Vertical Machining Center fits in crowded shop floors.December 27, 2010 -
Featuring 86.7 x 87.2 in. footprint, Model DNM 400A handles parts up to 25.0 x 17.1 x 20.1 in. and 881 lb. Machine is powered by 15 hp spindle motor that drives ISO No. 40 taper tools at speeds up to 8,000 rpm, while delivering 52 lb-ft of torque. Rapid traverses are 1,181 ipm along all 3 axes. Equipped with 20-station, double-arm ATC, system changes tools in 1.3 sec. Big Plus dual-contact tooling system creates full contact along spindle taper and toolholder flange.
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
Original Press release
Doosan Infracore America Corp & Eng Center
8 York Avenue
West Caldwell, NJ, 07006
USA
New Machining Center
West Caldwell, NJ - Doosan Infracore introduces the DNM 400A vertical machining center, designed for high productivity with precision tolerances, and built to fit the most crowded shop floors - and all at a price below $70,000.
The DNM 400A's rugged, one-piece casting is strategically ribbed to prevent distortion during heavy or interrupted cuts. Fine grain Meehanite is selected for its superior dampening characteristics and ability to dissipate heat. Widely spaced linear guideways give excellent support to the saddle in all locations, regardless of the table's load distribution. Each guideway is induction hardened and precision ground. Rapid traverses are 1181 ipm along all three axes.
Powering the DNM 400A is a 15 Hp spindle motor that drives ISO#40 taper tools at speeds up to 8,000 rpm, while delivering 52 ft. lbs of torque. The cartridge-type spindle is supported by precision-class, permanently-lubricate bearings. A heavy-duty drive belt eliminates slippage, reduces vibration, and contributes to thermal stability.
A 20 station, double-arm ATC changes tools in a quick 1.3 seconds. The Big Plus dual-contact tooling system creates full contact along the spindle taper and the toolholder flange. This assures maximum rigidity for greater precision and longer tool life. Both Big Plus and standard tool holders can be mounted at any ATC station with no need for special adaptors.
The 86.7" x 87.2" footprint is perfect for buildings with standard 8' x 8' doors. Maximum part size is 25.0" x 17.1" x 20.1" and 881 lbs.
Additional features of the economical DNM 400A include rigid tapping capability, an auger-type chip conveyor, cooling and lubrication systems, a program and data protection key switch, and a portable manual pulse generator with movement in increments of x1, x10, and x100 to make fixture or part alignments quick and easy. The color controller is a Fanuc Oi-MD.
|
|
|
|
|
|
|
| 
