 3,000 lm while drawing 43 W, Hella Power Beam 3000 LED Work Lamp comes in close and long-range illumination models for highway, agricultural, construction, municipal, forestry equipment, and heavy-duty work truck applications. Free-Form reflector technology optimizes output and beam placement precision, while thermal sensor protects against overheating. With 60,000+ hr lifespan, light comes in 5.68 x 4.48 in. die cast aluminum housing sealed to IP6K7 and IP6K9K.

Symmetricom/Analog Solutions    San Jose, CA 95131
Jan 23, 2012 Featuring intelligent auto-switching and multiple signal format support, 9611B distributes and generates centralized reference signals required by communication systems, satellite earth stations, test facilities, and engineering laboratories. Its low-phase noise capabilities for optimal RF distribution allows users to reduce thier equipment needs to support multiple signaling formats. Switch and distribution system also features redundant inputs, 12 outputs, front panel controls, and serial port.

Xilinx, Inc.    San Jose, CA 95124 3400
Jan 23, 2012 ISE® Design Suite v13.4 extends FPGA support and design productivity. MicroBlaze(TM) MCS support includes processor, local memory, GPIO, timers, and interrupt controllers and is pre-configured for hardware developers. RX Margin Analysis uses 2-dimensional statistical eye scan algorithms to optimize signal quality and lower bit error ratio (BER). Partial reconfiguration allows designers to build flexible systems that are able to swap functions and perform remote updates while operational.

Micro Analog Systems Oy    Helsinki   Finland
Jan 20, 2012 Measuring 21.4 x 25.0 mm, Model EB6180B1COB comprises ferrite antenna and PCB featuring MAS6180B1 AM receiver IC and necessary filter crystal and capacitor components. Model MAS6180B1 converts time code signal into digital pulses, which can be directly processed by digital circuitry such as MCU. Time, date, and daylight saving information can be retrieved from signal. Operating from 1.1-3.6 V, Model EB6180B1COB consumes 42 µA during reception and provides 25 µV/m sensitivity.

Intense    North Brunswick, NJ 08902
Jan 20, 2012 Available in 980, 830, 808, 785, and 780 nm wavelengths, 300 mW versions of Series 6030 and Series 6130 are based on Quantum Well Intermixing technology and operate from 25 to 50°C. Lasers are available in selection of free space packages, including 9 mm, C-mount, and 5.6 mm; PDM is optional. Multiple FAC lensing options and various standard beam divergences to match specific applications requirements are available. Areas of use include defense, medical, and print/imaging applications.

Vishay Intertechnology, Inc.    Malvern, PA 19355 2143
Jan 20, 2012 Supplied in 2512 case size, WSLP2512 SMT Power Metal Strip® resistor combines power capacity of 3 W with resistance values down to 0.0005 ohm. All-welded construction incorporates solid metal nickel-chrome or manganese-copper alloy resistive element with TCR of less than 20 PPM/°C. Able to be used over -65 to +170°C range without negative effects on power rating or electrical performance, resistor exhibits inductance of 0.5-5 µH and thermal EMF of less than 3 µV/°C.

IXYS Semiconductor GmbH      Germany
Jan 20, 2012 Offered as integrated optical solution for I²C bus design, CPC5902 buffers bidirectional I²C clock and data ports while providing 3,750 Vrms of galvanic isolation. It supports Standard- and Fast-mode I²C up to 400 kbps, does not require any internal clocking, and supports direct static-state buffering without refresh clocks. Operating from 2.7-5.5 V, communications IC is designed for glitch-free operation and is certified to UL 1577 and EN/IEC 60950.

Ironwood Electronics, Inc.    St. Paul, MN 55121
Jan 20, 2012 Used to socket 16 x 16 x 0.8 mm BGA packages on any application board, SM-BGA-9006 operates at bandwidths up to 40 GHz with less than 1 dB insertion loss. It dissipates few watts with compression screw and can be customized up to 100 W with modified fin design on top of screw and adding axial flow fan. Constructed with elastomer contactor, socket features shoulder screw and swivel lid that incorporates quick insertion method to accelerate IC changeout.

Maxim Integrated Products    Sunnyvale, CA 94086
Jan 20, 2012 Providing Class AB audio performance with Class D efficiency while helping to conserve PCB space in mobile applications such as portable electronic products, MAX98314 mono, 3.2 W, Class D amplifier has integrated input coupling capacitors that provide optimized voltage-independence and matching. Linearity promotes system PSRR and performance at low frequencies, while noise floor level and click-and-pop suppression techniques enhance sound quality.

Microsemi    Irvine, CA 92614
Jan 20, 2012 Targeting telecom equipment manufacturers, Models ZL30153 and ZL30154 allow transmission of SyncE over Optical Transport Network (OTN) channels without need for additional rate conversion PLLs. Model ZL30154 provides 2 independent digital PLLs for applications that require independent transmit and receive timing paths, while Model ZL30153 uses single digital PLL for clock synchronization. Programmable digital PLLs in both devices synchronize to any clock rate from 1 Hz to 750 MHz.

ZMDI    Dresden 01109  Germany
Jan 20, 2012 Designed for calibrated resistive sensor modules, Model ZSSC3016 combines amplification, 16-bit A/D conversion, and 18-bit DSP for linearization and calibration functions. Unit operates from 1.8-3.6 V with overall current consumption of less than 1 mA, standby current of less than 250 nA, and intelligent power save scheme. Designed for altimeter module applications, Model ZSSC3016 is suited for use in mobile phones, sport watches, or outdoor GPS tracking systems.

Pentek Inc.    Upper Saddle River, NJ 07458
Jan 19, 2012 Based on Xilinx Virtex-7 FPGA, Onyx(TM) Model 71760 provides 4 GB DDR3 memory at 1,600 MHz. Four-channel, 16-bit, 200 MHz A/D module includes external sample clock synchronization and VITA 42.0 XMC-compatible switched fabric interface. Native Gen 3 PCIe interface delivers peak speeds up to 8 GBps, while FPGA comes pre-configured with built-in functions for data capture, synchronization, tagging, and formatting.

Alligator Technologies    Costa Mesa, CA 92627
Jan 19, 2012 As single-channel, programmable signal conditioning instrumentation amplifier and band pass filter, USB-controllable USBPBP-S1(TM) comes in range of filter characteristics. Intelligence is built in to configure module from power-up and operate independently in Turn-Key or host computer controlled scenario. Compatible with 12, 16, or 24-bit A/D devices, module lets user mix and match filter characteristics and independently select and program high/low pass corner frequency and gain steps.

Allegro MicroSystems Inc.    Worcester, MA 01615
Jan 19, 2012 Featuring ambient temperature range of 40-150°C, customer-programmable Model A1357 converts analog signal from internal Hall sensor element to digitally encoded PWM output signal. Duty cycle of PWM output signal is proportional to applied magnetic field. BiCMOS, monolithic circuit inside A1357 integrates Hall element, precision temperature-compensating circuitry, high-gain amplifier, dynamic offset cancellation circuits, and PWM conversion circuitry.

Stackpole Electronics Inc.    Raleigh, NC 27604
Jan 18, 2012 Supplied in ceramic housing, 2 W LCBF2 is flameproof, wirewound resistor. CBF and LCBF2 resistors also provide housings with standoffs to help reduce temperatures seen by PCB. Welded wirewound resistive element is available in values from 0.05-0.33 ohms in 5% tolerance, and products are suited for current sensing applications such as switching power supplies, protection for TVs, displays, and monitors; displays for white goods; and motor controls.

Automation Systems Interconnect Inc.    Mechanicsburg, PA 17055
Jan 18, 2012 Manufactured with nickel-plated copper alloy body and UL94V-0 polyamide insulating body, CBD Series operates from -40 to +80°C. Units are available in 8 sizes with max current acceptance up to 250 A. Screw connection on both sides is indirect and anti-loosening. With CBD Series, users can create sliding link between 2 adjoining terminal blocks, create multiple commoning bar connection between several adjoining terminal blocks, or insert socket for test plug and labeling accessories.

OmniVision Technologies, Inc.    Sunnyvale, CA 94089
Jan 18, 2012 Using OmniBSI+ pixel architecture and second-generation backside illumination (BSI(TM)) technology, 1/3.2 in. OV8825 CameraChip(TM) sensor suits smartphone/tablet manufacturers upgrading camera designs. Sensor operates at 24 fps in full resolution and in full HD video mode at 30 or 60 fps and can capture images and video in bright and low-light conditions. Additional features include 4-lane MIPI interface, scaler with electronic image stabilization, and 2 x 2 binning functionality.

Texas Instruments, Inc. (TI)    Dallas, TX 75243-4136
Jan 18, 2012 Featuring dual independent inputs, Series bq2416x allows operation from USB port or higher power input supply such as AC adapter or wireless power input. Integrated FETs support charge rates up to 2.5 A from IN input and 1.5 A from USB input. With 20 V input and 10.5 V over voltage protection, single-cell Li-Ion battery chargers support unregulated adapters and poor USB sources. Integrated power path allows system startup from deeply discharged or no battery power conditions.