Triaxial MEMS DC Accelerometers measure from 2-200 g.
November 14, 2011 -
Suited for both commercial and military applications, 7503A Series feature micro-machined MEMS capacitive sensing element housed in hermetically sealed titanium case. Units combine integrated VC accelerometer chip with high drive, low impedance buffer for low-level acceleration measurements. Operating from +9 to +32 VDC power, accelerometers offer low-end frequency response down to DC (0 Hz), with upper frequency range of 400-2,500 Hz with differential output.
Original Press release
Dytran Instruments, Inc.
21592 Marilla St.
Chatsworth, CA, 91311
USA
Dytran Instruments Introduces High Precision Triaxial MEMS DC Accelerometers, 7503A Series
Chatsworth, California, USA - Dytran Instruments, Inc. (www.dytran.com) a leading manufacturer of piezoelectric and DC MEMS accelerometers, force and pressure transducers and associated electronics, has introduced the 7503A series, a family of high precision triaxial MEMS DC accelerometers designed for use in both commercial and military applications. The 7503A series accelerometers combine a micro-machined MEMS capacitive sensing element housed in a hermetically sealed titanium case to deliver reliable performance in harsh conditions.
Tailored for zero-to-medium frequency applications, the Dytran 7503A series combine an integrated VC accelerometer chip with high drive, low impedance buffer for low-level acceleration measurements. Offered with a choice of seven different sensitivities and available in measurement ranges between 2g and 200g, these highly accurate accelerometers offer a low-end frequency response down to DC (0 Hz), with an upper frequency range between 400 and 2,500 Hz with differential output.
Units are rugged to 5,000g shock and operate from +9 to +32 VDC power. The module contains three separate variable capacitance accelerometers configured orthogonally for X, Y, Z outputs and low noise electronics, with a 5/16-32 radial connector and easy mounting via two #4 or M3 screws.
Recommended accessories for the 7503A series include the model 6956A eight conductor cable assembly, 9-pin plug to (3) D-SUB connectors and model 4010 signal conditioner. The Dytran model 4010 is a microprocessor controlled, 3-channel DC signal conditioner amplifier designed for use with bridge-type or differential output accelerometers and pressure sensors.
For more information about the 7503A series other products available from Dytran, or to order online, visit www.dytran.com.
|
|
|
|
|
|
|
| 
