Toxic Gas Detector features low power design.
June 11, 2010 -
Suited for continuous monitoring for wide range of toxic gases, SmartWireless(TM) DM-100 provides 2-wire loop powered 4-20 mA current signal equivalent to range of detected concentration of gas. It comes in XP and intrinsically safe electro-polished 316 stainless steel housing fitted with ¾ in. NPT thread, and has non-intrusive operator interface with automated calibration. Accessories include field replaceable transient protection circuit, alarm relay board, and current to Modbus(TM) converter.
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
Original Press release
Detcon, Inc.
P.O. Box 8067
The Woodlands, TX, 77387 8067
USA
Model DM-100 Provides Low Power Gas Detection
The Woodlands, TX - Detcon's new Model DM-100 SmartWireless(TM) gas detection sensors are low power devices designed to detect and continuously monitor a wide range of toxic gases. All sensors provide a 2-wire loop powered 4-20 milliamp current signal equivalent to the range of the detected concentration of gas. The DM-100 features intelligent electronics and a non-intrusive operator interface with automated calibration and comprehensive fault diagnostics. The sensor is packaged in an electro-polished 316 stainless steel housing fitted with a ¾ inch NPT thread. All electronics are fully encapsulated in the sensor housing adding a high level of durability to the design. Packaging is XP and intrinsically safe. Additional accessories include a field replaceable transient protection circuit, a loop powered digital display, an alarm relay board, and a current to Modbus(TM) converter.
For more information contact sales@detcon.com or visit www.detcon.com
|
|
|
|
|
|
|
|
