Beckhoff Automation LLC
Minneapolis, MN 55337
Nov 06, 2009 Moisture- and dust-resistant, IP67-rated EP2338 EtherCAT® Box features 8 channels that can be used as inputs or outputs. Filter constant of inputs is 10 µs, while outputs, handling load currents up to 0.5 A, are short-circuit-proof and protected against inverse polarity. If channel is used as output, input is read back in parallel and can additionally be used for short-circuit analysis. Pre-assembled cables facilitate EtherCAT and signal wiring while preventing wiring faults.

Emerson Process Management, Rosemount Div.
Chanhassen, MN 55317
Nov 05, 2009 FOUNDATION(TM) Fieldbus Interface allows ControlWave® RTUs and ROC800-Series Remote Operations Controllers to access multiple variables over single pair of wires in point-to-point or multi-drop configuration. Efficiency is increased in oil/gas and water/wastewater applications through accuracy of digitally retrieved process data and diagnostic information provided to decision makers. Included software, Field Interface Configurator, facilitates setup and commissioning.

ViXS Systems Inc.
Toronto M2J 1R3  Canada
Nov 05, 2009 TransXmedia(TM) Low Power USB Stick Reference Design converts and streams multi-media content in various HD and Internet video formats on range of end devices. It enables manufacturers ablility to utilize 1,250 DMIPS application processor to offload CPU intensive tasks. Including Xtensiv(TM) USB software package, device is capable of multi-stream HD/SD media processing and supports HD/SD simultaneous output and multiple audio formats. Multiple encryption/decryption engines are also included.

Village Tronic
Wichita, KS 67205
Nov 04, 2009 With footprint of 1.7 x 2.8 x 0.9 in., ViBook Plus can drive up to 6 displays for Windows based computers and up to 4 for Mac OS. DL195 chip enables it to support resolutions of up to 1,920 x 1,200 in 16- and 32-bit color and play videos, including HD video streams. Unit is compatible with computer systems with USB 2.0 port and is supplied with Village Tronic multi-screen software that facilitates efficient arrangement of programs on each screen.

CommAgility Limited
Leicestershire LE11 3EH  Uruguay
Nov 03, 2009 Based on Xilinx Virtex-5 LX110T FPGA, single-width full-size Model AMC-V5F-10G is intended for wireless broadband and other demanding processing and optical data interfacing applications. Full Gigabit Ethernet infrastructure allows for system expansion, and additional optical data interfacing is enabled by dual SFP interfaces from FPGA. High-bandwidth connection to other AMC modules is provided by optional Serial RapidIO or PCIe links from FPGA to the AMC backplane.

Saelig Co., Inc.
Pittsford, NY 14534
Oct 29, 2009 Enabling users to connect I2C devices via USB port, IOW24-DG operates at 100 kHz and allows of up to 750 bytes/sec throughput. Handshaking via clock stretching is supported, along with programmable time-out function, to prevent dongle from hanging up due to malfunctioning slave devices. Comprised of assembled PCB, 4-wire cable, and 2-part snap-fit dongle case, product is sized to not block adjacent USB ports and available with 5 and 3.3 V outputs to power small external circuits.

ClearOne Communications, Inc.
Salt Lake City, UT 84119
Oct 28, 2009 Providing direct connection between Converge Pro audio conferencing systems and VoIP PBX phone systems, Converge® Pro VH20 enables users to transport audio signals across IP networks. VH20 links with any of ClearOne's Converge Pro products to create complete audio conferencing system that can be integrated with Cisco, Avaya, and many other VoIP PBX phone systems for 100% interoperability. Device ensures full security with TLS, AES, and SRTP encryption.

Fairchild Semiconductor
San Jose, CA 95134
Oct 20, 2009 Housed in 1.8 x 2.6 x 0.55 mm UMLP package, Model FSA800 handles USB data, stereo and mono audio, microphone, and UART data all on common connector port. Unit offers built-in charger detection and 28 V of overvoltage tolerance. Built-in termination resistors eliminate pop noise, while negative swing capability enables audio signals to swing below ground, eliminating need for AC coupling capacitors. Switch is suited for USB port isolation, connector sharing, and signal multiplexing.

New Scale Technologies
Victor, NY 14534
Oct 16, 2009 Custom auto focus modules accept standard M6-M12 threaded lens assemblies and feature digital (USB or I²C) as well as analog 0-3.3 V motion interfaces. Lens motion module uses SQUIGGLE® motor, TRACKERT position sensor, and integrated electronics to provide high-resolution, closed-loop control. Stroke is greater than 2 mm, velocity is rated to 7 mm/s, and respective values for position resolution and repeatability are 0.5 and 2 µm.

Advanced Micro Controls, Inc.
Terryville, CT 06786
Oct 16, 2009 Designed to bring linear displacement transducer (LDT) position sensor data into Allen-Bradley's ControlLogix PLC, 7252 LDT Interface Module can directly interface to 2 magnetostrictive sensors with PWM, control pulse, or start/stop signals. If required, module can use coordinated system time to generate interpolated position data value for high-speed applications. Latch inputs capture position data value, while onboard diagnostics monitor and report errors.

Watlow
St. Louis, MO 63146
Oct 15, 2009 Featuring EZ-ZONE® PM and EZ-ZONE RM integrated temperature controllers, PROFIBUS DP facilitates plant design and eliminates hard wiring. System features status LEDs, cycle read/writes up to 135 data points, and acyclic read/write capabilities. With generic station description file editor, users can create customized data exchange packets. Additional features include support for DP-Version 0 and 1 functionalities, 16 or 32 bit formatting, and independent temperature units in °C or °F.

OleumTech Corp.
Irvine, CA 92618
Oct 12, 2009 Offered in DIN rail package with 3.6 x 2.7 in. form factor, WM3000 lets users configure all of its 8 channels as any combination of inputs, outputs, or low-frequency pulse counters for industrial automation and process control applications. It supports Modbus RTU protocol over 2-wire RS-485 bus and can interface with any third-party Modbus master device. Scalable design allows for 247 expansion modules to be multi-dropped to one Modbus master device with RJ45 connector.

Dynamic Engineering Inc.
Ben Lomond, CA 95005
Oct 07, 2009 Customizable 1-lane PCIeBPMC and 4-lane PCIeBPMCx1 offer matched length, differentially routed, impedance controlled rear IO from Pn4. Model PCIeBPMCX1 (PCIe Bridge PMC 1 slot) adapter/carrier converter provides ability to install one PMC card into standard PCIe 4-lane slot. Products, offering auto selected or switch programmable speeds, are suitable for PCI or PCI-X operation with PMC; 32- or 64-bit data; and 33, 66, 100, or 133 MHz clock. Bridge can operate with 1-4 lanes active.

Beckhoff Automation LLC
Minneapolis, MN 55337
Oct 06, 2009 Suited for installation outside of control cabinets, EP1258 EtherCAT Box detects digital input signals with temporal resolution of 1 ns directly on machine. This allows reaction times to be shortened, independent of control cycle, while fast events can be detected and processed further without requiring special hardware. Featuring 8 digital inputs, box supports XFC (eXtreme Fast Control) technology in compliance with time stamp method.

GL Communications Inc.
Gaithersburg, MD 20877
Oct 06, 2009 As dual OC3/12 and STM1/4 PCIe card, LightSpeed 1000 may be used for protocol analysis and emulation of ATM, POS, RAW, and Ethernet traffic. It has 2 GB DDR2 RAM as well as GbE and USB 2.0 interfaces and comes with software for overall monitoring, BERT, emulation, and protocol analysis. Multiple cards can be accommodated in rack PC for simultaneous analysis of 4 or more signals, and all interfaces can capture and transmit at wirespeed to/from hard disk.

Powerex, Inc.
Youngwood, PA 15697
Oct 06, 2009 Model VLA536-01R is gate drive interface board in which control signals are isolated using high-speed optocouplers with 15 kV/µs common mode noise immunity. It provides 2,500 Vrms isolation for control power and signals, as well as isolated fault feedback signal if short circuit condition is detected. Measuring 101 x 64 mm, board includes CMOS-compatible input interface and mounts to dual NX IGBT modules. Unit operates from 15 Vdc power supply.

GOEPEL electronics LLC
Austin, TX 78759
Oct 02, 2009 Comprised of PXI-supported Interface Module (IFM) and offset Core Module (CM), PXI 5396/FXT-x supports structural JTAG/Boundary Scan Test and dynamic I/O operations up to 100 MHz for execution of functional tests in critical environments. Distance between modules can be up to 2 m without loss of performance, and 96 single-ended channels are configurable as input, output, and tri-state. Programmable from 1.8-5 V, I/O allows individual pull/up and pull/down adjustments for each channel.

GAO Instruments Inc.,
Toronto   Canada
Oct 02, 2009 Offering 4 parallel channels, with independent 20 MS/sec 12-bit A/D converter and independent programmable gain amplifier for each channel, model A0720002 PCI2712S parallel DAQ card features voltage signal acquisition ranges from 100 mV to 20 V. Sampling depth of each channel is up to 16 MS/sec. DAQ board with all-electronic calibration, is designed for transient signal recording, refined frequency synthesis, multi-channel parallel acquisition, and time-phase-sensitive acquisition.

ADLINK Technology Inc.
Irvine, CA 92618
Sep 29, 2009 Ampro by ADLINK MiniModule SIO, designed for Ampro by ADLINK CoreModule® 730, provides PC/104 interface as well as 4 serial ports, including 2 via DB-9 connectors supporting RS-232/422/485 and 2 via pin headers supporting RS-232. It also includes shared parallel port and floppy pin header, PS/2 mouse and keyboard pin headers, and 2 USB 2.0 ports. Ruggedized SUMIT I/O module measures 90 x 96 mm and operates in temperatures from -40 to +85°C.

Asset InterTech Inc.
Richardson, TX 75080
Sep 29, 2009 Model LGA1366 interposer enables engineers to access debug port on Intel® Xeon® Processor 5500 Series and Core(TM) i7 processors on circuit boards. It provides direct interface between CPU on board and PCT on ScanWorks® platform, which allows nonintrusive PCT tests, diagnostics, and debug routines to entire circuit board through Intel® processor, without need for physical probes on board. Product can also be applied to circuit board repair.