Electrical Equipment & Systems

Electrical Equipment & Systems

Uninterruptible Power System works in parallel for redundancy.

November 17, 2001

Powerware Hot Sync 9330 UPS can be configured in paralleled solutions for maximum system reliability and availability for applications in the 10 to 40 kV range. Digital signal processing provides true pulse width modulation. System's firmware-based paralleling technique uses mathematical instead of mechanical approach, which eliminates need for communication wiring and added circuitry between... Read More

Electrical Equipment & Systems

Switchboard Bypass Module ousts switchboard outsourcing.

November 17, 2001

PowerHandler Plus 3-phase power management switchboard system bypass module (SSBM) is designed for 3200 to 4000 A applications. It enables paralleled UPS systems to be serviced without removing critical loads from protected power. PowerHandler Plus features draw-out breakers and fully rated static switch. Read More

Electrical Equipment & Systems, Laboratory and Research Supplies and Equipment

Viewing Cabinet acts as mini darkroom.

November 16, 2001

Portable Spectroline(R) CM-26 UV Viewing Cabinet allows users to observe faint UV fluorescence in brightly lit rooms. It features ENF-260C UV lamp, which delivers typical peak long wave UV (365 Nm) intensity of 350 µW/cm2 and short wave UV (254 Nm) intensity of 390 µW/cm2 at cabinet floor. Contoured viewer has built-in UV-absorbing window, which protects user's eyes. CM-26 cabinet is... Read More

Electrical Equipment & Systems

Liquid Level Switches are based on ultrasonic technology.

November 15, 2001

Single point ULS-50 and multi-point ULS-60 are suitable for acids, ultra-pure and wastewater, inks and paints, slurries, food and beverage, semiconductor process chemicals, oils, petroleum distillates and other coating or aggressive liquids. ULS-60 mounts on top of tank and has 2 integral relays for level switching setpoints. ULS-50 wetted materials are either all-polypropylene or all-PFA... Read More

Controls & Controllers, Electrical Equipment & Systems

Pushbutton Switches have momentary or alternate actuation.

November 15, 2001

Series 600/800 single module, multi-image, lighted pushbutton switches are 2 A resistive and are rated 0.5 A inductive at 30 Vdc or 125 Vac. Features include operating pressure of 2 lbs (±1 lb), plunger travel of ~0.187 in., and rated life expectancy of 100,000 (minimum) actuations. Series 600 (3/4 in. square) and Series 800 (3/4 x 7/8 in. rectangular) units can be specified in singular or... Read More

Electrical Equipment & Systems

Lighting System replicates daylight in work areas.

November 14, 2001

IP68 rated compact 9700 Series High-Intensity Discharge work lamp provides daylight color impressions and produces 25% more light than company's previous model. It has all-glass lenses, stainless steel hardware and mounting system, and is sealed from water, dust and corrosion. Unit also eliminates breakage from shock and vibration. Lamp available in 12 or 24 V models. Read More

Electrical Equipment & Systems

Liquid-Tight Conduit suits continuous flexing applications.

November 13, 2001

Nonmetallic Type LNM-P will not wear from repeated flexing or vibration. Made of flame-retardant PVC, it resists oils, mild acids, and exposure to sunlight, and works in temperatures from -20°C to 60°C. Applications include cable carriers and industrial robots. It is available in trade sizes from 3/8 through 2 in. Conduit is CSA certified, UL listed, and meets Section 17.8 of Electrical... Read More

Electrical Equipment & Systems

Dimming Ballasts are designed for T5/HO lamps.

November 9, 2001

Mark X Powerline Dimming Ballasts provide 100% to 1% full-range dimming for 1 or 2 F54T5/HO, FT55W, or FC12T5/HO fluorescent lamps. They feature programmed-start operation; lamp ignition at any light setting, including 1% dim level; operation above 40 kHz to minimize risk of interference problems; and lamp end-of-life detection system. Ballasts are encapsulated in low-profile cases measuring... Read More

Electrical Equipment & Systems, Electronic Components & Devices

Transformers are for full rate or ADSL applications.

November 9, 2001

Engineered to match Texas Instruments' AC5 octal chipsets, Bel S560-6600-Z6 and S560-6600-CE transformers offer total harmonic distortion in EP10 packages. They are suited for Digital Subscriber Line Access Multiplexer equipment and may be specified for remote site Digital Loop Carrier multi-port applications. Devices feature electromagnetic interference suppression, operating temperature range... Read More

Electrical Equipment & Systems

Outdoor Light fits on top of posts.

November 9, 2001

Decorative Design ZAV-24 post-top luminaires emit visually interesting combination of glare-free ambient area lighting for outdoor commercial and institutional environments, corporate and university grounds, public parks, and retail and hospitality sites. Cylindrical lamphead has vandal-resistant solid metal ends and die-cast rectangular openings above the canopy. These lend a design aesthetic... Read More

Electrical Equipment & Systems

Cord Sets extend, then snap back.

November 9, 2001

Retractile cords are coiled in helical shape that allows cord to extend to 4:1 or 5:1 ratio. A 48 in. cord, for example, will extend to 20 ft. To maintain integrity in harsh environments they are constructed with thermoset rubber jacket that is waterproof and resistant to pinching, abrasion, oils, greases, chemicals, ozone and sunlight. Cords are available in SOW and SJOW configurations with 2 to... Read More

Electrical Equipment & Systems

Relay Assemblies are rated for 60 A loads.

November 8, 2001

Solid State Relay Assemblies feature anodized aluminum heat sink to ensure reliability at rated power levels in ambient operating environment up to 40° C. Load-suppression diode and finger-safe covers are standard. Units accept controller inputs of 3.5 to 32 Vdc or 90 to 280 Vac. Load currents range from 0.02 to 60 Adc and load voltages range up to 400 Vdc. Relays have bipolar output with 4000... Read More

Electrical Equipment & Systems, Optics & Photonics

Transmitters are available in 14 units.

November 8, 2001

LPI-SERIES isolated loop powered transmitters feature field programmable bi-polar input ranges with 2 kV isolation and accuracy of 0.10%. Members include: DC to DC with fixed or programmable input range, Bridge to DC, Resistance to DC, Potentiometer to DC, Differential RTD to DC, RTD to DC with fixed or programmable ranges, Thermocouple to DC with fixed or programmable ranges, AC to DC with... Read More

Electrical Equipment & Systems

Jack provides cable strain relief.

November 8, 2001

Xcelerator(TM) GX2 Jack features QuickLace(TM) termination process and universal wiring format. It includes white IDC tower for visual contrast and smoke-gray stuffer cap that provides positive snap-latch feel and strain relief when jack is installed. Read More

Electrical Equipment & Systems

Analog Converters are approved for hazardous locations.

November 8, 2001

Din rail mounted C.A.I.S. UNI multifunction analog converters convert voltage, current, resistance temperature devices (RTDs), and thermocouple signals to standard process levels. They offer plug-in wiring and short-circuit proof outputs. C.A.I.S.-E family includes four multifunction analog signal converters plus single function models to perform specific analog signal conversion. All have 3-way... Read More

Electrical Equipment & Systems

Power Supplies available in 10, 15 and 30 W sizes.

November 8, 2001

JBW line of PC card-style power supplies are single output devices in the range of 5 to 24 Vdc. They accept universal ac input from 85 to 264 Vac or a dc input from 110 to 370 Vdc. They measure 2.17 x 4.80 x 1.02 in. and are approved for all international conducted EMI and safety standards. Read More

Electrical Equipment & Systems

Miniature Relays consume very little power.

November 8, 2001

Model AZ852 and AZ853 relays meet Bellcore's 2.5 kV and FCC Part 68 1.5 kV surge voltages standards, plus IEC 60950, UL1950 and EN60950 spacing and high breakdown voltage requirements. Both consume only 79 mW power at pick-up, have stable contact resistance for signal or low-level switching, and are epoxy-sealed for automatic processing. Versions with latching coil and/or SMT enclosure are... Read More

Electrical Equipment & Systems

IDC Systems are available in various sizes.

November 8, 2001

FFSD Series IDC system features contacts on 0.050 in. x 0.050 in. pitch and is available in double row designs. Assembly measures 0.200 in. tall and includes 4-finger Beryllium Copper contacts with 10 to 25 positons per row. Notch polarization is standard. TCMD Series system features contacts on 0.0787 in. x 0.0787 in. pitch with square Phosphor Bronze pins and 2 to 25 positions per row. TCSD... Read More

Electrical Equipment & Systems, Electronic Components & Devices

Flyback Transformer features corona-free design.

November 8, 2001

Model 4283-1100 High-Voltage Transformer drives high impedance loads requiring up to 7,500 Vrms. Providing primary-to-secondary isolation up to 18 kVdc, unit is suitable for applications requiring high-voltage, low to medium power including industrial lasers, ion generators, cathode ray tube transformers and traveling wave tube power supplies. Model 4283-1100 is particularly reliable in... Read More

Electrical Equipment & Systems

DC/DC Converter provides 10 A output in small package.

November 8, 2001

Single output UHE Series isolated dc/dc converter delivers as much IOUT (10 A) as company's half/quarter-bricks and standard 2 x 2 in. modules. High efficiency eliminates need for heat-sinking aluminum baseplates common to most bricks. It comes in plastic package measuring 1.6 x 2 x 0.4 in. Options include 22 models with VOUTs from 1.2 to 15 V, IOUTs from 2 to 10 A, and VINs from 10 to 75 V. Free... Read More