UltraVolt Inc.    Ronkonkoma, NY 11779
Dec 27, 2005 HV Rack® Series is configurable with up to 4 independent channels, each ranging from 0-62 V through 0-40 kV between 4 and 250 W. Users can configure 1-4 output channels to float any 0-4 W through 20 W, 0-15 kV or lower UltraVolt power supply. Series allows for power supply stacking or hot-deck configurations and features green-meter, visible in high-ambient-light conditions, that is suited for cleanroom and semiconductor processing applications.

GC Electronics    Rockford, IL 61102
Dec 27, 2005 Comprised of more than 75 models with input voltages of 4, 6, 12, and 24 V, GC Series is available with flame-retardant cases and in 6 different terminal types. Providing maintenance-free operation and deep discharge recovery, deep-cycle units are valve-regulated and non-spillable. Batteries are suited for UPS systems, fire and burglar alarms, power supplies, PLCs, emergency lighting, and communications equipment.

EAO Switch Corp.    Milford, CT 06460
Dec 27, 2005 With installation height of 2.0 mm above front panel, IP67-rated Series 84 switches feature lenses in anodized aluminum with illumination windows or plastic surrounds. Visibility is achieved through single or multi-chip LEDs in multiple color options. With max ratings of 42 V/100 mA, switches mount flush to panel via 22.5 mm hole and are suited for PLC level signals. Modular range consists of pushbuttons, indicators, and illuminated EN418-rated, tease-proof emergency stop switch.

LEVITON    Melville, NY 11747
Dec 23, 2005 Pilot light and lighted handle switches, offered in single-pole and 3-way versions, have serrated backwire clamp design that eliminates internal back wiring holes to facilitate installation. While pilot light switches illuminate when load is ON, lighted handle switches illuminate when load is OFF to serve as switch locator in darkened areas. Construction includes thermoplastic toggles and housings, silver-cadmium oxide contacts, and non-floating terminal screws.

Northwest Power Systems    Bend, OR 97701
Dec 23, 2005 Working with hydrogen-fueled ElectraGen(TM) backup power systems, Extended Run Module converts liquid fuel into pure hydrogen to provide power in event of grid failure. System replaces multiple hydrogen cylinders, eliminating need for hydrogen storage when onsite storage is not feasible. Designed for autonomous operation, 250 W portable iGen(TM) proton exchange membrane with on-board fuel reformer, generates power continuously as long as fuel is supplied to system.

Artesyn Technologies    Framingham, MA 01701
Dec 22, 2005 Suited for use with RF power amplifiers, RFF series generates regulated intermediate bus voltage in telecom systems with distributed power architecture. Each model produces 28 Vdc output, which can be adjusted over 16.8-29.4 V range. Comprised of 5 isolated models with choice of 2 input voltage ranges and 3 output current ratings, series includes 7-10 Vdc auxiliary output as well as ability to be connected in parallel and automatically share load current.

Cablofil Inc.    Mascoutah, IL 62258
Dec 21, 2005 Suited for tight installations where access is limited or where cable must be installed close to ceiling or deck, CFL L Wire Cable Tray can be used in conjunction with I-beams or C-beams, allowing beam profile to become part of cable containment pathway. ETC tray beam support clamps attach directly to beam with no need for additional hardware. Available finishes for both include electrozinc, hot dipped galvanized, stainless steel, black, and custom painted.

SOR Inc.    Lenexa, KS 66215 2003
Dec 21, 2005 Horizontally mounted, float-operated Model 1540 is suited for plant and OEM applications where pneumatic valve operation is required to signal presence or absence of liquid at discrete level. One-piece body and all wetted parts are constructed with 316 stainless steel.

Scientific Technologies Inc.    Fremont, CA 94555
Dec 21, 2005 Providing 360° status indication in red, amber, or green, 24 Vdc Conduit LED Beacons are suited for various safety devices such as interlock switches, light curtains, and mats. IP65-rated, UL and C-UL listed units allow visual monitoring of multiple hazardous access points, without having to manually check status of each device. They feature M20 threads and 4 in. leads for installation without adapter, 1.25 in. footprint, and more 100,000 hours of life.

Linear Technology Corp.    Milpitas, CA 95035
Dec 20, 2005 Using constant frequency and current mode architecture, LTC3417 operates from 2.25-5.5 V input range and delivers up to 1.4 A continuous output current from one channel and 800 mA from other. This dual-output, synchronous buck regulator can generate 2 independent output voltages as low as 0.6 V, and its adjustable switching frequency from 0.6-4 MHz allows enables use of ceramic capacitors and inductors less than 2 mm high. Product delivers efficiencies to 95%.

Electroswitch, Unit Of Electro Switch Corp.    Weymouth, MA 02188 2913
Dec 20, 2005 Providing make and break action with ~10 msec contact transfer time, Snap-Action Rotary Military Switches comply with military requirements for ac or dc switching in high-shock, high-vibration environments. Standard models are available with up to 12 poles and 4 positions. To minimize resistance and heating, ends of stationary contacts extend outside insulating disks to serve as connecting terminals. Stationary contacts can be non-shorting, shorting, or sweep style.

TE Connectivity Ltd.    Berwyn, PA 19312
Dec 20, 2005 Available in 4, 6, 9, and 12 contact position versions for 20-14 AWG wire, Universal MATE-N-LOK Connectors provide environmental sealing protection to IP56 by employing wire entry seals, interfacial seal, and bulkhead seal. Four-contact position version handles up to 15 A/contact using 14 AWG wire, while 12-position unit handles up to 11 A with 14 AWG wire. Rear mount flange allows connectors to be pre-installed on wire harness.

Linear Technology Corp.    Milpitas, CA 95035
Dec 19, 2005 Standalone, linear Model LTC4065L charges single coin cell Li-Ion batteries up to 250 mA without overheating device or surrounding components. IC offers 4.2 V ±0.5% accurate float voltage, 5% charge current accuracy, timer termination, and C/10 detection. It requires no external MOSFET, sense resistor, or blocking diode. Charge current monitor output is provided for charge termination, recharge, trickle charging, and charge status indication.

W.A.C. Lighting Company    Garden City, NY 11530
Dec 19, 2005 Trumpet-shaped G617 Series features handcrafted glass pendants with hand-blown shades in blue/green, blue/red, and white/amber color combinations with Millefiore frits. Using quick connect components, pendants adapt to Flexrail2 two-circuit line voltage rail system, low-voltage monorail system, line and low-voltage track systems, monopoints, multipoints, and low-voltage wall sconces. Each Quick Connect pendant measures 4 in. wide x 7 in. tall.

Linear Technology Corp.    Milpitas, CA 95035
Dec 19, 2005 Featuring complete photoflash capacitor charger and IGBT driver, LT3485-3, -0, -2, and -1 photoflash capacitor charger ICs operate from 1.8-10 V range and have primary current limits of 2, 1.4, 1, and 0.7 A respectively. Control technique allows series to use 5.8 x 5.8 x 3 mm transformers, and no external components are required to set output voltage. While charging, output proportional to capacitor voltage is available for monitoring. Average input current ranges from 225-700 mA.

Pepperl + Fuchs, Inc.    Twinsburg, OH 44087 2245
Dec 15, 2005 AS-Interface Flat-to-Flat Model VAZ-2FK-B3 facilitates connection of two AS-Interface cables or two 24 Vdc auxiliary power cables. It fits into cable tray or can be screw-mounted to side of machine. AS-Interface offers wiring solution for machines that are built, tested, and broken down for shipment before being reassembled at customer plant.

Advanced Analogic Technologies Inc.    Sunnyvale, CA 94085
Dec 15, 2005 Available in 2.0 x 2.1 mm SC70JW-8 package, 1 MHz Models AAT1123 and AAT1143 supply 600 mA and 400 mA max output current, respectively, while maintaining low 25 µA no load quiescent current. Both units support input voltage range of 2.7-5.5 V and output as low as 0.6 V. Devices are available in fixed version with internal feedback or programmable version with external feedback resistor. Efficiency levels for AAT1123 and AAT1143 range up to 97% and 95%, respectively.

Artesyn Technologies, Inc    Boca Raton, FL 33434
Dec 15, 2005 With input range of 4.5-13.8 V, PMBus-compliant 20 A Model DPL20C offers programmable output voltage from 0.6-5.5 V as well as programmable sequencing, tracking, and margining. Non-isolated, POL converter offers real-time monitoring of voltage, current, and temperature, with automatic warning of fault conditions. It stores all configuration and set-up data in non-volatile memory, and powers-up with pre-programmed default settings, eliminating external power controllers.

Advanced Power Technology - Europe    Merignac 33700  France
Dec 13, 2005 Offered in SP3, SP4, and SP6 packages, 100 V MOSFET Modules are available in single switch, buck, boost, dual common source, phase leg, full bridge, asymmetrical bridge, dual boost, and dual buck configurations. With 12 mm height for SP3 package and 17 mm height for SP4 and SP6 packages, modules exhibit minimal internal parasitic resistance and inductance. Applications include motor control, power supplies, and battery-operated equipment from 24-48 V.

Texas Instruments, Inc., Semiconductors    Dallas, TX 75243
Dec 13, 2005 Delivering up to 85% efficiency, DCP010507DB meets UL1950 specifications with 1 kVrms isolation and EN55022 Class B EMC performance. This 1 W isolated, unregulated dc/dc converter operates from 5 V input and features dual ±7 V outputs. Operating over -40 to +100°C temperature range, unit provides thermal shutdown and short-circuit protection as well as device-to-device synchronization control. It can also provide point-of-load power conversion and ground loop elimination.