Philips Lumileds Lighting Company
San Jose, CA 95131
May 17, 2013 Combining 2 LED chips in one package with 3535 form factor, LUXEON 3535 2D, rated at 100 mA, helps designers reduce LED count in retrofit lamps, consumer downlights, and diffuse industrial lamps. LED operates at 0.5–1 W, delivering up to 130 lm and achieving efficacy of 140 lm/W for cool white light at 4000K and 80 CRI min. Available to address linear and omnidirectional lighting applications, LUXEON 4014 low-power, rectangular LED measures 4.0 x 1.4 x 0.7 mm and achieves 160 lm/W efficacy.

Broadcom Corp.
San Jose, CA 95110
May 14, 2013 Optimized for power-intensive Ethernet network applications, 40 nm BCM54290 Series features AutoGrEEEn® Plus technology, which extends energy savings to legacy MACs and non-EEE devices. Technology can be deployed when device is in Energy Efficient Ethernet mode communicating with EEE link partner or when linked to non-EEE enabled device. In addition to precision 1588 time synchronization, multi-port devices provide Y.1731 latency performance monitoring and 1 ns 1588 PTP time stamp resolution.

Mounting Systems
West Sacramento, CA 95605
May 07, 2013 Consisting of pre-packaged versions of Sigma II open terrain photovoltaic substructure, Sigma II GO Kits feature inclination angle of 25° and are ready to be installed on ballast blocks or concrete piers. Units accept all 60-cell crystalline modules and are intended primarily for installations up to 50 KW. Supplied with Professional Engineer certification, Sigma II GO Kits are available in either low load, for up to 90 mph wind/0 psf snow, or high load for up to 120 mph wind/30 psf snow.

MaxLite
West Caldwell, NJ 07006
Apr 30, 2013 Intended for installation in T-bar or drop-in ceilings, ArcMAX™ Volumetric LED Panels deliver low-intensity, reformative optic technology to evenly disperse light output, minimize glare, and avoid pixelation patterns. Units are available in 1 x 4 and 2 x 2 ft models rated at 42 W as well as 2 x 4 ft model rated at 60 W. Offering 3,500, 4,100, and 5,000 K CCTs, panels feature stainless steel housing and reflectors, angled interior end caps, and polycarbonate milky white diffuser cover.

Texas Instruments, Inc. (TI)
Dallas, TX 75243-4136
Apr 29, 2013 Housed in 14-pin, 5 x 6 mm TSSOP package, Model bq34z110 supports multi-cell lead-acid battery packs with battery voltages of 4–64 V. Impedance Track™ algorithm constantly informs user about battery's state-of-health and state-of-charge and maintains up to 95% accurate capacity measurement for entire life of battery. Gauge supports batteries used in mobile and stationary applications such as medical instruments, wireless base stations, e-bikes, inverters, and UPS systems.

Lumex Inc.
Carol Stream, IL 60188
Apr 19, 2013 Available in 405 nm (purple) wavelength, TitanBrite 2W UV LED (SML-LXL8047UVC series) produces 18 lm and comes in 8 mm round top dome SMT (surface mount) package that promotes space conservation. RoHS-compliant product, featuring 100° viewing angle, meets needs of space-constricted applications that require bright, intense light and low energy consumption. Specific areas of use include medical, security, water, and food processing applications.

Vishay Intertechnology, Inc.
Malvern, PA 19355 2143
Apr 05, 2013 Offered in flame-retardant plastic case with epoxy resin seal, Model MKP386M features capacitance range of 0.047–10 µF, operation to +105°C, and 7 voltage ratings from 700–2,500 Vdc and 420–800 Vac. Device reduces voltage and current spikes caused by switching of IGBTs, which are sources of EMI. With pulse strength to 2,500 V/µs and peak current capabilities to 1,850 A, metallized polypropylene film capacitor is suited for power/frequency converters, solar inverters, and wind power motor drives.

Exar Corp.
Fremont, CA 94538
Apr 03, 2013 With operating input voltage up to 18 V, PowerBlox™ XRP7674 achieves better than 90% efficient conversions for output current as low as 50 mA. Synchronous current mode PFM/PWM buck regulator operates at fixed 340 kHz switching frequency, with output voltage adjustable down to 0.925 V and ±2% accuracy across operating range. Housed in RoHS-compliant, halogen-free 8-Pin SOIC package, regulator is suited for set-top boxes, telecom, computing peripherals, and distributed POL conversions.

MaxLite
West Caldwell, NJ 07006
Apr 02, 2013 LED Post Top Retrofit Lamp, offered in medium and mogul bases, replaces metal halide or high-pressure sodium light sources in existing fixtures to increase energy efficiency and lower maintenance requirements. Designed for post-top outdoor lighting applications, 36 W LED lamp is available in cool 6500K CCT and delivers 360° optical design. Sealed body is constructed of aluminum to provide thermal protection and effective transfer of heat from LEDs, extending operational life.

Texas Instruments, Inc. (TI)
Dallas, TX 75243-4136
Apr 02, 2013 Comprising 4.5 A output, 20 V input-rated switch-mode chargers with I2C interface, bq2419x Series achieves 92% efficiency at 2 A and up to 90% efficiency at 4 A of output current. Fast-charge circuits minimize charge time through battery path impedance compensation, while programmable thermal management capability ensures safe system operation. Housed in 4 x 4 mm QFN package, ICs include integrated battery discharge MOSFET with low on-resistance of 12 mΩ.

Texas Instruments, Inc. (TI)
Dallas, TX 75243-4136
Mar 27, 2013 Used with WEBENCH® online design tool, LM5023 simplifies and accelerates high-voltage DC/DC designs. This isolated quasi-resonant PWM controller with integrated 700 mA driver offers efficiency up to 90% and consumes less than 10 mW in standby. Output voltage regulation accuracy of 1% over line, load, and temperature eliminates need for cable compensation. Supplied in 8-pin MSOP, controller offers quasi-resonant operation that improves efficiency while lowering EMI emission.

Analog Devices, Inc.
Norwood, MA 02062-9106
Mar 25, 2013 Housed in 4 x 4 mm LFCSP package, Model ADP1051 targets high-density, isolated DC-to-DC power supply systems with parallel/redundant capability. Controller features 6 PWM logic outputs that can be programmed using GUI via PMBus interface. Device enables high energy efficiency topologies including full bridge and active clamp forward variants with precision drive timing and control of secondary synchronous rectifiers. Energy efficiency is further optimized using adaptive dead-time compensation. 

Transphorm Inc
Goleta, CA 93117
Mar 22, 2013 Based on EZ-GaN™ technology, 600 V Total GaN™ TPH3006PS HEMT comes in TO-220 package with low on-state resistance of 150 mΩ and low reverse-recovery charge of 54 nC. Also available in industry-standard TO-220 packages, TPS3410PK and TPS3411PK GaN diodes offer 6 A and 4 A operating currents, respectively, with forward voltage of 1.3 V. Applications include power supplies and adapters, PV inverters, motor drives, and power conversion for electric vehicles.

Precision, Inc.
Minneapolis, MN 55430
Mar 19, 2013 Combining resonant inductor and transformer into single package, LLC Transformer is available in power ranges from 100–800 W. Resonant power conversion topology minimizes switching losses by promoting zero voltage switching, minimizing unnecessary power dissipation in switches. Power dissipation can be lowered to as little as 5%, ensuring 99% transformer efficiency and 95% overall efficiency. Applications include LED/LCD TVs, industrial LED lighting, and AC/DC power converters with PFC front end.

Broadcom Corp.
San Jose, CA 95110
Mar 18, 2013 Meeting FCC requirements, BCM7576 HD cable digital-transport adapter (DTA) SoC enables North American cable operators to provide enhanced basic digital HD services and deliver user features to compete with IP and OTT video service providers. Functionality also enables enhanced experiences for consumers, with fast channel change, advanced UIs, and IP video streaming. Device delivers up to 4 simultaneous programs by directly digitizing entire 1 GHz cable spectrum.

Littelfuse, Inc.
Des Plaines, IL 60016
Mar 15, 2013 Providing high energy absorption capability and resistance to temperature cycling, LV UltraMOV™ Series protects low voltage DC applications against peak surges, including lightning strike interference, system switching transients, and abnormal fast transients from power source. RoHS-compliant units are lead-free, halogen-free, and available with optional phenolic coating. Operating up to 125°C, varistors are suited for LED lighting drivers, mobile phone chargers, and security systems.

MaxLite
West Caldwell, NJ 07006
Mar 12, 2013 Featuring 300° beam angle, Omnidirectional A19 LED Lamps produce soft, uniform light in all directions. Dimmable 7 and 10 W lamps replace 40 and 60 W incandescent bulbs, respectively, and maximize lumen maintenance by using multi-layered tapered heat sink to draw heat away from LED chips. Available in standard Edison and GU24 bases, LED bulbs are suited for use with table and floor lamps, wall sconces, chandeliers, pendants, and other ceiling fixtures.

Vishay Intertechnology, Inc.
Malvern, PA 19355 2143
Mar 12, 2013 Housed in SSOP-4 mini-flat package, Series VOS618A and VOS617A feature DC input currents of 1 mA and 5 mA, respectively. Units have GaAs infrared emitting diode, which is optically coupled to silicon planar phototransistor detector. SSOP-4 package provides 3,750 Vrms isolation voltage rating, half lead pitch of 1.27 mm, and creepage/clearance distance of ≥5 mm. Offering CRT ranges from 40–600%, devices protect users from electrical shocks and microprocessors within systems from voltage spikes.

LEDtronics, Inc.
Torrance, CA 90505
Mar 01, 2013 Able to replace incandescent bulbs up to 60 W while consuming 13 W, DEC-A19F-13W-XIW-120AWD DécorLED™ Series can operate from 100–120 Vac supply, produces 956 lm, and has 80+ CRI. Warm white (3000K), bulb supports drop-in installation in existing 26 mm Edison screw-in base sockets and has average lifespan of 50,000+ hr. Construction features UV-stabilized polycarbonate lens over high-brightness LEDs encapsulated around grill-style, heat-sinking, magnesium-alloy housing.

Quantum Materials Corp.
Novato, CA 94949
Feb 19, 2013 Developed to meet worldwide concerns regarding nanoparticle biocompatibility and sustainability, NHM-TPQD Tetrapod Quantum Dots are non-heavy metal, cadmium-free, and non-REE. Dots will spur development of products and applications in next-generation displays, sensors, biomedical research, diagnostics and drug delivery, security and conductive inks, solid-state lighting, and photovoltaic solar cells.