SyChip    Plano, TX 75093
Jun 09, 2010 Supplied in 10 x 11.3 x 1.5 mm packages, WLBT8120 and WLBT8121 respectively conform to IEEE 802.11b/g WLAN and Bluetooth v2.0 with Enhanced Data Rate. Feature set for WLAN includes IEEE 802.11i security, QoS traffic prioritization, and sleep mode, while Bluetooth feature set includes v2.0 with EDR for optimal throughput and real-time data profiles. Targeting mobile phones and consumer electronics, modules provide 2 RF interfaces to support independent antenna configurations.

SyChip    Plano, TX 75093
Jun 09, 2010 Supplied in 10 x 11.3 x 1.5 mm package, WLBT8111/WLBT8112 dual radio module conforms to IEEE 802.11b/g wireless LAN and Bluetooth v2.0 with Enhanced Data Rate. Feature set for WLAN includes IEEE 802.11i security, QoS traffic prioritization, and sleep mode, while Bluetooth feature set includes v2.0 with EDR for optimal throughput and real-time data profiles. Targeting mobile phones and consumer electronics, module provides single RF interface to support shared antenna configuration.

ATEN International Co., LTD    Sijhih City,Taipei 221  Taiwan
Jun 08, 2010 Suited for use in business, entertainment, and education fields, VM0404H can route HD video and audio from any of 4 HDMI sources to any of 4 HDMI displays. It can also be cascaded with other units to provide up to 64 HDMI sources/displays. Remote control and front panel pushbuttons let user cycle through and select sources/displays, while bi-directional RS-232 serial interface allows system control through controller, PC, and/or home automation/theater software package.

Maxim Integrated Products    Sunnyvale, CA 94086
Jun 08, 2010 Model MAX2136 supports reception of signals as large as 10 dBm while maintaining sensitivity of -99 dBm, and acheives low noise figure of 3.8 dB while consuming 210 mW. Unit operates from 3 V supply and draws 70 mA when receiving either ISDB-T 13-segment or DVB-T signals. Featuring lead-free 5 x 5 mm, 32-pin TQFN package, it includes on-chip tracking filters, low pass filters, and low-noise amplifiers. Product is specified over -40 to +85°C temperature range.

Antenna Factor    Grants Pass, OR 97526
Jun 07, 2010 Featuring integral counterpoise that eliminates need for proximity ground plane, 2.4 GHz WRT antennas are available with U.FL connector terminations - miniature coaxial RF connectors intended for high-frequency signals. Antennas use 1.32 mm micro coax, and 19 x 11 mm radome, anchored by threaded base, installs through hole on product. Featuring adhesive foam compression ring that protects against elements, antennas suit applications requiring unobtrusive, tamper-resistant solution.

Harris Corp.    Rochester, NY 14610
Jun 07, 2010 Allowing customization of ground communications and expansion as requirements evolve, Mission Modules for Falcon III® AN/PRC-117G multiband manpack wideband radios add functions such as second wideband radio channel, high-frequency radio channel, and intelligence, surveillance, and reconnaissance (ISR) module. Modules also provide open platform and standard interface for generating future applications for radios, which offer frequency range of 30 MHz to 2 GHz.

Spectrum Advanced Specialty Products    Fairview, PA 16415
Jun 04, 2010 Designed for mating to spring loaded, compliant contacts, Rapid Mate Connectors provide rapid connection with low mating force, allowing for some misalignment during mating. Ruggedized units resist sand, dust, and water and are suitable for military and commercial communications systems, thermal and ambient light imaging cameras, docking stations, and scanners. Feed-through capacitors or Pi filters with selective loading and custom values are available.

Carlson Wireless Technologies, Inc.    Arcata, CA 95521
Jun 03, 2010 Designed for utility and enterprise markets, Trailblazer(TM) Star incorporates Carrier Class Voice service and SCADA capabilities into one enclosure. Multipoint system offers variety of interface options, including 4-wire, serial ports, PA, intercoms, emergency phones, and Ethernet. Available in 2.3-2.5, 5.x, and 4.9 GHz frequencies, TB-Star is transparent to all existing PBX, TDM, or VoIP systems; provides Carrier Class telecom service beyond 50 miles; and has fixed latency of less than 4 ms.

Quintech Electronics and Communications Inc.    Indiana, PA 15701
Jun 03, 2010 Suited for use in LTE, Wimax, and 4G test applications, LTE 3000 16 x 16 passive full fan-out matrix switch allows any of 16 inputs to be routed to any or all outputs. Switch can be controlled via front panel or remotely via web browser interface. Providing replacement for patch panels, switch ensures no signal degradation in lab environments.

Texas Instruments, Inc. (TI)    Dallas, TX 75243-4136
Jun 03, 2010 Model TLK6002 enables continuous data rate support from 470 Mbps up to 6.25 Gbps for wireless applications. Using single 122.88 or 153.6 MHz fixed reference clock frequency, IC can support Common Public Radio Interface (CPRI(TM)) and Open Base Station Architecture Initiative (OBSAI) rates, and automatically self-tunes to each. It has 20-bit parallel single-ended interface that connects to FPGAs. Receiver equalization and transceiver pre-emphasis enable trace reach of over 50 cm.

Eltek Limited    Cambridge   United Kingdom
Jun 03, 2010 Able to receive information from sensors relayed via Eltek transmitter unit over distances up to 2,000 m, WSR (Wireless Sensor Receiver) converts incoming data into voltage signals that are then fed directly to DAQ or process control system. Self-contained, mains-powered receiver and output unit, available with 8 or 16 I/O, incorporates LCD that shows real-time metering of sensor values. Built-in batteries provide 48 hr of operation in case of mains failure.

ABB Instrumentation    Warminster, PA 18974
Jun 02, 2010 Designed to unlock stranded information in existing HART devices, loop-powered FieldKey Wireless Adapter allows users to remotely monitor and configure instrumentation assets. Users can establish communications via WirelessHART protocol that supports frequency channel hopping. Protocol automatically builds mesh network that can re-route communication paths to overcome blocked signals. Encrypted messaging based on AES 128-bit banking standards provides secure communication.

Advanced Micro Peripherals    New York, NY 10001
Jun 02, 2010 VGASTANAG module converts non-interlaced VGA output of up to 1,280 x 1,024 SXGA resolution from any standard graphics source to STANAG 3350-compliant signals. All three STANAG frequencies - Class A/B/C - are available in standard or extended temperature versions of this PCI-104 form factor module, and no device driver software is required. In addition to timing generator, features include analog signal digitization, video scaling, frame rate conversion capabilities.

Texas Instruments, Inc. (TI)    Dallas, TX 75243-4136
Jun 02, 2010 Suited for wireless headphones and speakers, PurePath(TM) CC8520 features 2.4 GHz system-on-chip that transmits uncompressed CD-quality wireless audio over RF link with no unwanted noise or dropouts. Unit coexists with Bluetooth®, WLAN, and other 2.4 GHz devices and features low latency for optimal synchronization between audio and video. Housed in 6 x 6 mm QFN-40 package, 2-channel transceiver supports 16-bit, 44.1 KHz or 48 KHz audio without any compression.

Freewave Technologies, Inc.    Boulder, CO 80301
Jun 02, 2010 Model FGR2-PE spread spectrum radio offers 2 ports each of active serial and Ethernet wireless connectors for long distance communication in Smart Grid applications. It also provides AES encryption and low power consumption, making it suitable for remote use. Industrial-grade, small, rugged enclosure offers mounting and installation options. Radio is suitable for use in alternative energy markets as well as SCADA applications in markets such as water/wastewater and oil and gas.

Alps Electric    Raleigh, NC 27607
Jun 01, 2010 All-in-One WLAN Module UGFZ1 Series features built-in CPU as well as GS1011 chip with antenna, Wi-Fi protocol, and connection applications. Integrated UART physical interface, ADC, I²C, PWM, and GPIO analog/digital port allow connection with devices such as humidity and lighting sensors. Devices/systems not originally equipped for networking can be WLAN-enabled via unit's serial interface connection. Product operates for up to 10 yr on AA type lithium thionyl chloride battery.

Dicon Fiberoptics Inc.    Richmond, CA 94804
Jun 01, 2010 Qualified to Telcordia GR-1221, Multi-Mode Optical Switch features MEMS technology and is made with multimode 50 or 62.5 µm core fiber. Unit consumes less than 700 mW of electrical power when controlled with I2C or RS-232, or 1.5 W when controlled via TTL. Packaged in 90 x 55 x 12.5 mm housing, switch withstands shock and vibration, temperature cycling, damp heat, and dry heat, making it suitable for military and avionics customers.

Solartron Metrology    Gastonia, NC 28054
Jun 01, 2010 Orbit3 allows users to build large, flexible sensors and gauging systems with single common interface, regardless of sensor technology. Sensors are hot-swappable and up to 200 probes can be connected to network card. System features RS485 multidrop communications link and T-Con 9-pin lockable connectors that channel output of each I/O device to receiver electronics. Other features include accuracy to 0.05% of reading and local LED diagnosic display for each unit.

Tripp Lite    Chicago, IL 60609
May 28, 2010 Enabling control of up to 4 computers from one monitor, keyboard, and mouse, model B006-VUA4-K-R can be mounted in 19 in. rack or used directly on desktop. KVM console, connected peripherals, and audio can be independently switched, making it possible to work on one computer while printing from second and listening to audio from third. Specific interfaces include 2-port USB 2.0 hub, 3.5 mm audio jacks, and on-screen display that provides 2-level security for administrator and 4 users.

Z-Communications, Inc.    San Diego, CA 92126
May 27, 2010 Operating at 3,900 MHz, model SFS3900A-LF has typical phase noise of -88 dBc/Hz @ 10 kHz offset and typical sideband spurs of -65 dBc. RoHS-compliant product delivers typical output power of 3 dBm with VCO voltage supply of 5 Vdc while drawing 33 mA (typ) and PLL voltage of 3 Vdc while drawing 15 mA (typ) over -40 to 85°C range. Supplied in 0.60 x 0.60 x 0.13 in. PLL-V12N package, synthesizer offers typical second harmonic suppression of -20 dBc.