Ventilation Equipment

HVAC, Fluid & Gas Flow Equipment

Dryer Vents boost efficiency and safety.

August 26, 2015

Available in 3 magnetically aligning models, Dryer Vents resist crushing and obstruction, allowing dryer to operate at optimum efficiency. Self-aligning Models MV-180 and MV-90 are designed for straight vent path and 90° vent path, respectively, while MV-Flex is designed to accommodate any direction venting. All are available for new and existing construction. Read More

HVAC

Solid-State CPU Cooler combines efficacy and small form factor.

August 24, 2015

Supporting use in diverse enclosure types, 4.3 x 3.5 x 3.5 in. HEX 1.0 features SilverCore™ technology and dedicated control board. Latter provides Variable Assist Cooling, which combines heat pump with electronic control hardware and firmware to respond to changing CPU load and ambient conditions, maximize thermal performance, and minimize noise. Tested to TDP levels >175 W, CPU cooler features 80 mm fan with fully enclosed blades and fan heatsink with integrated solid-state heat pump. Read More

HVAC

Oil Mist Collector removes ultra-fine mists and fumes.

August 20, 2015

Built to operate 24/7, Handte Oil Expert offers separation efficiencies up to 99.97% on 0.3 micron and larger particles. First-stage coarse mesh filter separates out large particles and chips, followed by 2 stages of Camfil APC CoaPack diffusion filters. Design combines high efficiency separation with self-cleaning capability via drainage of separated cooling lubricant. Processes served include turning, drilling, milling, roughing, grinding, broaching, honing, rolling, deep-drawing, and pressing. Read More

Fluid & Gas Flow Equipment, HVAC

Air Filter features washable, reusable design.

August 19, 2015

Combining benefits of open cone filter and air box in one unit, K&N Apollo Filter Renault Duster is suitable for aspired engines up to 250 hp and turbo engines up to 350 hp. Unit has smooth internal features to help minimize air turbulence and maximize air flow. Outer shell, made of lightweight materials, helps keep incoming air cool, while hose with specially designed radius finish cap directs cooler outside air into engine. Read More

HVAC, Green & Clean

Energy Recovery Ventilator is AHRI certified and ETL listed.

August 7, 2015

Utilizing total energy core, Model ECV provides 500–1,000 cfm of preconditioned fresh outdoor air for commercial/institutional applications. Energy core technology, applied to building's ventilation system, reduces heating and cooling loads to promote energy conservation. Hinged doors facilitate maintenance access to internal components and control center, while optional controls – economizer bypass damper, BMS communication, and Vari-Green® motors – further enhance energy conservation. Read More

HVAC, Mounting & Attaching Products

Outdoor Duct System features pre-insulated design.

August 4, 2015

Engineered for exterior and rooftop applications, Q Duct™ requires no additional weatherproofing or insulation. System is custom-fabricated using 2 layers of rigid UL 181 Pal phenolic core material, faced on both sides with coated aluminum and exterior multilayered laminate jacketing material. Interior and exterior layers resist mold, mildew, UV, and extreme weather conditions. Delivered preassembled to jobsite, Q Duct does not emit VOCs or toxic gases and contains no microfibers, CFCs, or HCFs. Read More

HVAC

Packaged HVAC Units offer 2-5 ton capacities.

July 27, 2015

Offering heating and cooling solution for residential and light commercial buildings, Champion LX Series fits most roof frames and slabs, and features exact-match gas and electric hookups that save time during installation. Single-cabinet units include copper tube/aluminum fin condenser coils, slide-out evaporator coil, tubular stainless steel gas heat exchanger, single-stage compressor, and single-stage gas heat. Using just 2 screws per corner, removable base rails optimize installation. Read More

Chemical Processing & Waste Management, Materials & Material Processing, HVAC

Quench/Scrubber Systems treat contaminants from high-temp sources.

July 20, 2015

Available as complete ScrubPac™ Custom Skid-Mounted systems in sizes capable of handling gas capacities from 500–150,000 cfm, Hi-TScrub™ Quench/Scrubber Systems utilize Bionomic advanced horizontal or vertical configuration atomized spray and venturi gas quenchers to cool corrosive hot gas streams up to 2,600°F before scrubbing. Cooled gas with acid vapors, halogens, or particulate is removed with Bionomic Series 5000 Packed Tower or Series 7000 Venturi Scrubber. Read More

HVAC

Explosion-Proof HVAC System provides customizable climate control.

July 16, 2015

ATEX-compliant HVAC system provides all-in-one automatic climate control for walk-in style process analytical instrumentation shelters. Customizable and scalable to suit diverse applications, unit handles ventilating, heating, cooling, dehumidifying, air filtering, purging, and pressurization within hazardous area up to zone 1. Heating and cooling capacities are available from 6 kW upwards, and system can be supplied fully integrated within shelter or as external standalone unit. Read More

HVAC

Emulsion Mist Collectors combine efficiency, 24/7 performance.

July 6, 2015

Featuring automatic sprayer that counteracts emulsion clumping, Handte EM Profi cleans up contaminants generated during machining processes that utilize emulsion mist coolants. Long-life coarse and fine filter demisters, followed by final-stage HEPA filter, offer 99.9% efficiency on particles 0.3 micron and larger. While basic modules handle air volumes from 1,700–8,000 cfm and can be combined for larger airflow requirements, space-saving models are offered for 500–1,400 cfm applications. Read More

HVAC, Green & Clean

Thermal Dampers feature Class 1 and 1A leakage rates.

July 1, 2015

Employing thermally insulated and broken aluminum airfoil blades and thermally broken aluminum channel frame, TICD Series eliminate transfer of cold or heat and reduce condensation while providing air control in medium- to high-pressure and -velocity applications. Products feature AMCA Certified Leakage of Class 1 (12.6 cfm/ft² @ 10 in. wg at 60 in. wide) and Class 1A (3 cfm/ft² @ 1 in. wg at 60 in. wide) and comply with International Energy Conservation Code. Read More

HVAC

Plug Fan provides 125,000 cfm capacity.

June 30, 2015

Offered in Sizes 18 through 60, ECF Plug Fan utilizes ECF-9 airfoil wheel to optimize flexibility, helping users select correct unit for specific application requirements. Class 2 and 3 models are available with pressure to 13 in. SP and temperature capabilities to 200, 450, 800, and 1,000°F. Accessories/options include 316 and 347 stainless steel construction, inlet guard, shaft/bearing guard, belt guard, integral inlet cone assembly, and ceramic felt shaft seal. Read More

HVAC

Ceiling Air Diffuser will not rust in damp environments.

June 30, 2015

With Quick Connect™ center knob, HAVACO 2 x 2 ft Plastic T-bar Drop-in 3-Cone Supply Grille enables easy removal of two center cones for cleaning, making it suitable for restaurants that need to clean grease off ceiling diffusers. Users turn knob and cones drop out for cleaning in sink. Base cone can be wiped out with degreaser spray and cloth. In addition to restaurants, damp environments such as spas and locker rooms will not have to replace diffusers often or use stainless steel models. Read More

HVAC, Optics & Photonics

Cable Blowing Machine installs micro fiber cable.

June 24, 2015

Engineered to install micro fiber cable into pre-installed 0.157–0.708 in. diameter microduct, Whisper Micro Cable Blower can place 0.078–0.334 in. diameter cable at speeds up to 260 fpm. Product features integral air valve, pressure gauge, and electronic monitoring system that provides digital read-outs of speed and distance. Operated by single person, portable Whisper is suited for both interior and exterior fiber cable placement applications. Read More

Fluid & Gas Flow Equipment, HVAC, Material Handling & Storage

Compressed Air Filters exhibit minimal pressure differential/loss.

June 23, 2015

Deep-pleat KE (KAESER Extra) aerosol filters achieve residual aerosol content of 0.01 mg/m³ and saturation differential pressure of no more than 200 mbar. Range covers 4 element grades for filtration of aerosols, dust, and oil vapors so that compressed air can be treated to suit needs of specific application in accordance with ISO 8573-1 purity classes. Suitable for pressures up to 16 bar at temperatures of up to 66°C, there are 9 model sizes for flow volumes from 21.2–501.5 cfm. Read More

HVAC, Green & Clean

HVAC Systems combine energy efficiency and comfort.

June 23, 2015

Intended for residential and light commercial markets, Champion HVAC Systems come in variety of tonnages, fuel sources, and configurations. Heating and cooling equipment is rated in accordance with AHRI Standard 210/240 and 340/360 at AHRI conditions. Product line also meets relevant ASHRAE 90.1, ENERGY STAR®, and EPACT 2005 standards. Read More

HVAC

Air Measuring Dampers provide accurate control.

June 17, 2015

To control airflow volumes to target set point, thermal dispersion-based AMD-TD series combines functionality of thermal dispersion airflow station and control damper. Vari-Green® airflow measurement probes and transmitters enable airflow measurement down to 100 fpm. While factory-supplied controllers are available with analog or BACnet MS/TP operation, optional factory-supplied controller makes series turn-key solution. There are 4 models that feature various blade styles. Read More

Chemical Processing & Waste Management, Fluid & Gas Flow Equipment, HVAC, Green & Clean

HVAC Air Filter features energy efficient design.

June 5, 2015

Rated A+ by Eurovent, Hi-Flo F7 50+ Bag Filter is made of glass-fiber media with conical shaped pockets. Aerodynamic design prevents filter pockets from overlapping each other or coming in contact with filter housing, optimizing airflow through filter. Green thread used for stitching has been chosen for its ability to handle strong airflows. For easy identification, media grade and minimum efficiency are printed on each pocket. Read More

HVAC

Round Dust Collectors feature integrated cam-lock canister.

June 4, 2015

Suited for vacuum applications and other high-pressure conditions, Schust Round Collectors can operate with pressures as low as -70 in. of water column. Units feature mobile, self-centering, cam-lock canister that seals directly to collector housing, eliminating need for rotary valve. Compact bottom load bag configuration provides space savings for indoor applications. Stainless steel construction is available. Read More

HVAC, Laboratory and Research Supplies & Equipment

Ductless Fume Hoods offer optional BACnet network interface.

June 2, 2015

Available in 5 standard sizes from 30–69 in. wide, Purair ECO™ Fume Hoods are designed for both chemical and particulate protection over broad range of laboratory and industrial applications. Energy-efficient ductless containment cabinets minimize stress on facility HVAC systems without compromising protection for personnel and environment. Hoods are available with choice of controllers, including ECOair™ touchpad control with color display interface. Read More