Phihong USA
Fremont, CA 94539
Aug 17, 2009 Designed to be mounted adjacent to Ethernet device, 21 W Series POE21-240 provides 24 V at 0.875 A for powering security cameras, wireless network access points, IP telephones, and IP servers. Gigabit-compatible unit divides power and data and converts PoE source to regulated DC power source. Available in non-vented case with 10BASE-T, 100BASE-T, and 1000BASE-T data rates, splitter is isolated from PoE source by 1,500 Vac and has full OCP and OVP-protection.

Phoenix Contact
Harrisburg, PA 17111 0100
Aug 17, 2009 Suited for integration into new or existing PLC, SCADA, or DCS systems, 900 MHz busable Trusted Wireless Ethernet (TWE) radio RAD-ISM-900-EN-BUS allows user to collect I/O without remotely located PLC or I/O data concentrator. Bused I/O is made accessible to network using MODBUS protocol, while multiple master function creates redundancy and wireless failover connections if master or host radio is not accessible. Applications include tank level, pressure, and temperature monitoring.

Analog Devices, Inc.
Norwood, MA 02062-9106
Aug 17, 2009 Operating up to 4.4 GHz, ADF4150 PLL synthesizer is capable of Fractional-N or Integer-N operation and has -222 dBc/Hz phase-noise figure. Model ADL5601/ADL5602 broadband RF/IF gain blocks, operating from 50 MHz to 4 GHz, integrate internal bias circuitry and are fully ESD protected. With 400-2,700 MHz operating frequency range, ADL5604 broadband 1 W driver amp consumes 325 mA current. As TruPwr(TM) rms power detector, ADL5902 measures signals with varying crest factors up to 9 GHz.

California Eastern Laboratories
Santa Clara, CA 95054
Aug 12, 2009 Measuring 2.0 x 1.35 x 0.4 mm, Model UPG2405T6Q helps enable embedded small form factor wireless designs. GaAs MMIC SP3T Switch features frequency range of 0.01-2.5 GHz and control voltage of +2.8 V. It can support Near Field Communications and RFID wireless systems, as well as Bluetooth and Wi-Fi devices. Switch is also applicable in ZigBee/802.15.4 products for automatic meter reading, wireless security, cable replacement, and lighting systems.

Microchip Technology, Inc.
Chandler, AZ 85224 6199
Aug 05, 2009 Supplied in 16-pin TSSOP, MRF49XA covers 434/868/915 MHz unlicensed Industrial, Scientific, and Medical (ISM) RF band. Compatibility with suite of development tools facilitates integration with any 8-, 16- or 32-bit PIC® MCU, enabling designs for various bidirectional, short-range wireless applications such as remote controls, remote meter reading, and home security/alarms.

L-Com, Inc.
North Andover, MA 01845
Aug 05, 2009 Covering frequency range of 750-2,700 MHz, Model SCW04N features 50 W power rating and is constructed from heavy-duty aluminum. Four-way signal splitter can be installed indoors or in weather-resistant enclosure. Unit is suited for 800/900 MHz cellular and ISM band operation and 1.8/1.9 GHz PCS cellular radio applications, as well as 2.3 GHz WCS band, 2.36 GHz CDMA band, and 2.4 GHz 802.11b/g/n applications.

Summit Data Communications, Inc.
Akron, OH 44311
Aug 05, 2009 Supporting both 802.11b/g and 802.11n, which operate in 2.4 and 5 GHz band, respectively, Model SDC-MCF10AG has compact flash interface while Model SDC-MSD10AG has SDIO interface. Because modules have same board connector and pin definitions as Summit's 2.4 GHz modules, AG modules provide smooth upgrade path from single-band to dual-band support. Units are Wi-Fi CERTIFIED(TM) and operate on Windows CE and Windows Mobile®.

L-Com, Inc.
North Andover, MA 01845
Jul 29, 2009 Covering frequency range of 750-2,700 MHz, SCW04N 4-way wireless splitter features 50 W power rating and is constructed from heavy duty aluminum. It is suited for 800 and 900 MHz cellular and ISM band operation, 1.8 and 1.9 GHz PCS cellular radio applications, as well as 2.3 GHz WCS Band, 2.36 GHz CDMA Band, and 2.4 GHz 802.11b, 802.11g, and 802.11n applications. Device is designed to be installed indoors or in weather-resistant enclosure.

Crystek Corporation
Ft. Myers, FL 33913
Jul 24, 2009 Operating from 2,416-2,553 MHz with typical step size of 100 kHz, CPLL66-2416-2553 is housed in compact 0.6 x 0.6 x 0.15 in. SMD package. It needs only external frequency reference and supply voltages for internal PLL and VCO and is programmed using standard 3 line interface (data, clock, and load enable). Phase noise is -90 dBc/Hz at 10 kHz offset with minimum output power of 3 dBm, VCO voltage is 5 Vdc, PLL voltage is 3 Vdc, and second harmonic suppression is -15 dBc typical.

International Manufacturing Services, Inc. (IMS)
Portsmouth, RI 02871
Jul 22, 2009 Measuring 0.375 x 0.250 in., VGX-3725WA high power aluminum nitride chip attenuator features wraparound terminals for solder or epoxy attachment and dissipates 100 W at 100°C baseplate temperature. Standard impedance is 50W and attenuation values to 30 dB are available with 0.5 dB increments. Attenuation accuracy starts at ±0.2 dB while achievable VSWR is 1.3:1 to 6 GHz depending on implementation.

EF Johnson Technologies, Inc.
Irving, TX 75038-2401
Jul 22, 2009 Supporting operation on APCO Project 16 SMARTNET/SmartZone as well as Project 25 trunked and conventional systems, 5300 ES Series integrate Enhanced (AMBE+2) Project 25 Vocoder for loud and clear digital audio. Features include over-the-air-rekeying and over-the-air-programming as well as support for up to 864 talkgroups, P25 Packet Data, and DES/DES-OFB/AES encryption algorithms. Lightning(TM) Control Head, featuring bright and clear display, is also offered in VHF and UHF bands.

Crystek Corporation
Ft. Myers, FL 33913
Jul 21, 2009 Featuring VCO wrapped around PLL in single package, CPLL66-1600-2200 operates from 1,600-2,200 MHz with typical step size of 1,000 kHz. It requires only external frequency reference and supply voltages for internal PLL and VCO, and is programmed using standard 3 line interface. Features include typical phase noise of -6 dBc/Hz at 10 kHz offset with minimum output power of +7 dBm, second harmonic suppression of -15 dBc typical, and VCO and PLL voltages of 12 and 3 Vdc, respectively.

National Semiconductor Corp.
Santa Clara, CA 95051-0695
Jul 15, 2009 Offered in series of 6 devices covering 31.6-4,000 MHz range, PowerWise® LMX2541 comes in 6 x 6 mm, 36-pin LLP® and provides less than 2 mrad rms noise at 2.1 GHz (3.5 mrad rms noise at 3.5 GHz). Device, which can be operated with up to 104 MHz of phase-detector rate in integer and fractional modes, integrates delta-sigma fractional-N PLL, VCO, divider, and output driver. Areas of use include local oscillator (LO) applications in basestation radio transceivers.

Z-Communications, Inc.
San Diego, CA 92126
Jul 13, 2009 Operating at 2,200 MHz, Model SFS2200C-LF features typical phase noise of -109 dBc/Hz at 10 kHz offset and typical sideband spurs of -70 dBc. Unit delivers output power of 6 dBm with VCO voltage supply of 5 Vdc while drawing 30 mA and phased locked loop voltage of 3 Vdc while drawing 11 mA over temperature range of -40 to 85°C. Housed in PLL-V12C package measuring 0.60 x 0.60 x 0.22 in., device features typical 2nd harmonic suppression of -10 dBc.

Z-Communications, Inc.
San Diego, CA 92126
Jul 13, 2009 Measuring 0.60 x 0.60 x 0.22 in., Model SFS2400C-LF features typical phase noise of -109 dBc/Hz at 10 kHz offset and typical sideband spurs of -70 dBc. Unit delivers output power of 6 dBm with VCO voltage supply of 5 Vdc while drawing 30 mA, and phased locked loop voltage of 3 Vdc while drawing 11 mA over temperature range of -40 to 85°C. Suited for satellite communication and fixed wireless applications, device features typical 2nd harmonic suppression of -10 dBc.

Z-Communications, Inc.
San Diego, CA 92126
Jul 13, 2009 Operating in C-band at 4,500 MHz, SFS4500A-LF features typical phase noise of -84 dBc/Hz @ 10 kHz offset and a typical sideband spurs of -65 dBc. RoHS-compliant product delivers typical output power of 2.5 dBm, with VCO voltage supply of 5 Vdc, while drawing 33 mA (typ) and phase locked loop voltage of 3 Vdc while drawing 15 mA (typ) over -20 to +80°C range. Typical 2nd harmonic suppression is -25 dBc, and PLL-V12N package measures 0.60 x 0.60 x 0.13 in.

Freewave Technologies, Inc.
Boulder, CO 80301
Jul 09, 2009 Due to RF propagation characteristics (430-470 MHz @ 2 W), LRS455 may be used in rugged and heavily treed terrain applications. Data rate of 19,200 bps throughput on 12.5 kHz channel and noise immunity levels complement long-distance SCADA applications, and included FreeWave Tool Suite provides integrated platform for all aspects of radio and network configuration and diagnostics. Radio offers 70 mile range with clear line of sight and supports use of repeater.

Comdel, Inc.
Gloucester, MA 01930
Jul 07, 2009 Accommodating up to 16 channels and programmable to any frequency between 2-60 MHz, VF Series modules provide phase adjustable output to avoid destructive arcing and cross-talk in multiple cathode plasma processing chambers. Phase of each channel can be adjusted to accuracy greater than 0.1° resolution. Allowing adjustment for cable length dependencies, modules are designed for solar thin film photovoltaics and semiconductor processing in RF-driven plasma systems.

K-Tek
Prairieville, LA 70769
Jul 06, 2009 Enabling transmitting of data between process sensors/DCS or SCADA systems, DX80 Wireless Transmitter and Receiver includes wireless transmitter node accepting up to 2 analog and 2 discrete switch inputs. Including wireless receiver gateway that accepts up to 55 nodes, system has embedded site survey tool which analyzes strength of radio signal between gateway and specified node. Housed in IEC IP67, NEMA 6 rated enclosure, product offers line of sight range of 3 miles.

RF Micro Devices, Inc.
Greensboro, NC 27409-9421
Jun 29, 2009 Utilizing Gallium Arsenide (GaAs) pseudomorphic high electron mobility transistor (pHEMT) technology, symmetric SPDT switches operate in multiple market segments, including cellular infrastructure, WiFi, WiMAX, and antenna tuning applications for mobile devices. Models RF3021 and RF3025 are housed in 16-pin 3 x 3 mm QFN package and feature high isolation and single-bit control. Offered in 6-lead SC70 package, RF3023 and RF3024 feature low insertion loss and moderate isolation.