Urethane Coating provides high temp corrosion resistance.
October 16, 2013 -
Applied in 4.0 mil wet film thickness that dries to 2.0 mils, Corr-Paint™ CP2010 provides corrosion resistance on copper and steel components and structures exposed to oxidation and corrosive atmospheres up to 400°F. Single-part, aluminum-rich formula dries and cures at room temperature to hard, non-porous, abrasion-resistant surface. With viscosity of 300-600 cP and specific gravity of 1.08 g/cc, product is also resistant to wide range of acids, bases, fuels, and solvents.
|Original Press Release |
Aremco Products, Inc.
707 Executive Blvd., Unit
Valley Cottage, NY, 10989
New Corr-Paint CP2010 Provides High Temp Corrosion Resistance
Corr-Paint™ CP2010, a new aluminum rich, high performance coating developed by Aremco Products, Inc., is now used to provide high temperature corrosion resistance on copper and steel components and structures exposed to oxidation and corrosive atmospheres to 400 ºF (204 ºC).
Aremco's Corr-Paint™ CP2010 is a single part, aluminum rich, low viscosity, urethane coating that dries and cures at room temperature to a hard, non-porous, abrasion resistant surface. CP2010 is resistant to a wide range of acids, bases, fuels and solvents, and has also survived long-term salt fog, salt spray and humidity testing of over 1000 hours.
Corr-Paint™ CP2010 is supplied with a viscosity of 300-600 cP, specific gravity of 1.08 g/cc, and solids by volume of 66.0%, and solids by weight of 70.0%. It is typically applied in a 4.0 mil wet film thickness that dries to approximately 2.0 mils. The theoretical coverage rate in a 1.0 mil dry film is 1058 ft2/gal.
Corr-Paint™ CP2010 can be used in combination with Aremco's Corr-Prep™ CPR2000, a solution that is used to prepare extremely smooth surfaces for coating. CP2010 can also be applied directly to severely rusted surfaces found in many maintenance and repair applications. Application methods include brush, roller or conventional pneumatic spray equipment.
Typical applications include the coating of OEM components such as motor housings, bag houses, cyclones, hoppers, pipelines and precipitators, to the coating of large structures found in MRO applications throughout the power, pulp and paper, and chemical processing industries.
CP2010 is available from stock in pint, quart, and gallon quantities. Please contact Aremco's Technical Sales Department for more information about this advanced coating.