SC100 Pump Controller features a 4-digit, 7-segment digital display.
Press Release Summary:
SC100 Pump Controller features push buttons helps to simulate the level, scroll through the parameters, and to change the parameter settings. Unit offers scaling range of 4-20 mA level input signals. Controller comes with pump up/pump down, lag delay and forcing the lead pump position features.
Original Press Release:
M.P. Electronics Has Changed the Look of Their SC100 Controller!
M.P. Electronics has modified their SC100 Pump Controller to have the same operator interface as its SC1000 and SC2000 Pump Controllers. As can be seen in the picture, the new SC100 has a 4-digit, 7-segment digital display and push buttons to simulate the level, scroll through the parameters, and to change the parameter settings.
The new model SC100 can now be scaled for the desired level range by scaling the 4-20mA level input signal to the range desired for display on the unit.
Other features, such as pump up/pump down, lag delay, forcing the lead pump position, and selecting the # of pumps present are now also parameter selectable.
The SC100 is a lower cost alternative to the SC1000 and SC2000 family, designed for duplex stations with analog level control that do not require the horsepower and additional features of the SC1000 and SC2000 pump controllers.
As with all pump controller designs by M.P. Electronics, the SC100 is simple to use, and field setup is done in just a few minutes, allowing stress free installation and start-up.
