Highland Technology, Inc.    San Francisco, CA 94103
May 22, 2013 Usable as crate slot 0 arbiter or secondary controller, V120 VME bus master crate controller connects to PCI Express cable driver board with up to 7 m cable. Unit provides 8184 remapping registers, each controlling 16 KB PC-to-VME remapping page with flexible timing and endian controls. Default powerup mapping allows access to A16, A24, and partial A32 VME address spaces. Product includes status LEDs and scope monitors and is suited for aerospace, industrial, and laboratory applications.

Asset InterTech Inc.    Richardson, TX 75080
May 07, 2013 Operating from PC and PXI chassis, ScanWorks® PXI-1000 can apply boundary-scan tests based on IEEE 1149.1/6 standards (JTAG), processor- and FPGA-controlled tests, and access instruments embedded in chips via IEEE P1687 Internal JTAG (IJTAG) standard. Controller comes with single-port interface pod for connecting ScanWorks to board being tested; up to 8 controllers can be installed in one PXI chassis for testing multiple circuit boards simultaneously.

Pixus Technologies    Waterloo, ON N2V 1C5
Jan 14, 2013 Available in 7U and 9U versions, which accommodate 6U pluggable boards, Recessed Enclosure Series allows subrack and boards to be completely protected inside enclosure frame, preventing damage to modules, limiting exposure to dust, and minimizing susceptibility to EMI/RFI. Versions for 3U pluggable boards in 4U overall height are also available. Front-to-rear or bottom-to-top cooling options are standard in 7U to 9U sizes, and wide range of AC or DC power supplies are available.

Atmel Corporation    San Jose, CA 95131
Sep 20, 2011 Certified to IEC/EN 60730 Class B, AT42QT1481/1244/1245/2640 are QTouch® capacitive touch controllers for buttons, sliders, and wheels are ready to use with no MCU programming and support high button counts through 24, 48, or 64 acquisition channels. Adjacent Key Suppression(TM) mode provides precise discrimination between closely spaced keys, while Failure Mode Effect Analysis support ensures system is running properly. Conducted immunity and QMatrix(TM) technology are standard.

Atmel Corporation    San Jose, CA 95131
Feb 10, 2011 Supporting 2-12 in. touchscreens, maXTouch(TM) E Series is suited for smartphones, e-book readers, and tablets. Single-chip solutions feature capacitive touch engine, advanced 32-bit AVR® architecture, and 224-768 nodes. With optimized noise immunity, devices allow consumers to simultaneously use 2 mm passive conductive stylus while continuing to support multi-touch. Controllers support unlimited touches and deliver sensitivity needed for detection of fingernail or gloved user.

Atmel Corporation    San Jose, CA 95131
Mar 10, 2010 Based on QTouch® capacitive touch technology for buttons, sliders, and wheels, AT42QT1110 meets all device specification requirements for GPS, window/mirror control, keyless remote entry, and other in-car automotive applications. This 11-key capacitive touch controller features firmware written according to Motor Industry Software Reliability Association C (MISRA C) standard and qualified according to AEC-Q100 (Automotive Electronic Council) standard.

National Instruments Corp.    Austin, TX 78759-3504
Dec 01, 2008 Featuring high-performance peripheral I/O, 2.16 GHz two-slot VXI Embedded Controller VXIpc-882 enables engineers to create hybrid systems by connecting external instruments to VXI system through GPIB, Ethernet, USB or serial ports or ExpressCard/34 slot. Users can add second VXI chassis to their systems with NI VXI-MXI-Express remote controller connected to unit via ExpressCard/34 slot. Controller can also be paired with 32 GB solid-state hard drive and LabVIEW v8.6 software.

3Dconnexion    Fremont, CA 94555
Nov 18, 2008 Offering CAD professionals intuitive navigation and control in SolidWorks® 2009 (3D CAD software), 3D mice enable design engineers to move in all 3 dimensions simultaneously using 6 degrees of freedom. SolidWorks users can pan, zoom, and rotate - without stopping to select commands - by gently lifting, pressing, and turning controller cap. Products also allow engineers to view design from multiple angles, which helps detect and correct design flaws.

IOGEAR    Irvine, CA 92618
Nov 12, 2008 Suited for audio/video editors, gamers, and graphic artists, 4-Port Dual Link DVI KVMP Switch with 7.1 Audio supports resolutions greater than 1,080 p HD. Unit is equipped with Display Emulation Technology, which remembers monitor's ideal resolution and refresh rate when switching between computers. For users who integrate number of machines to their workstation, switch allows independent sharing of USB 2.0 peripherals between 4 computers.

S.I.E. Computing Solutions, Inc.    Brockton, MA 02301
Sep 11, 2008 Engineered with open architecture, 500 Series Systems incorporate backplane, as well as power and cooling system, allowing end-users to completely customize industrial printer's computing system. Enclosures feature redundancy of N+1 hot-swap power supplies, so there is no need to shut power down to make adjustments. Units can be configured for both ac and dc power inputs with ground stud and ESD jack on rear I/O panel to meet NEBS requirements.

ARM Ltd.,    Sunnyvale, CA 94085
Jun 13, 2008 Suitable for single and multi-processor systems, ARM PrimeCell® GIC can be configured with 0-16 software generated interrupts, 0-16 private peripheral interrupts, and 1-988 shared peripheral interrupts. It offers inter-processor communications through multiple SGI broadcasting modes, and status tracking for interrupts through assertion, acknowledgement, and ending. Controller also provides intelligent management of interrupt security for systems with TrustZone® technology support.

Cypress Semiconductor Corp.    San Jose, CA 95134
Jan 10, 2008 Supporting up to 16 MLC NAND Flash devices, West Bridge(TM) Astoria(TM) peripheral controller comes with configurable multimedia storage interface and flexible processor interface. It can connect to any embedded processor or DSP, and supports SDHC v2.0, MMC+ v4.2 cards, CE-ATA for HDD, and various controlled NANDs. Unit features up to 27 programmable GPIOs and 16 USB endpoints, and supports standard handset frequencies such as 19.2 and 26 MHz for clock input.

Digital View, Inc.    Morgan Hill, CA 95037
Jan 07, 2008 LCD controller board, DVS-1600, has flexible port architecture that provides physical inputs for DVI, VGA, S-Video, and Composite Video. It supports various video modes, VESA timing modes, and legacy video modes. Pre-programmed to work with variety of panel models, solution supports multiple resolutions from VGA to UXGA and panel formats from 4:3 to 16:10. Calculated MTBF exceeds 260,000 hr, and panel timing and other features can be updated via serial port.

GDA Technologies, Inc    San Jose,, CA 95131
Aug 01, 2007 PCI Express Gen 2 Controller (GPEX-2) IP features scalable, configurable design targeted for end-point, root complex, switch, and bridge implementation in desktop, server, mobile, networking, and telecom applications. Independent of application logic, PHY designs, implementation tools, and target technology, solution supports range of data widths (32, 64, 128) and configurable lanes (x1, x2, x4, x8, x16). Flexible backend architecture allows for integration into range of applications.

Altronix Corp.    Brooklyn, NY 11220
Apr 19, 2007 Designed to handle current surge that panic hardware locking devices demand, StrikeIt(TM)1 Panic Device Power/Controller operates up to two 24 Vdc panic hardware devices individually or simultaneously. System also provides programmable timed lock release feature with 1-30 sec range, supervised lock outputs, and 2 programmable fire alarm disconnect options. For access control accessories, simultaneous 12 and 24 Vdc constant power outputs are also provided.

Atmel Corp.    San Jose, CA 95131
Apr 04, 2007 Based on 8051 X2 core which executes instruction in 6 clock periods, microcontrollers are offered in 32-pin 5 x 5 mm and 48-pin 7 x 7 mm QFN packages. Models AT83C5134/35/36 have 8-, 16-, and 32-Kb ROM code memory, respectively, while AT83EC5136/I5136 have 512-byte and 32-Kb EEPROM. Products feature USB Full-Speed controller, UART, SPI, and 2-wire interface.

Elma Electronic Inc.    Fremont, CA 94538
May 26, 2006 With sheet metal design and full pluggability, Type 39c HA Chassis are available in 1-4 U heights in horizontal-mounting orientations. Compliant to PICMG specifications and IEEE 1101.10/.11, enclosures feature side-to-side 200 cfm cooling, 300 mm depths, and rear I/O options. CompactPCI backplanes include pluggable 47-pin connectors for hot swapping power supplies. Pluggable fan tray headers and optional shelf management modules are available.

Atmel Corp.    San Jose, CA 95131
May 01, 2006 Based on AVR®32 core, AP7000 series 32-bit digital signal controllers integrate, on one chip, functionality required for multimedia systems. Features include vectored multiplier co-processor, 32 KB on-chip SRAM, memory management unit, peripheral DMA controller, and support for dynamic frequency scaling of 4 clock domains. Along with 16-bit stereo audio DAC, peripherals include TFT/STN LCD controllers, 480 Mbps USB 2.0 with on-chip transceivers, and two 10/100 Ethernet MACs.

NEC Electronics    Santa Clara, CA 95050
Mar 01, 2006 Based on WiMedia MAC and WiMedia MAC-PHY interface specifications as well as Wireless Host Controller Interface specification, uPD720170 enables wireless transmission of data between PCs and PC peripheral devices at 8 rates from 53.3-480 Mbps over 3 m range. It supports 4 data transfer types - control, bulk, interrupt, and isochronous - and can connect up to 32 physical devices simultaneously.

Deva Electronic Controls Ltd    Wirral CH41 1EL  United Kingdom
Aug 18, 2005 Deva 004 enables position, speed, and acceleration of 3 or 4 stepper driven axes to be controlled from PC-compatible computer. Hardware features include 32-bit expansion slot, 16 opto-isolated digital inputs, and 16 opto-isolated outputs, including 4 servo enable outputs. Closed loop controller with PID and velocity feed forward terms maintains control of axis position. Axis speed is set via 16-bit speed register, and axis position is derived from 24-bit position register.