Phihong USA
Fremont, CA 94539
Sep 30, 2008 Model POE60U-560G 60 W midspan can power wireless access point arrays and thin client computer terminals that require up to 52 W of low voltage dc power. Available in non-vented case with 10BASE-T, 100BASE-T, and 1000BASE-T data rates and UNH IOL test report, Model POE45-120 is 45 W dc-dc gigabit-compatible splitter that divides power and data and converts from PoE source to regulated low voltage dc power source that can be mounted adjacent to any Ethernet device.

American Power Conversion
West Kingston, RI 02892
Sep 29, 2008 Fuel Cell Extended Run (FCXR) product provides hydrogen-based backup power for InfraStruXure® data center solution, which fully integrates power, cooling, environmental monitoring, and management in rack-optimized design. Using air and stored hydrogen, FCXR product delivers emission-free electrical backup power and scales onsite with 1-3, 10 kW modules contained in one 19 in. rack. It uses Hydrogenics' HyPM XR Fuel Cell Power Modules and supports 3-Phase Symmetra PX product line.

American Power Conversion
West Kingston, RI 02892
Sep 29, 2008 Designed to protect valuable electronics, such as plasma and LCD TVs from surges, spikes, and blackouts to optimize performance of connected equipment in pro installation, APC AV G5 Rack Power Filter features 8 surge-protected outlets, 6 for digital devices and 2 for high current, to aid in noise filtering through isolated noise filter banks. With Let-Through voltage rating of less than 40 V, unit has LCD, delayed turn on/off (4 banks), and ability for rack or shelf installation.

American Power Conversion
West Kingston, RI 02892
Sep 29, 2008 RoHS compliant Back-UPS® 350, 450, 550, 650, and 750 uninterruptible power supplies provide 200-450 W of power to back up variety of home computer system configurations depending on load. Models 450, 550, and 650 feature 8 outlets, while Models 750 and 350 offer 10 (master and controlled) and 6 outlets, respectively. Back-UPS ES 650 and 750 offer coax and telephone or Ethernet protection, ensuring surges and spikes do not travel through data lines.

Tyco Electronics Corp.
Harrisburg, PA 17105-3608
Sep 29, 2008 Featuring slide-in mounting style, CORCOM SRB Series of power line filters provide quick mounting in panel openings, reducing need for additional mounting hardware. UL recognized and CSA certified units are rated up to 15 A at 250 Vac, 50/60 Hz. Load termination is provided using wire leads to keep mounting depth to minimum. They are suited for unfiltered or filtered applications, and are VDE approved for 10 A at 250 V.

Schneider Electric
Palatine, IL 60067-7399
Sep 29, 2008 Designed for custom home theater installations, APC AV In-Wall Power Filter and Connection Kit works in conjunction with APC AV power protection solutions to protect remote wall-mounted televisions and ceiling-mounted projector. Kit comes with input and output receptacle boxes, 8 ft output power cord, and 2 ft input power cord for TV/projector. It lets installers offer critical protection to displays in remote locations from surges, spikes, or even blackouts.

austriamicrosystems AG
Premstatten   Austria
Sep 26, 2008 Suited for battery-driven OLED or LCD displays, Model AS1343 delivers 40 mA at 24 V from two AA cells or 30 mA at 12 V from single AA cell. Unit operates from single 0.9-3.6 V supply and can provide adjustable output voltages from 5.5-42 V. Housed in 3 x 3 x 0.8 mm TDFN 10-pin package, converter offers automatic power save operation, 1 MHz fixed switching frequency, 2% output voltage accuracy, and micro-power design that reduces operating supply current to 22 µA.

Rittal Corporation
Springfield, OH 45504
Sep 26, 2008 Comprised of up to 250 RiBat modules joined using pre-assembled cable and connected to RiBat Manager, RiBat system extends UPS battery life up to 30% to promote IT system security and availability. RiBat Manager collects, evaluates, and uses all relevant data over service life of monitored battery to control charging process, while RiBat modules control charging process for each battery connected using technology that prevents overcharging.

UltraVolt Inc.
Ronkonkoma, NY 11779
Sep 26, 2008 Available with PPM-level temperature coefficient, ripple, regulation, and stability, MMS-EB Series provides all power sources needed to operate industry-standard precision electron guns. Products are configurable as 3-, 4-, or 5-bias electron gun high-voltage power supplies for beam, filament, extractor, suppressor, and lens voltages. They utilize HVPS modules and accessories from 0-62 Vdc to 40 kVdc at 0-4 W to 30 W. Convection cooled design permits mounting within 24 in. of E-beam.

Advanced Analogic Technologies Inc.
Sunnyvale, CA 94085
Sep 25, 2008 Integrating 1.7 A and 800 mA buck converters, Model AAT2789 consolidates power management functions for WLAN products, GPS devices, smart phones, and other handheld devices. Two-channel synchronous step-down converter operates from 2.7-5.5 V, making it suited for portable systems powered from single-cell Li-Ion battery or consumer equipment using 3.3 or 5 V bus. Housed in 3 x 4 mm TDFN package, converter includes soft start as well as over-temperature and current limit protection circuits.

XP Power
Littleton, MA 01460
Sep 25, 2008 Including 5 models that provide output voltages of 12, 15, 18, 24, or 28 Vdc, MCM Series rugged, convection cooled 60 W power supplies offer input voltage range of 90-264 Vac or 120-370 Vdc. Available in metal case sealed against dust and water, units operate at full output power between -40 to +50°C and derate linearly to 50% load at 70°C. They comply with UL60950-1 and EN60950-1 safety approvals. Measuring 5.5 x 2.75 x 1.48 in., they have 5 pin DIN plug standard output connector.

Automation Systems Interconnect Inc.
Mechanicsburg, PA 17055
Sep 24, 2008 Controlled by voltage threshold, CSF Series power supplies are equipped with output voltage alarm contact that indicates when voltage drops under 90% of rated value. With 90-264 Vac or 100-370 Vdc input rated voltage range, units are available in 1-20 A versions at 24 Vdc with adjustable range of 23-27.5 and 12-15 Vdc, or at 48 Vdc with adjustable range of 45-55 Vdc. Measuring 1.53 in. wide, DIN-rail mounted supplies have green and red LED status display indicators.

Micrel Inc.
San Jose, CA 95131
Sep 24, 2008 Operating at 2 MHz, MIC4724 non-synchronous PWM buck regulator addresses need for higher operating/transient voltage for 5 V bus while minimizing footprint requirements. Internal compensation allows for accelerated transient response and use of small LC components. Integrated p-channel MOSFET enables chip to deliver up to 3 A, where designers can realize over 94% efficiency, and also eliminates need for sense resistor to provide current limit. Output voltage is adjustable down to 1 V.

Sola/Hevi-Duty, EGS Electrical Group
Rosemont, IL 60018
Sep 24, 2008 SCP-X power supplies feature 24 Vdc output that meets Class 2 requirements for limited power. Supplies are sealed in metal case and mini-change connectors simplify connectivity for distributed I/O devices. SCP100S24X-CP for use in physical layer of Ethernet/IP control power applications where power supply output is connected to ground, while SCP100S24X-DVN can be used in physical layer of DeviceNet(TM) applications where power supply output is isolated from ground.

AMETEK Prestolite Power & Switch
Troy, OH 45373
Sep 23, 2008 Utilizing MOSFET high-frequency power conversion circuitry, Prestolite Advanced Charger Eclipse Series recharges any 100% discharged lead-acid battery, flooded or sealed, as well as NiCad batteries. Series adapts to variety of charging requirements, including opportunity charging and multiple battery types with 3 equalize options, delayed start, and time of day block-out periods. With microprocessor control, chargers allow battery to determine charge cycle rate based on state of discharge.

American Superconductor
Westborough, MA 01581
Sep 23, 2008 Able to be customized for various electrical applications, PowerModule(TM) PM3000W is designed for integration into wind turbines rated from 750 kW to 6 MW. Integral algorithms and external communication protocols enable universal generator connectivity, while construction withstands changes in climate and power grid conditions. Programmable, flexible, and modular, solution utilizes thermally and mechanically enhanced IGBTs, wind power-specific controls and interfaces, and LVRT support.

Pacific Aerospace & Electronic
Wenatchee, WA 98801
Sep 22, 2008 Flex Lead filters promote system reliability with design eliminates possibility of solder joint fatigue. Lead insulation is encapsulated inside filter body, reducing potential for accidental shorting. Rated for 50-500 Vdc, completely encapsulated products have 1,000 pF to 20 nF capacitance range, 100 GW min insulation resistance at 25°C, and -55 to +125°C operating temperature range. Filters meet requirements of MIL-F-15733 and MIL-F-28861 specifications.

Astrodyne Corp.
Mansfield, MA 02048
Sep 19, 2008 Available in single and dual outputs from 3.3-15 Vdc, FED20W Series accepts inputs from 9-75 Vdc and provides output power of 20 W. All models contain short circuit protection, over-voltage protection, and On/Off control function. Internal input filter eliminates need for addition of external components. Providing 1,600 V input-to-output isolation, converters operate over temperature range of -40 to +75°C without forced cooling or output power derating.

Toshiba America Electronic Components (TAEC)
Irvine, CA 92618-1811
Sep 18, 2008 Supplied in 2.9 x 2.8 x 0.8 mm package, TB7102AF/TB7101AF ICs accept 2.7-5.5 V input, offer 1 A max output current, and exhibit 95% typ efficiency. Adjustable output voltage from 0.8-1 V typ is available in TB7102AF, while fixed output voltage is offered by TB7101AF. Intended for use as step-down converters in electronic devices, monolithic ICs integrate high- and low-side MOSFETs, PWM controller, and MOSFET driver. Low enable threshold voltage is 1.5 V.

Murata Power Solutions, Inc.
Mansfield, MA 02048
Sep 17, 2008 Single-output HPH and UCH series, isolated to 2,250 Vdc, come in 61 x 58.4 x 10.2 mm package with open-frame construction. Utilizing full-bridge, fixed-frequency topology along with synchronous output rectification, HPH series offers fully regulated 3.3-12 Vdc output from 36-75 Vdc input and reaches up to 91% efficiency. Offered with 2.5-15 Vdc outputs and 36-75 Vdc or 18-36 Vdc input voltages, UCH series has semi-synchronous rectifier design and 92% optimal efficiency.