AutomationDirect.com
Cumming, GA 30040-9905
Jul 03, 2009 ZIPport(TM) panel interface connectors mount on outside of electrical control panel boxes and act as pass-through connections, allowing operator to interface with PLCs and other programmable devices without opening control box. Units include standard reset 3 A circuit breaker and are available with single/duplex/GFCI power outlets as well as no-power option. Designed for frame sizes 6-48, communications connectors available include D-sub, RJ45, RJ12, USB, Ethernet, and Data Highway.

Neutrik
Lakewood, NJ 08701
Jul 02, 2009 Dust and water protected, IP67 rated XX-HD Series includes 3-pole female XLR connector (NC3FXX-HD-D) with optional black housing (NC3FXX-HD-B-D) as well as 3-pole male XLR connector (NC3MXX-HD-D) with optional black housing (NC3MXX-HD-B-D). Rubber sealing jacket protects against mechanical shock, while chuck type strain relief system helps in secure clamping of cables. Product features rugged zinc die cast shell and gold contacts.

ITT Corporation
White Plains, NY 10604
Jun 30, 2009 Designed for low-pressure water immersion or fording applications, KJAYA Series provides hermetic sealing of 0.01 micron cu-ft/hr for pressure differentials of 15 psi. It is available in sizes 9-25 in wall and jam-nut mounting receptacles and is water immersion sealed to 10^-7 cm³/sec. Meeting all MIL-STD-810 and IP67 water immersion requirements, connector is suited for variety of applications including integrated avionics, radar, electronic warfare systems.

Cobra Cable Tie Co
Ashland, MA 01721
Jun 30, 2009 Low Profile Cable Ties feature low head height and, when cut, stub is concealed within head to create smooth, snag-proof outer surface that conforms to bundle. They are available in UV-resistant black and natural nylon, and can be installed using industry standard tools. UL/CSA listed, QPL approved, ties come in 7-16 in. sizes in medium and heavy duty styles, and are suited for wire harnesses and bundling of tubing and hoses.

Corning Cable Systems
Hickory, NC 28603-0489
Jun 29, 2009 Designed for data centers, high-density LANscape® Pretium® Evolved-Density, Growth-Enabled (EDGE) solutions feature preterminated multi-fiber assemblies, or trunks, with minimum bend radius as small as 5 times OD of cable. Cable can be tightly routed around corners and bends, and extra slack can be coiled without causing attenuation. Interconnect cables offer bend radius of up to 8 times OD, while housings are available in 1U and 4U sizes and mount in 19 in. racks or cabinets.

Binder-USA, LP
Camarillo, CA 93012
Jun 26, 2009 Used with power supply networks, Series 820 threaded-locking feed-through connector connects male and female cable connectors between cabinet and industrial environments. It is available with 5 gold-plated contacts and has rated current of up to 8 A per contact. Each connector is constructed with nickel-plated brass housing and M25x1.5 fixing thread. Unit is IP67-rated protecting from ingress of debris and liquids.

Siemon Co., The
Watertown, CT 06795
Jun 26, 2009 Available in both UTP and shielded configurations, 6 A Z-MAX Patch Cords feature RJ-45 Smart-Plug design, which integrates PCB into every plug, offering signal tuning capabilities. Zero-Cross(TM) termination method eliminates split pair, pair-crossing, and pair untwisting. To maintain pair twist to point of contact, cable conductors are terminated to IDC contacts at rear of plug. Double-ended stranded patch cords and single and double-ended solid cords are available.

Wireworks Corp.
Hillside, NJ 07205
Jun 25, 2009 Simplifying set up by eliminating need to make individual connections directly to equipment and wall panels, AV2000 multi-pin connector system can accommodate audio, high definition video, data over Cat6 cabling, and control signals in single sophisticated hybrid connector. System utilizes 3 components; access point, umbilical and link, and can be integrated into any existing AV system. Applications include multi-media presentation rooms, corporate board rooms, and classrooms.

ITT Interconnect Solutions
Santa Ana, CA 92705
Jun 25, 2009 Offering contact counts of 1-600, Chip-on-Flex (CoF) connectors are available in rack and panel, circular and D-subminiature configurations. Filter design features one standard flex per layout and utilizes flexible circuit internal to connector, with chip capacitors surface-mounted on small pad adjacent to feed-thru contact. Tested to MIL-DTL-38999 Series III mechanical shock, vibration, and high altitude DWV specifications, connectors exceed 1,000 cycles of thermal shock per MIL-STD-1344.

Channellock, Inc.
Meadville, PA 16335-0519
Jun 24, 2009 Featuring narrow jaw that fits into tight spaces, No. 89 rescue tool has hardened cutting edge designed to shear through soft metal and standard battery cables. It also features gas shut-off valve slot, tapered pry wedge to open doors and windows, and spanner wrench that tightens and loosens up to 6 in. hose couplings. Lightweight tool also has window punch that can shatter safety glass.

General Machine Products Co.
Trevose, PA 19053
Jun 23, 2009 Used to install telecommunication cables over extended distances, Sidewinder can be used as end-puller or placed at mid-point. Trailer-mounted unit employs one 32 in. dia capstan to provide controlled force to pulling of rope or tape. Take-up drum, driven independently by hydraulic motor, has detachable side to facilitate rope/tape removal and can be declutched from drive. Adjustable from 0-1,100 lb, pulling tension is displayed on dial gauge, and max pulling speed is 200 fpm.

Torrent, Inc
Needham, MA 02492
Jun 23, 2009 Available in Select, Advanced, and Elite models, SureConnect(TM) HDMI-certified cables incorporate MagLoc(TM) feature for maximizing connection strength. VeriFYI® LED indicator confirms proper signal transmission, while AmpliFire(TM) optimizes signal with equalization process based on low-power processor built into cables. Featuring documented compliance with HDMI 1.3C specification, units include 5-layer shielding that maximizes protection from EMI/RFI.

Alltec Corporation
Canton, NC 28716
Jun 23, 2009 Utilizing Point Discharge Principle, TerraStat® Charge Dissipation Terminals minimize accumulation and concentration of electrical charge which causes upward streamers to generate. By rapidly dissipating ions from thousands of sharp metal points, terminals delay formation of upward streamers critical to completion of lightning stroke. Made of stainless steel, corrosion-resistant terminals come in standard and medium risk protection models as well as vertically and horizontally mounted units.

Neutrik
Lakewood, NJ 08701
Jun 22, 2009 Providing optional screen to chassis grounding and sealing gasket for lockable and watertight digital interface connection, HDMI 1.3 feedthrough connector models NAHDMI-W and NAHDMI-W-B are suited to transmit any digital TV and PC video format including HDTV. Universal D-Shaped chassis connectors are available with either nickel or black housing.

Automation EZ LLC
Tucson, AZ 85741
Jun 22, 2009 Designed to accommodate in-process quality checks, Battery Assembly Cell is available as Complete Assembly Cell or as Individual Automated Semi-Automated battery assembly substations. Line consists of automatic tab welding machine; cell winding machine; jelly roll insert-bottom, tab weld, seam former; electrolyte fill, cap, weld cell closer; cell label shrink wrap; and cell pressure/leak tester. All tension controls, number and placement of tabs, and web speeds can be adjusted from touch screen.

San-Tron, Inc.
Ipswich, MA 01938
Jun 19, 2009 Featuring single piece body construction, UG-58 A/U Type N panel receptacle are rated for operating voltages of 1,000 Vrms and have maximum dielectric withstanding voltage of 2,500 Vrms at 60 Hz at sea level. They have nominal impedance of 50 W, operating temperature range between -65°C and +165°C, and meet interface standards in accordance with MIL-STD-348.

Wireworks Corp.
Hillside, NJ 07205
Jun 18, 2009 Adaptable BG Unisex XLR Cords match up MusiLUX microphone cable or AES/EBU digital cable with convertCON 3-pin connectors that feature sliding housing to convert between male and female connector. Used in microphone and line level applications, units allow users to connect variety of gear without need to consider XLR connector gender. They are available in convertCON to convertCON, convertCON to XLR3 male, convertCON to XLR3 female, and convertCON to ¼ in. TRS configurations.

San-Tron, Inc.
Ipswich, MA 01938
Jun 18, 2009 Manufactured with counterbore joining technique, UG-28A/U and UG-107B/U have max dielectric withstanding voltage of 2,500 Vrms at 60 Hz at sea level. Available in both male and female versions, T's are designed for temperature range of -65 to +165°C and meet interface standards in accordance with MIL-STD-348. Adapters are manufactured with PTFE dielectric material and feature gold and silver center contacts. They are also available in albaloy, nickel, and silver body finishes.

Y-Connect, Inc.
Middletown, PA 17057
Jun 17, 2009 Duplex and Quad LC Adapters include modularized multiport dust shutter providing dust as well as eye protection for Class III A and lower lasers. Units offer secure panel mount latching and are compatible with T.I.A. FOCIS 10B duplex and quad panel cutouts, allowing users to double connection densities using existing simplex or duplex SC adapter panel cutouts, respectively. Available in MM, SM, and APC, products meet UL 94 V-0 flammability requirements and are RoHS compliant.

RTX Telecom A/S
Noerresundby 9400  Denmark
Jun 17, 2009 Based on SiTel chipsets SC14450 and LMX4180, DECT/CAT-iq 2.0 USB dongle supports CAT-iq 1.0/2.0 features, 4 audio lines via USB interface, DECT 6.0, and firmware updates via USB as well as utilizes existing Windows/Linux drivers. Unit enables developers to add cordless telephony to VoIP-enabled broadband gateways, IP PBXs for SMB applications, wired IP telephones, set-top boxes, and PCs. Included SDK simplifies host integration of dongle support.