VPX Load Board (6U) verifies power and cooling capabilities.
July 30, 2010 -
Helping system designers verify where to optimally redirect airflow to prevent overheating, 6U VPX Load Board helps confirm chassis meets VITA 46/48 power specifications for VPX and also aids in locating hot spots within enclosure. It applies load to power supply for verification and creates necessary heat to confirm chassis cooling. MCU-based stepped load control is rated to 100 W max, and Go-No-Go indicators are present for 3.3 V, 5 V, 12 V, +12 V_Aux, -12 V_Aux, and 3.3 V_Aux.
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
Original Press release
Elma Bustronic
44350 Grimmer Blvd.
Fremont, CA, 94538
USA
Bustronic Releases 6U VPX Load Board
FREMONT, California - Elma Bustronic Corporation, an industry leading designer and manufacturer of high performance backplanes has announced a new 6U VPX Load Board. The load board helps confirm the chassis meets the VITA 46/48 power specifications for VPX and aids in locating hot spots within the enclosure.
The 6U VPX version is the latest in Bustronic's family of load boards. This includes a 3U VPX form factor style announced in 2009, VME64x/VME, CompactPCI, and AMC (MicroTCA) formats. The load board helps test a system's cooling capabilities by first applying the load to the power supply for verification and creating the necessary heat to confirm chassis cooling. By locating hot spots in the chassis, a system designer can verify where to optimally redirect the airflow to prevent overheating.
The 6U VPX load card features a microcontroller-based stepped load control to 100W maximum. Go-No-Go indicators are present for 3.3V, 5V, 12V, +12V_Aux, -12V_Aux and 3.3V_Aux. The rotary switch selects the voltage setting while pushing the ON switch will cycle between different power levels shown on the LED display. The set load power levels are saved in EEPROM. Other features include a power reset button (to minimum level) and a SYSRESET signal on the two test point outputs.
Bustronic is also planning a conduction-cooled version in the coming months. The company also offers VPX backplanes, chassis, test extender boards, and SerDes test units.
The lead- time is 2-3 weeks ARO.
About ELMA BUSTRONIC:
Founded in 1989, Elma Bustronic specializes in the design and manufacture of high-performance backplanes. Elma Bustronic has a complete line of industry-standard backplanes, including CompactPCI, VME, VME64x, H.110 CT, VXI, VXS, and ATCA. Elma Bustronic's custom design service combines creative engineering, highly sophisticated computer simulation and modern design techniques to offer customized backplanes that meet the most specialized system requirements. A member of the ELMA Electronic group, Elma Bustronic is located in Fremont, California. Elma Bustronic is a member of PICMG(TM), VITA, and the StarFabric Trade Association and can be found on the World Wide Web at www.Bustronic.com.
|
|
|
|
|
|
|
| 
