Optical Transmitters

Communication Systems & Equipment, Optics & Photonics, Electrical Equipment & Systems

Ethernet over Coax Solutions facilitate analog to IP migration.

December 3, 2015

Cop-R-Com Ethernet over Coax (EoC) series enables existing coax infrastructures to be used for migration to IP-based systems. Along with transmission speeds of up to 1,000 Mbps full duplex, solutions offer extended range of up to 3,280 ft and PLC technology that accommodates multi-port receivers with integrated Ethernet gigabit switch technology. Security Link over Coax (SLOC) technology, also included, ensures compatibility with IP cameras from SLOC manufacturers. Read More

Test & Measuring Instruments, Communication Systems & Equipment

Optical Extenders target professional AV systems.

December 16, 2014

Using single fiber optic cable, Models DVI-7313 and DVI-7314 extend HDMI v1.4 signals with resolutions up to 4K/30p over cable distances of 1,640 ft and 1.2 miles, respectively. DVI-7313 supports Multi-Mode optical fiber, while DVI-7314 supports both Multi-Mode and Single-Mode fiber optic cable. By employing high-speed SerDes that combines DVI/HDMI signal channels into single uncompressed 10.3 Gbps bit stream, extenders enable transmission of signal over single wavelength. Read More

Computer Hardware & Peripherals, Communication Systems & Equipment, Optics & Photonics

Video Extenders deliver full HD-1080p and 3D video content.

May 10, 2013

Rack-mountable and hot-pluggable, Models VE882 and VE892 combine transmitter and receiver for extending HDMI, RS-232, and IR signals using single fiber optic cable. Model VE882 supports distances up to 2,000 ft, while Model VE892 is suitable for up to 12 miles. Each product utilizes unique FPGA design, which offers clock regeneration that ensures high-resolution video performance. Through small form-factor pluggable modules, models simplify maintenance process. Read More

Electrical Equipment & Systems, Communication Systems & Equipment, Optics & Photonics

CMOS 100G Transmitter PHY combines speed and low power draw.

March 25, 2013

Enabling high-capacity, 100G optical modules and line-card designs, BCM84128 is implemented in 40 nm CMOS process technology, consumes less than 2 W, and achieves aggregate data rate of 128 Gbps with four 32.1G lanes. Solution is designed for long-haul, regional, and metropolitan data transport and provides respective full- and half-rate clock outputs at 32 and 16 GHz. Features such as clock and data skew control adjust lane-to-lane skew and date-to-clock skew on line-side interface. Read More

Communication Systems & Equipment, Optics & Photonics

Fiber Optic Transmitters/Receivers serve microwave applications.

December 13, 2012

Optiva Satcom Band Microwave Fiber Optic Transmitters and Receivers offer band-specific C, X, Ku, or Ka transmitter and receiver modules compatible with EMCORE modular or flange-mount Optiva Platform configurations. Addition of Optiva Satcom Band RF Fiber Optic Transport System expands existing Optiva Platform that supports 50 MHz to 18, 22, or 40 GHz broadband microwave transport, reference oscillators, IRIG, IF, L-/S-band, plus audio, video, data, and Ethernet. Read More

Communication Systems & Equipment

Fiber Optic Link transports HDMI high-resolution video.

May 23, 2012

Fully compatible with all HDMI-compliant devices, Model FVT/FVRHDMI transmits HDMI signal over one multimode fiber up to 500 m for 1080p60 format. Unit is capable of transmitting uncompressed bi-directional communications with full HDCP copyright protection, EDID, and CEC connection functionality. Supporting all sync configurations, Model FVT/FVRHDMI transmits pixel-for-pixel images with full 24-bit scan rate and no picture degradation. Read More

Test & Measuring Instruments, Communication Systems & Equipment

Fiber-Optic NIR Transmission Probe has self-cleaning design.

March 14, 2012

Accommodating applications that experience gradual build up of particulate or other residue on exposed surfaces, FPT-850SCN has integral spray nozzle that can direct pressurized stream of liquid solvent or vapor at probe windows. Sealing technique, involving direct sapphire to metal welded pressure seal, ensures chemical resistance; only materials in contact with process are sapphire, high nickel alloys, and thin flash of gold or PTFE. Also, there are no optical fibers in probe. Read More

Electrical Equipment & Systems, Communication Systems & Equipment, Optics & Photonics

Low-Power Transponder Module delivers 100 Gbps performance.

November 29, 2011

MSA-compliant MI 8000XM employs PM-QPSK modulation format combined with coherent detection. Latter delivers scalability and flexibility needed for effective, efficient bandwidth transmission over fiber optic networks. Also included, low-power digital signal processor large-scale integrated (DSP-LSI) circuit offers correction of chromatic dispersion as well as polarization mode dispersion. Soft-decision forward error correction (SD-FEC) also enhances operation. Read More

Test & Measuring Instruments, HVAC, Sensors, Monitors & Transducers, Communication Systems & Equipment, Electronic Components & Devices

Temperature Sensors suit switch gear and bus bar monitoring.

November 10, 2011

Featuring DIN rail mount design, Model FTX-301 supports 3 fiber optic temperature inputs and includes 3 optically isolated 4-20 mA analog outputs, while Model FTX-302 is same device only without analog outputs. Both include industrial RS-485 serial bus for modbus communication to multiple daisy-chained devices. Providing real-time temperature data to 200°C, each device is configured and monitored via OSENSAView FTX software and direct USB connection to PC/laptop. Read More

Communication Systems & Equipment

Fiber Optic Transmitter is immune to pathological signals.

March 3, 2011

Available in card and box versions, Fiberlink® 3370 Series allows Ethernet and 2 channels of bi-directional RS-Type data along with SMPTE-compliant 3G/HD/SD-SDI to be transmitted over 1 single mode fiber or 2 multimode fibers. All data channels are available simultaneously and switches on transmitter allow operator to configure each of 2 pairs of data independently. Series is suited for broadcast studios, OB Vans, point-of-view cameras, medical imaging, stadiums, and transportation hubs. Read More

Electrical Equipment & Systems, Communication Systems & Equipment

DM 8G Transmitter/Switcher optimizes AV network performance.

October 12, 2010

DigitalMedia 8G(TM) (DM 8G) system, comprised of matrix switcher input and output cards and receiver/room controller, delivers one-wire transport over multimode fiber without signal scaling, compression, or hardware repeaters. Uncompressed digital signals, HDMI, DVI, DisplayPort, Ethernet, and USB keyboard/mouse control are seamlessly distributed up to 1,000 ft. While delivering 8 Gb pipeline for each input and output, system preserves native video resolution and audio format. Read More

Communication Systems & Equipment

Audio Transmitter/Receiver operate over long-distances.

September 10, 2010

ValueLine FVXATC1 Transmitter and FVXARC1 Receiver Series accommodate applications where standard line-level audio and contact need to be transported more than few hundred feet. Single line-level audio and contact closure signal are transmitted over one multimode or single mode optical fiber. Audio over fiber products suit applications such as public address announcements or those that require broadcast-quality audio. Read More

Communication Systems & Equipment, Green & Clean, Optics & Photonics

Fiber Optic Short Link Transceiver offers optimal galvanic isolation.

August 27, 2010

Occupying 13 x 33.56 mm footprint, 10 MBd HFBR-3810Z is suited for isolating frequency inverter and power converter applications in renewable energy installations. Fiber Optic (FO) short link technology pin-to-pin distance of 24.96 mm provides transient voltage suppression of 12 kV according IEC 60664-1. It also allows galvanic isolation on one PCB, promoting compact designs. DC coupled data link does not require data encoding or digitizing circuitry, and receiver has CMOS/TTL output. Read More

Communication Systems & Equipment, Optics & Photonics

Transmitter/Receiver Pair extends HDMI 1,000 ft over fiber.

April 15, 2010

Supporting HDMI 1.3a with deep color and 7.1 channel lossless audio, HD-TX3-F and HD-RX3-F transmitter/receiver pair extend uncompressed HDMI, analog audio, Ethernet, USB HID, and control signals up to 1,000 ft over single multimode fiber. Units manage EDID and HDCP, handle resolutions up to 1920 x 1200 and 1080p60, and are compatible with DVI and DisplayPort Multimode. Devices are housed in compact enclosures, which can mount to any flat surface or on one rail of equipment rack. Read More

Communication Systems & Equipment, Optics & Photonics

CCTV Video Transmitters/Receivers have self-healing feature.

June 26, 2009

Digital fiber optic video transmitters and receivers with bi-directional data include FVTFVR1010SHR single channel with data series, FVT/FVR4014SHR with 4 video and data channels, and FVT/FVR8018SHR with 8 video and data channels. In event of broken fiber connection, video and data transmission is seamlessly re-routed when system is configured in ring topology. Bi-directional data transmission allows for camera PTZ function to be controlled from any monitoring location. Read More

Computer Hardware & Peripherals, Controls & Controllers, Communication Systems & Equipment, Optics & Photonics

Optical Fiber Modules are based on 650 nm wavelengths.

December 8, 2008

Optical fiber transmitter and receiver modules, HFBR-15x5/25xx includes 4 models supporting SERCOS, Interbus and PROFibus standards. They are available with SMA and ST connector ports and are compatible with 1 mm POF/200µm HCS. Model HFBR-1505/AFZ/2505AFZ is designed for 10 MBd SERCOS, HFBR-1505CFA/2505CFZ supports 2 MBd Interbus-S, HFBR-1515BFZ/2515BFZ supports 10 MBd PROFIbus-S, and HFBR-1506AFZ/2506AFZ supports 16 MBd SERCOS. Models have operating temperature range from -40 to 85°C. Read More

Sensors, Monitors & Transducers, Communication Systems & Equipment

Fiber Optic IR Transmitters feature 1 msec response time.

August 19, 2008

With adjustable emissivity from .05 to .99, OS4000 Series industrial high speed fiber optic infrared transmitters are capable of measuring temperature from 392-2,912°F using 3 standard optical fields of view and 3 standard fiber optic cable lengths. CE compliant units feature built in laser sighting for lens probe positioning, linear analog output (1 mV/°, 0/5 Vdc, 0/10 Vdc, or 4-20 mA), fiber optic gain adjust, RS232 interface, and Windows based PC interface software. Read More

Communication Systems & Equipment

Video Transmitter is designed for multimode optical fiber.

July 2, 2008

Model FVT11-m is mini fiber optic video transmitter that converts single baseband video channel to optical signal and transmits it up to 2.5 km to fiber optic receiver, where it is converted back to baseband video for monitoring. Read More

Communication Systems & Equipment, Display & Presentation Equipment

Fiber Optic Transmitters incorporate 850 nm GaAlAs LED.

December 11, 2006

OPF670 Series LED transmitter family consists of OPF670 in TO-46 package, OPF672 in standard profile metal housing, and OPF673 in low profile metal housing, all designed to launch optical power into 50/125 µm or 62.5/125 µm diameter multimode fibers. Model OPF670 comes with plastic lens cap for active alignment into connector receptacle, and Models OPF672 and OPF673 are equipped with ST connector. Read More

Communication Systems & Equipment

Fiber Optic System operates at 1,310 nm wavelength.

October 17, 2006

RoHS compliant Pure Digital Fiberlink® 7220 Series digitally transmits high-resolution RGB and stereo audio over one single mode or multimode fiber optic core. Series is compatible with display devices that support VGA, SVGA, XGA and WXGA, and HDTV resolutions of 480p, 720p, and 1080i. Requiring no adjustments, equalization, or de-skewing, 7220 Series is used in applications such as digital signage, broadcast or corporate studios, auditoriums, stadiums, and theaters. Read More