Utility Cutters utilize square shoulder insert edges.April 22, 2005 -
Utility Cutters maximize effects of APET and XPET Inserts by utilizing areas not typically used in 90° square shoulder milling. BCSM Back-Corner Shell Mill allows unused corner to be used for general 15° face milling, providing 4 usable edges per insert. CMEM Chamfering End Mill delivers free-cutting, positive geometry for 30° and 45° chamfer milling.
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
Original Press release
Dapra Corporation
66 Granby St.
Bloomfield, CT, 06002
USA
Dapra's New Utility Cutters Make The Most of Square Shoulder Insert Edges
Dapra Corporation's new Utility Cutters maximize the benefits of APET and XPET Inserts by utilizing areas of the inserts that are not typically used in 90 degree Square Shoulder milling. The BCSM Back-Corner Shell Mill allows the unused corner to be used for general 15 degree face milling, providing four usable edges per insert instead of two. The CMEM Chamfering End Mill provides a free-cutting positive geometry for both 30 degree and 45 degree chamfer milling.
For complete information on these cost-saving Utility Cutters, please contact Dapra Corporation at 800-243-3344 or at info@dapra.com. Additional data on the Utility Cutters, as well as the APET and XPET Inserts, can also be found on the company's Web site: www.dapra.com.
|
|
|
|
|
|
|
| 
