Maxim Integrated Products
Sunnyvale, CA 94086
Nov 06, 2009 Consuming 20 µA of IQ to conserve battery life, 200 mA MAX16910 includes reset output with adjustable delay so no external reset IC is needed. Unit operates from 3.5-30 V to withstand cold-crank and double-battery conditions; it can also operate during load-dump conditions up to 45 V. Available in thermally enhanced 8-pin TDFN and SO packages, MAX16910 has 3 pin-selectable output-voltage configurations: 3.3 or 5 V fixed output, or externally adjustable output-voltage from 1.5-11 V.

Maxim Integrated Products
Sunnyvale, CA 94086
Nov 06, 2009 Supplied in 4 x 4 mm package, MAX17409 offers active voltage positioning that lowers output voltage in response to load current and subsequently reduces output capacitance requirements and power dissipation. Load current is sensed at MAX17409's output, minimizing noise sensitivity, and can be sensed using current-sense resistor or DC resistance of inductor. Along with 200-600 kHz adjustable switching frequency, features include overvoltage, undervoltage, and thermal-fault protection.

Linear Technology Corp.
Milpitas, CA 95035-7417
Nov 06, 2009 Housed in thermally enhanced 3 x 3 mm QFN-16 package, LTC3775 synchronous step-down DC/DC switching regulator controller features 4.5-38 V input range and 30 ns minimum on-time. Onboard MOSFET gate drivers allow use of high-power external MOSFETs to produce output currents up to 20 A with output voltages ranging from 0.6 to 80% of input voltage. Constant-frequency, leading edge modulation, voltage mode line feed forward architecture provides selectable or PLL frequency from 250 kHz to 1 MHz.

Sauer-Danfoss
Ames, IA 50010
Nov 06, 2009 Integrating OSP steering technology and electrohydraulic steering valve, OSPE improves vehicle performance and comfort while facilitating compliance with Machinery Directive 2006/42/EC and simplifying hydraulic system architecture. Safe State feature can isolate electrohydraulic section of steering valve to protect steering system. Other features include selectable reactive and non-reactive steering modes, Load Sensing and Open Center options, and variable steering ratio.

AutomationDirect.com
Cumming, GA 30040-9905
Nov 06, 2009 Available in 45 and 55 mm DIN rail mountable frame sizes, microprocessor-based Stellar(TM) SR22 Series is overcurrent protected and has operating voltage range of 208-460 Vac. Each unit is equipped with 3 potentiometers allowing adjustable start and stop times of up to 30 sec and adjustable start pedestal voltage from 30-100%. Separate 24 Vdc control voltage is required. Starters are suited for applications such as pumps, blowers, and conveyors.

Maxim Integrated Products
Sunnyvale, CA 94086
Nov 05, 2009 Respectively capable of simultaneously managing up to 12 and 8 supply voltages, MAX16065 and MAX16066 are flash-configurable sequencers/monitors that integrate ±2.5% accurate current monitoring/group sequencing as well as ±1% accurate voltage monitoring/sequencing. Internal ADC and nonvolatile fault registers store and read back fault data. Also provided, graphical configuration tool helps generate data to analyze fault data or test different configurations.

Pilz Automation Safety L.P.
Canton, MI 48187
Nov 04, 2009 Bridging gap between standard and programmable relays, PNOZmulti Mini performs machine control tasks and monitors 2 or more safety functions such as emergency stop, safety gates, and light beam devices. Software-configured unit comes with 20 inputs, 10 if device being monitored requires dual channel wiring and 4 semiconductor outputs, 2 if dual channel wiring is required. LCD provides on-site diagnostics, while push and turn operator control allows access to status and diagnostics messages.

Linear Technology Corp.
Milpitas, CA 95035-7417
Nov 04, 2009 Featuring programmable average input current limit, Model LTC3606B delivers up to 800 mA of continuous output current with efficiencies up to 96%. Using constant frequency and current mode architecture, unit operates from input voltage of 2.5-5.5 V, making it suited for single-cell Li-Ion and USB applications. Device can generate output voltages from 0.6-5 V and uses switching frequency of 2.25 MHz. Housed in 3 x 3 mm DFN-8 package, synchronous buck regulator operates from -40 to 125°C.

Brady Corp.
Milwaukee, WI 53201 2131
Nov 04, 2009 Available in blue or grey with 4 or 6 information panels, Visual Display Boards help lean manufacturers track key performance indicators, report kaizen results and awards, and notify employees about future audits, kaizen blitzes, and other lean events. Boards can serve as production control boards or production scoreboards and display schedules, 5S duties, and employee assignments. Designed to endure harsh operating environments, boards will not warp, crack, or fade.

Advantech Automation Corp.
Cincinnati, OH 45240
Nov 03, 2009 Supplied in fanless, rack-mount, 2U chassis, ITA-2000 is designed for centralized management and remote monitoring of rail transport systems. This 1.6 GHz Intel® Atom(TM) N270 CPU-based system, featuring various I/O connectors and all-in-one motherboard, supports various embedded and real-time operating systems. Designed to resist vibration, solution also supports 100-240 Vac, 47-63 Hz or 110-220 Vdc input as well as 3.5 or 2.5 in. SATA HDD data storage options.

ADLINK Technology Inc.
Irvine, CA 92618
Nov 03, 2009 Model PCI-8253, 3-axis, and PCI-8256, 6-axis DSP-based servo motion controllers provide ±10 V analog motion control, PID plus feed-forward algorithm, and 20 MHz encoder input frequency. Units feature high-speed position comparison and trigger output speed of up to 1 MHz. They include motion functions such as multiple dimension interpolation and high-speed position comparison. Integrated point table supports over 5,000 points for each axis, suitable for contouring applications.

Rockwell Automation
Milwaukee, WI 53204
Nov 03, 2009 Available in power ranges from 0.75-250 kW or 1-350 hp at 400/480 Vac and 540/650 Vdc input, PowerFlex 753 supports multiple languages and complies with global standards and certifications. DeviceLogix control technology enables users to combine inputs and/or outputs, as well as local logic functions to determine drive's behavior. Drive can also be configured to provide advanced notification of operating data on cooling fans, I/O relay cycles, motor run-time hours, and potential fault warnings.

Maxim Integrated Products
Sunnyvale, CA 94086
Nov 02, 2009 Supplied in 5 x 5 mm package, step-down VID power-supply controllers MAX17030/MAX17036 have 2 integrated drivers that support 2-phase standard voltage cores and optional external driver configuration that supports 3-phase extreme edition cores. Three phases operate 120° out-of-phase, minimizing I/O filter requirements and EMI. Current-sense resistors and low-offset amps maintain current balance across 3 phases, reducing instantaneous input current of each phase and input-voltage ripple.

Crydom Corp.
San Diego, CA 92123
Nov 02, 2009 UL approved UPD Series solid state relays come in single-in-line PCB mounted version or low profile panel mount package with 0.25 in. male quick connects. They are designed for single channel, dual channel, or 3 phase operation rated at 280 Vac with either 15 or 25 A/channel output, depending upon model, available heat sinking, and operational ambient temperature. Units feature optically isolated DC input control ratings of either 3-32 Vdc, 3-15 Vdc, or 4.5-8 Vdc.

SJE Rhombus
Detroit Lakes, MN 56502
Nov 02, 2009 VFDC-1300 is equipped with variable frequency drive in NEMA 3R enclosure with circuit breaker, VFDC-1300 controller, and pressure transmitter. It can be configured for simplex, duplex or triplex pump control. Factory-tested and pre-programmed, control panel features built in PID control with sleep function, fill pipe function, smf dry run protection with automatic re-start after pre-set time.

American Industrial Systems, Inc.
Irvine, CA 92614
Oct 30, 2009 Based on 1.6 GHz Intel® Atom N270 processor and MiFare RFID card reader, Access Management System enables users to log and control traffic in and out of content sensitive workplaces. System includes 2 DI/DO ports, dual Gigabit LAN ports, and 1.3 Megapixel Web camera, as well as digital microphone and IR motion detector. Bundled Access Management Software offers custom features such as conference room booking, library management, and student attendance recording.

DPS Telecom
Fresno, CA 93727
Oct 29, 2009 Featuring LAN connection, Remote Power Switch enables user to switch on, switch off, and reboot equipment as well as keep tabs on power consumption via web interface. SNMP compatibility lets switch send traps directly to SNMP manager. Users may choose to receive notifications when relay is latched, or if unit is reset for any reason. If power to large number of devices needs to be controlled at single site, several switches can be daisy chained and will behave as single unit.

Glenro, Inc.
Paterson, NJ 07501 1799
Oct 29, 2009 Cantilevered Multi-Unwind and Rewind System offers auto edge control that is accurate to ±1 mm, and auto jog that allows material to automatically advance when pulled over load cell roll. System's auto run mode automatically unwinds start tension control when tension set point is reached. Configurable, PID-controlled product allows enable/disable, under/over-wind, tapering, and side-lay of each winder. It is suited for webs up to 18 in. wide with 20 in. roll dia and 100 lb roll weight.

Omron Electronics, LLC
Schaumburg, IL 60173
Oct 28, 2009 Integrating with CJ-Series PLCs, Trajexia CJ1W-MCH72 Module can operate up to 14 tasks simultaneously and control up to 30 axes over MECHATROLINK-II Motion bus with independent position, speed, or torque control for every axis. Each axis can run complex interpolated moves, e-cams, and e-gearboxes. Module includes digital I/Os, MECHATROLINK-II master connection, and serial port for external encoder input. Selectable cycle time, from 0.5-4 ms, enables individual response to servos and AC drives.

Microchip Technology, Inc.
Chandler, AZ 85224 6199
Oct 28, 2009 Featuring 28 V input, MCP1804 Low Dropout Regulators (LDOs) deliver up to 150 mA output current and support output voltages from 1.8-18 V. Input and output are stable, with 0.1 µF of capacitance, and operate on typ quiescent current of 50 µA. Shutdown function allows output to be disabled, dropping quiescent current to 0.01 µA. Available in SOT-23, SOT-89, and SOT-223 packages, LDOs support use of smaller ceramic capacitors and are suited for space-constrained and high-power designs.