DTE Energy Technologies, Inc.    Detroit, MI 48226
Jul 15, 2003 Rated at 75 kW, energy|nowâ„¢ ENI 75 on-site energy system incorporates automotive natural gas fired engine and can provide full power in event of utility outage. Unit has pre-engineered, packaged design, supports peak and full load requirements, and suits base load and waste heat utilization applications. Able to support indoor/outdoor installations, waste heat applications can provide both chilled and hot water.

ITW Switches, An Illinois Tool Works Co.    Harwood Heights, IL 60656 3512
Jul 15, 2003 With 0.050 in. centers, ERG SMJS Jumper-Switchâ„¢ can be configured as SPDT or DPDT. Product is available with custom or ganged top half that allows pick-and-place equipment to remove switch for processing. Other features include gold over nickel-plated beryllium copper contacts, 4-point wiping contact design, positive detent action, and deep V slots. Unit is suited for data programming, digital address settings, and signal and data line switching.

C & D Technologies    Mansfield, MA 02048-1151
Jul 15, 2003 Series LEN non-isolated, point-of-load DC/DC converters accept 12 V ±15% input and convert it to lower voltage from 0.8-3.3 V at 28 A or 5 V at 25 A. Two-phase, fixed-frequency, buck-regulator design enables them to simultaneously deliver 85-96% efficiency, 100 µsec step response, and operating temperature to +70°C without derating. E-brick package is offered in both standard through-hole and SMT versions. Units are lead-free and include I/O protection.

Linear Technology Corp.    Milpitas, CA 95035
Jul 15, 2003 Model LTC3252 spread spectrum, step-down DC/DC converter can deliver 250 mA continuous output to 2 separate channels. It operates from 2.7-5.5 V, making it suitable for single cell Li-Ion or multi-cell NiMH/Alkaline applications. Both outputs are resistor programmable from 0.9-1.6 V. Switched capacitor fractional conversion enables it to attain efficiencies as high as 88%. Switching frequency randomly shifts within 1.0-1.6 MHz range to minimize harmonics.

Heyco Products, Inc.    Toms River, NJ 08753
Jul 14, 2003 Heavy-Duty Ring and Spade Terminals are available 2- or 3-up on single-reel, rear-feed system, which allows 2 or 3 terminals to be crimped onto ground wire at one time for high-voltage applications. Made from solid, smooth-finish brass, terminals are offered in sizes to crimp onto larger, higher voltage, 6–8 and 8–12 American Wire Gauge ground wire from single large-capacity rear-feed reels.

Interpower Corporation    Oskaloosa, IA 52577-0115
Jul 14, 2003 With 1U size, 19 in. rack-mount Interpower(TM) Model 852Q2L18 provides domestic and international single-phase power to equipment racks. Unit is equipped with IEC 60320 Sheet F outlets with C20 inlet and is rated at 16 A for service at 250 Vac. It comes with lighted rocker circuit breaker and is UL recognized, CSA certified, and TUV approved with CE mark. Interpower IEC 60320 Universal Jumper Power Cords and Cordsets connect product to equipment.

Rip-Tie Inc.    San Francisco, CA 94107
Jul 14, 2003 Rip-Tie CableCarrier is available with 2 1/16 in. nylon swivelhook, 3 1/8 in. aluminum carabiner, or 2 3/16 in. aluminum triangular carabiner. Non-load bearing carabiners come in matte silver and matte black. Max opening on 3 1/8 in. carabiner is 1 in. allowing it to hang from wide range of supports and equipment. Rip-Tie pull tab makes opening CableCarrier one handed operation. Product will last for 10,000 refastenings.

Supertex Inc.    Sunnyvale, CA 94619
Jul 14, 2003 Using HVCMOS technology, HV632 integrates high- and low-voltage circuits on one die. With full integration of low voltage CMOS logic, 32-channel IC supports PWM conversion of 256 levels of gray shading and 32 high-voltage CMOS outputs, each capable of 80 V operation as well as sourcing and sinking 4 mA. Data bus (8-bit) includes balanced shift clock and output and blank functions. Product suits applications requiring data rates to 20 MHz and operating within 12–80 V output range.

Astrodyne Corp.    Mansfield, MA 02048
Jul 14, 2003 Active power factor corrected Series SP500 provides output power of 500 W, 85-265 Vac universal input, and single outputs from 12-48 Vdc. Series offers soft-start circuitry with integral EMI filtering and includes power-good LED indicator, output adjustment potentiometer, and 0 to +40°C ambient temperature range. Each model contains over voltage and short circuit protection circuitry, 3,000 Vac I/O isolation, and screw terminal I/O connections.

TE Connectivity Ltd.    Berwyn, PA 19312
Jul 11, 2003 Enclosed in UL 94V-0 rated housing that is RT III and wash-tight, 5 mm wide OEG PCN series relay has 1-form-A contact arrangement: single-pole, single throw, NO. Rated for 3 A, it handles switching voltages up to 250 Vac or 30 Vdc resistive. Bifurcated, gold-plated, nickel contacts are capable of switching loads as low as 1 mA @ 5 Vdc. Coil requires 120 mW of coil power, and may be ordered in 5 voltage ratings from 5-24 Vdc.

Dwyer Instruments, Inc.    Michigan City, IN 46361
Jul 11, 2003 Series MP Mini-Photohelic combines Minihelic II® differential pressure gage with 2 SPDT switching setpoints. It measures and controls positive, negative, or differential pressures consisting of non-combustible and non-corrosive gases. Gage reading is independent of switch operation. Switching status is visible by LED indicators located on front and rear of gage. Compact size makes unit suitable for fume hoods, dust collection, and pneumatic conveying.

Supertex Inc.    Sunnyvale, CA 94619
Jul 11, 2003 Model HV111 high-voltage Inrush Limiter/Circuit Breaker/Hotswap IC suits externally powered network equipment and pluggable backplane applications with loads up to 1.65 A. Operating from -8.0 to -80 V, unit has 3 current control algorithms and incorporates on-board, 80 V, 2 A MOSFET combined with UVLO supervisor. Features include multi-level current control, junction isolated construction, and 1.2 A inrush current limiting with 75 msec timeout.

CIT Relay & Switch: Division of Circuit Interruption Technology, Inc.    Maple Grove, MN 55369
Jul 10, 2003 Suitable for logic switching in computers and peripherals, KG Series full profile, single pole single throw (SPST), DIP switch is available with 2–12 positions. Offered with extended actuator for ease of switching, series is available with top tape seal for solder washing.

Cooper Power Systems    Waukesha, WI 53188
Jul 09, 2003 Kyle® NOVAâ„¢ encases vacuum interrupter in cycloaliphatic epoxy to eliminate need for insulating fluid, gas, or foam. Requiring no maintenance throughout life of product, unit has polymer casing that resists UV radiation. It maintains self-cleaning, unblemished surface with low adhesion to contaminants. Polymer also resists tracking, reducing flashovers. NOVA technology is available in Cooper Kyle switches, sectionalizers, and reclosers.

Specialty Lighting Inc.    Shelby, NC 28151 1680
Jul 09, 2003 SlimLink flicker-free fluorescent lighting system features ¾ in. high x 1 ¾ in. deep profile, allowing fixtures to be concealed under curved or flat surfaces. Housing lengths range from 10–23 in. Lights can be used alone, end-linked, or cord-linked to form continuous rows of up to 10 units per run. T4 linear fluorescent lamps provide illumination from 6–20 W per SlimLink unit. Prismatic acrylic diffuser shields lamp from viewer's eyes, while providing 120° light distribution.

NKK Switches    Scottsdale, AZ 85260-3420
Jul 07, 2003 Available in flat or tubular key styles, panel-mount CK Series switches are offered in 19 and 16 mm dia bushing options and offer 4- and 5-tumbler locking mechanisms, resp. Products also employ self-cleaning, sliding contacts and dielectric strength of 1,500 V between contacts and case. Rated 3 A @ 250 Vac, series is available in single pole, 2- and 3-position models with respective 90° and 45° angle of throw. Circuit options are ON-ON or ON-OFF-ON.

Mitee-Bite Products Inc.    Center Ossipee, NH 03814
Jul 07, 2003 LOC-LITE is waterproof and requires only a twist to turn on or off. Batteries last over 100 hours, and strong rubber coated magnet will not scratch painted surfaces. Small size makes it easy to put light in difficult, constrained location. All light components are in stainless steel body, so flexible length can be adjusted by snapping apart.

W.A.C. Lighting Company    Garden City, NY 11530
Jul 07, 2003 Low Voltage Monorail System can be custom designed with curves to negotiate corners on ceilings and walls. Monorail, which is flexible in field, bends for visual impact in various installations. QuickConnect Series consists of ceiling canopies, components, and accessories that allow pendants and fixtures to be utilized as monopoints and multipoints. Pendants include shades crafted of mouthblown glass. Monorail/track Fixtures include designs with stems, aiming wands, and bulb shields.

Zippertubing Co.    Los Angeles, CA 90061 0129
Jul 07, 2003 Constructed of 4-ply knitted tin copper-iron (SnCuFe) wire, Zipper-Mesh® enables users to add additional EMI protection to new or existing designs. Using heavy-duty mechanical zipper closure enables tool-less installation, allowing access to cable assembly for service, repairs, or redesign. Flexible, durable mesh is available in sizes from 1 in. and larger, with or without external protective jacket. Custom lengths to 100 ft long are available.

ABB Control Inc.    Wichita Falls, TX 76302
Jul 07, 2003 Smissline adds no height or width and eliminates 50% of power wiring. DIN rail components mount with click and base-mounted components mount with screws. Single-phase devices can be mounted adjacent to multi-phase devices on same system. Smissline system offers 6–100 poles and employs finger safe design. It is UL and IEC approved.