Structural Methacrylate Adhesive produces clear bond line.
October 8, 2008 -
With mixed viscosity of 22,000 cps, Clear Welder(TM) two-part adhesive is formulated to produce clear bond line on various plastics including acrylics, PMMA, FRP, ABS, PVC, and PETG. It requires little or no surface preparation, has typical hardness of 82 Shore D, and withstands service temperatures from -67 to 200°F. Available in 380 mL co-axial cartridges, unit is mixed as dispensed in 10:1 ratio with manual/pneumatic dispensing gun and attains functional cure in 2 hr at room temperature.
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
Original Press release
ITW Devcon Environmental Products
30 Endicott St.
Danvers, MA, 01923
USA
New Adhesive Produces Crystal Clear Bond Line
DANVERS, MA - Clear Welder(TM), a two-part structural methacrylate adhesive from ITW Devcon, is specially formulated to produce a crystal-clear bond line on a variety of plastics including acrylics, PMMA, FRP, ABS, PVC, and PETG. It requires little or no surface preparation. Ideal for the assembly of signs and display cases, it is also suitable for a multitude of other applications where a clear bond line is desired. UV stable, it will not discolor or craze when exposed to sunlight.
Available in 380-ml co-axial cartridges, Clear Welder(TM) is mixed as dispensed in a 10:1 ratio with a manual or pneumatic dispensing gun. With a mixed viscosity of 22,000 cps, it is easily applied and self-leveling. Clear Welder(TM) has a working time of 4-6 minutes and a fixture time of 12-16 minutes and attains functional cure in 2 hours at room temperature. Fully cured, it has a typical hardness of 82 Shore D and withstands service temperatures from -67° to 200° F.
For more information, contact:
Bruce Hanson
Marketing & National Accounts Manager
ITW Devcon,
30 Endicott Street, Danvers, MA 01923
Toll-Free: 1-800-933-8266
TEL: (978) 777-1100,
FAX: (978) 774-0516
oeminfo@devcon.com
www.devcon.com.
|
|
|
|
|
|
|
| 
