Stepper Motor Controller has resolution of 1,600 step/rev.
July 6, 2009 -
Supplied as 57 x 57 mm PCB, SMC75 offers everything required to solve modern control task as standalone controller or controlled from PLC/PC via serial commands or I/O. It incorporates RS485 and CANbus serial interface as well as 8 I/Os that can be configured as inputs, outputs, or analog input - controllable via nanoPLC and MacTalk graphic programming. MODBUS RTU and CANopen facilitate and accelerate connection to PLC, while ActiveX/OCX driver is available for PC or IPC.
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
Original Press release
JVL USA/Motion Control Sales Ltd.
8610 Morrow-Rossburg Rd.
Morrow, OH, 45152
USA
Stepper Motor Controller from JVL
JVL, now represented in Ohio, USA, presents a step motor controller with RS485 and CANbus serial interface. 8 IO's can be configured as inputs, outputs, or analogue input that can be controlled via a nanoPLC and MacTalk graphic programming. The very compact 57x57mm PCB contains everything required to solve a modern control task either as a stand-alone controller or controlled from a PLC or PC via serial commands or IO. MODBUS RTU and CANopen give the possibility for easy and fast connection to a PLC. For PC or IPC an ActiveX/OCX driver is available for simple interfacing to LABview, Excel, VB or other Windows programs. The SMC75 uses the same protocol as the MAC motors and can therefore be connected to the same RS485 bus system.
NanoPLC with 8 IO at 24V
RS485 up to 962 kbit
CANopen DSP 402
MODBUS RTU
Resolution 1600 step/rev.
Pulse/Direction mode
Supply 12-48V DC
Motor current 0-3Amp RMS
Dual supply for safe emergency stop
ActiveX/OCX driver available
The PCB can be built into a separate instrument or mounted directly on the back of the motor thus providing a cost-effective solution. Alternatively it can be delivered by JVL in a box with cables or M12 connectors, for mounting in a bottom plate or DIN rails.
Further information can be obtained from:
JVL International o Att: Mike Fisher o Motion & Control Sales Ltd.
8610 Morrow-Rossburg Rd o Morrow o OH 45152-9444
E-mail: mfisher@jvlusa.com o Tel.: 513/877-3134 oTel.: 513/282-0888 (Tech Support Line) o Fax: 513/877-2471 www.jvlusa.com
|
|
|
|
|
|
|
| 
