Meter-Treater Inc.    Lake Park, FL 33403
Dec 14, 2004 Series SST provides protection against any transient voltage that exceeds nominal signaling voltage. Each line is protected against surge current impulses up to 10 kA. Units are configured to work in series or parallel with measurement/control lines being protected, diverting harmful transient energies while maintaining tight clamp at peak voltage. Suppressors protect 1 circuit consisting of 2 wires plus ground.

Astris Energi Inc.    mississauga L5L1X2  Canada
Dec 14, 2004 Model E7 AFC Generator is built with two 900 W POWERSTACK MC250 alkaline fuel cell stacks, which give unit 1.8 kW nominal power rating with ability for max power output to reach 2.15 kW. Ability to overload generator by 20% provides power for peak loads during acceleration and hill climbing, and fuel cells keep voltage supply at constant level. Silent-running, emission-free generator replaces traction batteries used in mobile applications.

Heyco Products    Toms River, NJ 08753
Dec 13, 2004 Available in sizes from ¼â€“2 in. diameter, FPAS Corrugated Nylon Conduit and Tubing offers flexible wire protection. Smooth interior ensures free movement of all wires completely through. Damage-resistant, corrugated exterior allows tubing to withstand abrasions and lubricating fluids while it fits around tight bends and corners without deformation or fatigue. Suited for all environments, high-impact, crush-resistant nylon features temperature range of 40–248°F.

ITT Industries    Newton, MA 02458
Dec 13, 2004 Lead-Free Switches such as trackball navigation switch, and KMR, KMS, TPC, TPA, and KSU tact switches contain no cadmium, mercury, or other toxic substances, such as hexavalent chromium, polybrominated biphenyls, or polybrominated diphenyl ethers. With height of 6 mm, Elumâ„¢ illuminated pushbutton switches feature right angle actuator with integral LED, facilitating design of front panels for mode select, power on, reset, and notification functions.

CUI, Inc.    Beaverton, OR 97005
Dec 13, 2004 Series RCJ-01X-SMT is housed in metal body with insulator material made from PA66 high-temperature plastic, making units suitable for IR reflow mounting. Right-angle, surface mount connectors withstand potential of 500 Vrms 50/60 Hz applied between mutually-insulated metal parts for 1 minute. Insulation resistance is 100 Mohm, while contact resistance is 30 mohm max at 100 mA. Connectors operate within temperature range of -25 to 85°C.

Crescent/Stonco    Union, NJ 07083
Dec 13, 2004 Kaleidoshade®/Kaleidoscope vapor-tight luminaires provide ambient and accent lighting in dry or wet locations. UL and CUL listed products, suited for commercial environments, have bullet-shaped lighthead designs. Ceiling, pendant, sign, wall, and pole-mount versions are available, with or without matching vandal guards. Die-cast aluminum products can be specified with incandescent, LED, HID, and compact U-shaped screw-in fluorescent sources.

Caterpillar, Inc., Solar Turbines, Inc.    San Diego, CA 92186 5376
Dec 13, 2004 Cold-end-drive, single-shaft Taurusâ„¢ 65 generator suits cogeneration, combined cycle, and other power generation applications. Generator set is rated at 6000 kWe for continuous duty at ISO conditions. It features 13-stage axial compressor with 15:1 pressure ratio that produces air inlet flow of 19.4 kg/sec, and utilizes 3-stage turbine with shrouded stage-3 turbine blade. SoLoNOâ„¢ combustion system reduces formation of NOx and CO, eliminating post-combustion clean-up devices.

Electro Standards Laboratories    Cranston, RI 02921 3403
Dec 10, 2004 Watch Dog Automatic Fallback Switch, Model 4145, detects carrier presence signal on port A and if carrier is lost, automatically switches to port B. It maintains connection to port B until it detects carrier presence again on port A, then automatically returns to A position. User can override Automatic Fallback and operate Watch Dog as A/B switch. Optional Remote RS232 serial port allows off-site operator to monitor operation mode and switch position.

Phillips Industries    Santa Fe Springs, CA 90670
Dec 10, 2004 STA-DRY® Slim-7â„¢ provides users with molded, 7-way connection suited for any heavy-duty trailer. Molded connectors between modules have ribs and o-rings that keep moisture and contaminants from penetrating electrical system. Integral design enables harness to be threaded through trailer configurations with tight areas, eliminating potential for unintentional disconnect.

Eubanks Engineering Co.    Monrovia, CA 91016
Dec 10, 2004 Model 2940 Large Cable Stripper employs pneumatic drive that provides power for stripping cross-linked polyethylene, Teflon®, Nylon, and other wrapped or extruded insulation. Dual-port, 6-stage cutterhead provides up to 1,800 psi of force, and heavy-duty strip assemblies feature double-acting clamp cylinders. Unit uses die-type blades, is available with tooling for 2- and 3-stage stripping, and stores up to 1,000 programs.

Cherokee International, Inc.    Tustin, CA 92780
Dec 10, 2004 Suited for equipment with distributed power architecture, DPS2000 adheres to SSI guidelines. Rated at 2,000 W, 48 V unit features active current sharing, hot-swap capabilities, N+1 redundancy, and I2C interface. Power-factor corrected unit meets EMI Class B regulations, measures 12.80 x 2.74 x 4.86 in., and is upgradeable via flash memory. With full load efficiency of 87%, it delivers 1,000 W at low-line 110 Vac and protects against over-temperature conditions.

Delta Computer Systems, Inc.    Vancouver, WA 98682
Dec 10, 2004 Two-channel Model VC2124 enables electronic motion controllers to drive fluid-powered servo valves. It provides way to set full scale current to match valve requirements, limit max current, or set optimum working ranges while converting ±10 V inputs into current outputs. Bipolar outputs are switch-selectable in 10 mA increments up to ±100 mA on each of 2 channels. To aid in diagnostics and troubleshooting, 2 LED indicators are provided for each channel.

Siemens AG    Munich D-80333  Germany
Dec 09, 2004 Measuring 102 mm wide, Sitop power DC UPS delivers output current of 6, 15, or 40 A, depending on model. DIN rail module has battery management system that optimizes load of connected batteries and monitors their backup reserves, charge status, and aging. Messages and signals indicating operating states of module are output via isolated contacts or optional USB port, and selectable switch-off feature permits automatic warm restart of industrial PCs.

Sipex Corp.    Miliptas, CA 95035-1701
Dec 09, 2004 Operating at 2.4 MHz switching frequency, SP6685 provides 2 independently adjustable and bit selectable output current levels for flash and torch mode in camera applications. It requires 1 µF, 1 µF, and 4.7 µF external capacitors and delivers up to 92% efficiency. Provided with automatic soft-start mode, 1x/2x current regulated charge pump has feature that enables automatic transition from buck to boost mode based on battery input voltage.

VXI Technology Inc.    Irvine, CA 92614
Dec 08, 2004 Model SMP2012 is a 30 A, SPST unit that provides heavy-duty switching in high-density, modular package. It is suited for automating signal switching and testing of motors, ballasts, or high-power ac or dc signal devices. Series SMP2300 consists of 500 V SPST coaxial switches with 50 or 93 ohm impedance. They provide high voltage switching capabilities while matching characteristic impedance of signals under test with controlled impedance of switch.

Waytek Inc.    Chanhassen, MN 55317
Dec 08, 2004 Mid-range circuit breakers come in panel mount design as automatic reset or switchable with manual trip feature to allow opening of circuit path without disconnection from power source. Single pole thermal type breakers are rated up to 30 Vdc max, and 10-32 stud terminals and nuts are included. Uses include marine, agriculture, construction, RV, chassis, and specialized equipment applications.

Linear Technology Corp.    Milpitas, CA 95035
Dec 08, 2004 Housed in 3 x 4 x .75 mm, 12-lead DFN package, LTC3216 fractional charge pump has multi-mode architecture that automatically switches between 1X, 1.5X, or 2X boost modes. White LED driver has 900 kHz switching frequency and built-in soft-start circuitry. Independent high and low current settings for flash and torch/video modes are programmed by 2 external resistors, and shutdown mode and current output levels are selected via 2 logic inputs.

Foster Transformer Co.    Cincinnati, OH 45223 2571
Dec 08, 2004 Available with mounting options to meet any design parameter, transformers include UL Recognized Class 130 (B) insulation and optional ¼ in. quick connect terminals to keep high current off printed circuit board. Standard models feature 1:500 turns ratio and handle rated currents from 0.1–30.0 A. With operating frequency range of 50–400 Hz, products are suited for use in UPS systems and other applications where isolated current monitoring is desirable.

LEDtronics, Inc.    Torrance, CA 90505
Dec 08, 2004 Single Contact Series B618/619 and Double-Contact Series DB618/619 are 15 mm bayonet-based 18- and 19-LED Lamps for replacement of No. 310 and 312 incandescent bulbs. Incorporating optical-grade epoxy, sunlight visible lamps offer emitting angles of 12-15° and 20-30°. Units come in 12-28 Vac or Vdc and draw between 1.0-1.7 W of power. Colors include green, white, blue, yellow and red. Infrared lamps are offered in wavelengths of 850, 880, and 940 nm.

AMETEK Prestolite Power & Switch    Troy, OH 45373
Dec 08, 2004 Equipped with micro-controller, interactive ULTRA Industrial Battery Chargers are designed around silicon-controlled rectifier power supply. With start rate of 16.3 A/100 AH, ULTRA CHARGER charges discharged batteries in 8 hr or less, while ULTRA MAXX Opportunity Charger has start rate of 25 A/100 AH and charges 20% charged batteries to 80% in 3 hr or less. ULTRA EXTREME features start rate of 40 A/100 AH and charges 20% charged batteries to 80% in 2 hr or less.