Edmund Optics    Barrington, NJ 08007
Feb 23, 2012 Available in 40+ wavelengths and 12.5, 25, or 50 mm dia, TECHSPEC® Fluorescence Bandpass Filters are designed to match emission and excitation bands for fluorophores, including DAPI, Cy5, FITC, SpectrumGreen, ICG-A, QDots, and more, in fluorescence imaging applications. Products feature greater than 93% transmission and greater than OD6 blocking outside desired passband, less than 3% from edge of bandwidth, to ensure detection of weak signals.

Edmund Optics    Barrington, NJ 08007
Feb 23, 2012 Available in more than 40 wavelengths and 3 diameters of 12.5, 25, and 50 mm, TECHSPEC® Fluorescence Bandpass Filters are matched to fluorophores used in fluorescence imaging applications. Units feature greater than 93% transmission and greater than OD6 blocking outside desired passband, with less than 3% from edge of bandwidth to ensure detection of weak signals. Each is manufactured with hard sputtered coating on single fused silica substrate and mounted in black anodized ring.

TE Connectivity Ltd.    Berwyn, PA 19312
Feb 22, 2012 Designed to minimize crosstalk, Z-PACK HM-Zd Plus offers density of up to 40 differential pairs per linear inch. Connector is available in 2, 3, and 4 pairs per column - fitting 20.32 mm slot-pitch for 2- and 3-pair versions and 25.4 mm slot-pitch for 4-pair version. With integrated pre-alignment features and polarization built into mating interface, connector is suited for hubs, routers, switches, servers, test and measurement equipment, and medical diagnostic equipment.

Greenray Industries Inc.    Mechanicsburg, PA 17055
Feb 22, 2012 Supplied in 5 x 7 mm ceramic package, T72 Series offers stability to ±0.2 ppm from -40 to +85°C, g-sensitivity of less than 1 x 109, phase noise floor of 159 dBc/Hz, and current consumption down to 1 mA typ. TCXO, available from 10-50 MHz, offers clipped sine wave output and 3.3 V supply range. Electronic frequency control is provided for tuning or phase locking applications. Unaffected by vibration and temperature fluctuations, product suits exploration and tracking equipment applications.

Renesas Technology America, Inc.    San Jose, CA 95134-1368
Feb 22, 2012 Based on Mobile modem with multi-mode FDD and TDD-LTE Category 4 capabilities, 1.5 GHz Model MP5232 enables OEMs to accelerate creation and delivery of high volume LTE/HSPA+ capable smartphones, tablets, and mobile Internet devices. Application processor provides multi-core computing power with optimized graphics, video, and imaging capabilities. Delivered fully tested and certified, chip also includes advanced RF transceivers, power management, and audio solutions.

Chelsio Communications    Sunnyvale, CA 94085
Feb 22, 2012 Based on T4 ASIC, B420-SR dual-port 10 GbE card with PCIe 2.0 host bus interface and B404-BT quad-port 1 GbE adapter with PCIe 2.0 interface are designed for WAN optimization, load balancing, business continuity, and wire analytics applications. Adapters fully offload key functions - TCP/IP, traffic management, packet analysis, and filtering - onto T4 ASIC, relieving CPU of network traffic while driving performance increases. Cards also perform inline wire-speed sniffing, tracing, and time-stamping.

Berkeley Nucleonics Corp.    San Rafael, CA 94901
Feb 22, 2012 Enabling users to step delays in tiny increments, Model 745 is designed for ultra-short, precise time control applications where users need to synchronize events to trigger or to each other. This 4-channel unit achieves 5 psec jitter with 250 fsec delay and pulse width control and also offers option of browser-based controls. For timing applications requiring up to 64 channels of precision gating, timing, syncing, or delaying, included software provides single interface for all channels.

Phoenix Contact    Harrisburg, PA 17111 0100
Feb 21, 2012 Available for RBO 5/RSC 5 modular feed-through terminals, Carrier 35-13 Kit and Carrier F-13 Kit provide short circuit capability for current transformer applications. Carrier 35-13 supports DIN rail-mounted terminals, while Carrier F-13 suits panel-mounted terminals. Both include 4 shorting screws, 1 bridging bar, 4 isolators, and 1 carrier to hold 4 screws when not in use. Offered in 9 and 13 mm pitches, RSC/RBO terminals are rated 600 V and either 30 or 45 A.

Vishay Intertechnology, Inc.    Malvern, PA 19355 2143
Feb 20, 2012 Housed in 2906 package, Power Metal Strip® WSMS2906 features proprietary processing technique that produces extremely low resistance values from 300-600 µW, optimizing accuracy in current meter shunt applications. Inductance values are less than 5 nH and thermal EMF is less than 3 µV/°C. With 5.0% tolerance, RoHS-compliant resistor provides power companies with accurate data to determine customer usage and to adjust billing terms.

Mini-Circuits    Brooklyn, NY 11235
Feb 20, 2012 Operating from 3-5 Vdc supply, surface mount Model PSA4-5043+ provides IP3 as high as 33 dBm, output power levels up to +21 dBm, and on-die ESD protection rated to over 500 V, making device suited for wide range of 50 MHz to 4 GHz applications. MAC Ceramic Hermetic Mixers, covering frequency range from 0.3-12 GHz, feature LO levels from 4-17 dBm. Devices deliver broadband performance suitable for instrumentation, with case that meets/exceeds aerospace and military ground requirements.

Agilent Technologies, Inc.    Santa Clara, CA 95051
Feb 20, 2012 Supporting creation of signal scenarios using 5-7 GHz spectrum, M8190A simultaneously delivers wide bandwidth and high resolution with up to 80 dBc of spurious-free dynamic range. Capabilities such as switching between 14-bit output at 8 GSPS and 12-bit output at 12 GSPS help engineers handle multiple applications and measurement requirements. Along with support for output formats such as NRZ, DNRZ, RZ, and doublet mode, generator features 3 amps optimized for different applications.

STMicroelectronics    Lexington, MA 02421
Feb 17, 2012 Producing brightness equivalent to outdoor security floodlight, Model STCF04 offers 8 user-selectable levels for flash, 12 levels for torch, and light-sensor input. Device incorporates flash and torch safety timers, temperature sensing, and short circuit protection features. Combining supercapacitor, discrete high-current MOSFET switch, and high-power LEDs in 3 x 3 mm TFBGA package, IC is suited for emergency high-intensity flashing lights as well as camera and cameraphone applications.

Texas Instruments Inc. / Tiris Division    Dallas, TX 75243
Feb 17, 2012 WiLink(TM) 8.0 product family is collection of 45 nm single-chip wireless connectivity solutions that integrate up to 5 different radios. Each chip variant comes in compact WSP package that can be mounted directly on PCB, and includes all required RF front ends, complete power management system, and comprehensive coexistence mechanisms. Product includes integrated RF front ends for both 2.4 GHz and 5 GHz capable of reaching more than 100 Mb/sec Wi-Fi TCP throughput.

Anadigics, Inc.    Warren, NJ 07059
Feb 17, 2012 Supplied in 7 x 7 x 1.3 mm package, AWB7128 and AWB7228 are optimized for WCDMA, HSPA, and LTE small-cell base stations operating in 2,620-2,690 MHz frequency band. Both power amplifiers use InGaP-Plus(TM) technology and offer linearity of -47 dBc ACPR @ ±10 MHz offset. Respectively, AWB7128 and AWB7228 are performance-optimized for ¼ and ½ W linear power applications and offer +24.5 and +27 dBm linear output power, 16% and 14% efficiency, and 28 and 27 dB gain.

Ironwood Electronics, Inc.    St. Paul, MN 55121
Feb 16, 2012 Designed for 7 x 7 mm package size, Model DG-QFN56B-01 operates at bandwidths up to 40 GHz with less than 1 dB of insertion loss. Socket is constructed with shoulder screw, swivel lid, and diamond particle interconnect contactor capable of 100,000 insertions. Mounted on target PCB with no soldering, device operates from -70 to +200°C and dissipates 12 W with lid mounted heat sink and fan. Contact resistance is typically 3 mW per pin.

Oberon, Inc    State College, PA 16801
Feb 16, 2012 Measuring 12 x 12 in., Model 1041-00 consists of concealed spline ceiling tile designed specifically to secure Cisco 1140, 1260, 3500, and 3600 series wireless access points. Powder-coated steel enclosure installs into ceiling runners like standard concealed spline tile. Securely flush to ceiling, access point provides unobstructed wireless coverage and aesthetic installation.

Dialight Corp.    Farmingdale, NJ 07727
Feb 16, 2012 Designed for both indoor and outdoor industrial lighting applications, 17,000-lumen, 170 W DuroSite® LED High Bay luminaire provides instant-on capability that allows units to be paired with an occupancy sensor and/or dimmable components. Units operate on an integrated universal power supply at 100-277 Vac, and are designed for change out from HID light sources, such as metal halide and high pressure sodium. Product is IP66 certified for use in outdoor and washdown locations.

Atmel Corporation    San Jose, CA 95131
Feb 16, 2012 With internal lighting timing algorithms, MSL2164 and MSL2166 eliminate 3D ghosting and flickering effects on LCD TVs. Drivers work with Atmel AVR® MCUs, which process timing and dimming instructions. Able to drive up to 16 parallel strings of LEDs, products incorporate power management and backlight control along with multiple dimming modes for 3D, scanning, and zone dimming edge-lit LCD TVs. Multiple PWM modes reduce design complexity.

STMicroelectronics    Lexington, MA 02421
Feb 15, 2012 Designed to meet AEC-Q100 specification, 3-axis Model A3G4250D measures angular rates up to ±250 degrees/sec, optimizing dead-reckoning and/or map-matching capabilities in car navigation and telematics applications. On-chip IC interface converts angular-motion data into 16-bit digital bit stream that is transmitted to dedicated microcontroller chip through SPI or I2C protocol. Operating from 3 V single supply, device provides 2 output lines and 4 user-selectable output data rates.

Microsemi    Irvine, CA 92614
Feb 15, 2012 Available in ceramic QFP package, RT ProASIC®3 FPGAs offer reprogrammable, non-volatile logic integration solution for space-flight hardware designers. Devices are based on secure flash technology that provides immunity against radiation-induced configuration upsets. Intended for applications requiring up to 350 MHz operation and up to 3 million system gates, FPGAs operate at core voltage between 1.2 V for low-power applications and 1.5 V for performance-driven designs.