Calex Mfg. Co., Inc.
Concord, CA 94520
Aug 01, 2007 With input range of 18-36 Vdc, LT Series provides 3 fully independent and regulated output voltages from 5-1.5 V. Units are isolated input to output and output to output. Housed in half-brick package measuring 2.4 x 2.3 x 0.55 in., each unit is fully encapsulated with thermally conductive potting compound and aluminum baseplate with operating temperature of -40 to +100°C. Trim capability on output voltage is provided to compensate for voltage drops.

MagnaChip Semiconductor
Cheongju-si,Chungbuk   Korea (south)
Aug 01, 2007 Capable of up to QVGA (240RGB x 320) resolution, cell phone LCD driver chip can be mounted on HD Low Temperature Polysilicon (LTPS) LCD panels. This driver IC has embedded controller offering Picture in Picture (PIP) and EEPROM memory to promote picture quality. Targeted towards high-end cell phone models, product supports 16 million colors as its default and provides interfaces that support GSM phones.

Fairchild Semiconductor
San Jose, CA 95134
Aug 01, 2007 Available in 2 x 2 mm, green-compliant MicroFET(TM) MLP package, IntelliMAX(TM) FPF214X and FPF216X Series provides thermal dissipation and full system protection for portable applications operating between 1.8 and 5.5 V. Units integrate 0.11 W current-limited P-channel MOSFET with thermal shutdown, controlled turn-on, reverse-current blocking, and UVLO. Power Good signal indicates stable output power signal for software management in power sequencing applications.

Tyco Electronics Corp.
Harrisburg, PA 17105-3608
Jul 31, 2007 Model M/A-COM MASWSS0201 achieves less than 0.9 dB of insertion loss and 65 dB of isolation at 100 MHz in 75 ohm system. Switch is designed to have P1 dB of 21 dBm at 100 MHz and 28 dBm at 900 MHz. Greater than 40 dB isolation is maintained up to 2.5 GHz with corresponding insertion loss less than 1.5 dB. It is configurable to have absorptive or reflective RF1, RF2 port matches, and when un-powered, it automatically enables default-on state.

Texas Instruments, Inc., Semiconductors
Dallas, TX 75243
Jul 31, 2007 Suited for high-voltage, noisy applications, dual-channel ISO7220 and ISO7221 utilize capacitive technology to provide galvanic isolation up to 4,000 V and immunity from external magnetic fields. Devices also offer immunity against data corruption due to voltage transients up to 24 kV/µs. To faciliate PCB layout, ISO7220 has 2 channels in same direction and ISO7221 has 2 channels in opposite directions. Both provide 3 speed options of 1, 25, and 150 Mbps.

Texas Instruments, Inc. (TI)
Dallas, TX 75243-4136
Jul 31, 2007 Supporting any combination of 3.3 or 5 V supplies, ISO722x family digital isolators feature 1 nsec channel-to-channel skew, 3 nsec part-to-part skew, 1 nsec jitter, 1 nsec pulse width distortion, and 4 kV ESD protection. Integrating capacitive isolation technology, units provide immunity against data corruption due to 25 kV/µs voltage transients. Facilitating PCB layout, Model ISO7220 has 2 channels in same direction, while Model ISO7221 has 2 channels in opposite directions.

WAGO Corp.
Germantown, WI 53022
Jul 30, 2007 Supplied in 6 mm-wide package, 857 Series (JUMPFLEX) signal conditioning and relay modules feature CAGE CLAMP wiring technology and push-in jumper system. Signal conditioners consist of 12 different modules, configurable and dedicated, supporting range of signal types. Configurations include splitter, single- and multi-channel, repeater, and loop-powered. Up to 7 different relay modules offer variety of AC/DC coil voltages and can switch loads up to 250 V and 5 A.

Cooper Lighting
Peachtree City, GA 30269
Jul 30, 2007 Series 505 ceramic metal halide track lampholders for multiple Halo track systems provide an energy efficient alternative to halogen sources. Features include track aligned die-cast extruded aluminum ballast housing, lockable tilt and rotation, lampholder locking tab, matching integral on-off switch, and silicone beam adjustment knob. Accepts 20 W MR16, 39 W and 70 W PAR30, or T6 CMH lamps.

Pickering Interfaces
Wobum, MA 01801
Jul 27, 2007 Model 60-310 High Voltage Matrix is capable of hot switching 500 Vdc signals and cold switching 1,000 Vdc signals. Using Ruthenium sputtered relays providing less than 2.5 mV thermal EMF, model 60-510 Low Thermal EMF Matrix is capable of switching 150 Vdc signals with carry current up to 1 A. Contained within 2U enclosure, both include IVI, SOAP, and Direct I/O drivers and soft front panels for control through any W3C-compliant browser.

Harwil Corp.
Oxnard, CA 93030
Jul 27, 2007 Suited for fluid-based operating systems requiring temperature sensing and monitoring, Model Q-12NT senses temperature with accuracy of ±0.2°C over range of 0-70°C. Unit is rated at 50 W, 120/240 Vac and can control on/off functions within flow ranges specified by OEM or equipment designer. Able to mount vertically or horizontally, switch comes in Noryl Model Q-12NT for water and mild acid or base solutions, and Fortron Model Q-12CRT for corrosive solutions.

CIT Relay & Switch: Division of Circuit Interruption Technology, Inc.
Maple Grove, MN 55369
Jul 27, 2007 Offered with SPST NO contact arrangement, A9 Series uses standard automotive fuses with 9 options from 3-40 A. Coil voltage options include 6, 12, and 24 Vdc. Providing contact resistance of less than 50 mW initially, RoHS compliant units offer max switching power of 420 W, max switching voltage of 75 Vdc, and max switching current of 30 A. Insulation resistance is 100 MW at 500 Vdc and operating temperature is -40 to 85°C.

Banner Engineering Corp.
Minneapolis, MN 55441
Jul 27, 2007 Designed for Banner SureCross(TM) Wireless Network and adaptable to other devices, FlexPower(TM) Nodes allow SureCross Node to operate using 10-30 Vdc line power, solar panels, or FlexPower battery module in remote or difficult-to-access locations. Battery module enables operation for up to 5 years due to integral power management technology. Featuring NEMA 6 construction, portable product offers configurable parameters for actuation voltage up to 24 Vdc, time on, and sample.

Advanced Energy Industries Inc.
Fort Collins, CO 80525
Jul 27, 2007 Targeting semiconductor, FPD, MEMS, and solar photovoltaic manufacturing, Paramount(TM) RF-Power Delivery System enables power control and delivery across full output range, both on and off 50 W, for seamless process transitions in strip, PECVD, HDP-CVD, PVD, and PEALD. Half-rack, 3 kW unit has impedance measurement that enables power delivery and control at 13.56 MHz fixed or variable frequencies, and can keep pace with abrupt plasma-impedance changes.

Fairchild Semiconductor
San Jose, CA 95134
Jul 27, 2007 Available in Pb-free packages that meet or exceed standard J-STD-020C requirements, Models FAN7710 and FAN7711 feature built-in adaptive ZVS control, 15 V shunt regulator, HVIC, and UVLO function. Suited for CFL designs, Model FAN7710 includes one high-side 625 V gate driver circuit, two 550 V MOSFETs, and frequency control circuit. Model FAN7711 integrates all but 2 MOSFETs offered by Model FAN7710, and suits LFL designs as well as CFL applications.

Harwil Corp.
Oxnard, CA 93030
Jul 26, 2007 Models L-40 N (Noryl) and L-40 VCR (Fortron - for corrosive fluids) submersible switches signal fluid level changes to on/off pump controls, alarms, and microprocessors. Switches feature loose pivot movement arms, 2-ft 22 gauge electrical leads, and 316 stainless steel float pivot pins. Hastelloy C, titanium, and Teflon pins are also available. Both models are rated at 50 W for 120/240 Vac.

Pass & Seymour/Legrand
Syracuse, NY 13221
Jul 26, 2007 Illuminated Hospital Grade P&S PlugTail(TM) Receptacles feature LED-illuminated receptacle faces that help identify proper power connections in hospitals - even in dark rooms or at night. Installed in seconds, design offers one-click termination and ensures safe, consistent, reliable connections. Integral LED lamps carry 9-year life expectancy.

Samtec, Inc.
New Albany, IN 47151 1147
Jul 26, 2007 Featuring 1 or 2 RF connectors per end, high-speed QMS/QFS Q2(TM) Series provides up to 156 single-ended or 48 signal pairs per connector on 0.635 mm pitch with internal ground plane. ESRF/ETRF Series features high-density connectors on 2 mm pitch with up to 80 signal/ground pins and 6 RF connectors as standard. Units can be combined with MMCX-scale or other RF connectors to provide optimal board-to-board flexibility and functionality.

Bel Fuse, Inc.
Jersey City, NJ 07302 4419
Jul 26, 2007 Capable of delivering 40 W of output power at higher voltages, or up to 18 A of output current at 1.2 V, 1/16 brick DC-DC converters operate over 4:1 input range of 18-75 Vdc. They feature fixed frequency synchronous rectification control together with positive/negative remote sense, remote on/off logic, and ±10% output trim. Protection features include input and output over-voltage, over-temperature, current limit, and short circuit protection, and under voltage lockout.

Impact Acoustics
Dayton, OH 45404
Jul 26, 2007 Compatible with all interlaced or progressive scan analog HD component video signals, 6x2 Component Video Matrix Selector Switch simultaneously routes any of 6 HDTV source devices to 2 separate high definition TVs or monitors, or splits one source to 2 high definition TV/monitors. Switch features video bandwidth of 300 MHz, and contains 6 HD component video inputs, 6 stereo audio inputs, and 6 optical digital audio TOSLINK inputs with 2 outputs for each of these signal types.

Remstar International, Inc.
Westbrook, ME 04092
Jul 25, 2007 QuickPick® Position Indicator (QPi) indicates order picking information for Remstar horizontal carousels directly in front of exact storage tote or container. QPi moves vertically, positions itself above or below shelf level, and indicates correct container by flashing arrows. It shows the operator tote position, as well as the required transaction quantity, resulting in more efficient and accurate order picking.