Workpiece Holding Clamps use sharp edges for gripping.
October 1, 2008 -
Comprised of cam screw and hardened washer, Knife Edge Clamp is made of hardened steel and features sharp edges to optimize grip on castings and rough cut material. Low-profile product is suited for clamping castings because it follows contour of workpiece for optimal holding, and tightening workpiece is accomplished with ¼-turn of screw. Available with 3/8-16, ½-13, and 5/8-11 size screws, clamp helps increase production and conserve space.
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
Original Press release
Mitee-Bite Products Inc.
340 Rte. 16B, P.O.box 430
Center Ossipee, NH, 03814
USA
Mitee-Bite Knife Edge Clamps
Mitee-Bite cam action edge clamps are well known for fast strong clamping, leaving the top surface unobstructed, and low cost per clamp.
Now Mitee-Bite Products, Inc. introduces the "Knife Edge Clamp" for clamping castings and rough cut material. This clamping element, made of hardened steel and having sharp edges to BITE into the material, retains its low profile and small size. The Knife Edge Clamp is ideal for clamping castings because it always follows the contour of the workpiece for maximum holding.
Knife Edge Clamps are available in three sizes, 3/8 -16, ½ - 13 and 5/8 -11 screws. The clamp, simply comprised of a cam screw and hardened washer, tightens a workpiece with a quarter turn of the screw.
To increase production and save space use the Mitee-Bite Knife Edge Clamp for your castings and rough cut material.
For more information contact Mitee-Bite Products Inc., Center Ossipee, NH.
|
|
|
|
|
|
|
| 
