Solenoid Valve Connectors feature modular design.
June 3, 2009 -
Available in Mini, ISO, and Sub-Micro versions, Series 5000 protective enclosures are intended for electrical connection in conjunction with hydraulic and pneumatic solenoid valves. Modular design facilitates use where rapid installation and service are required. While ISO and 8 mm Sub-Micro versions connect valves using DIN 43650/ISO 4400 and EN175301-803:2000 specification, Mini and 9.4 mm Sub-Micro connectors are industry standards.
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
Original Press release
Canfield Connector
8510 Foxwood Ct.
Youngstown, OH, 44514
USA
Solenoid Valves Feature Modular Design
Canfield Connector's Series 5000 solenoid valve connectors are protective enclosures for electrical connection in conjunction with hydraulic and pneumatic solenoid valves. Available in Mini, ISO, and Sub-Micro, their modular design offers the advantage over standard "hardwired" solenoid valves because they can be used where rapid installation and service are required. The ISO and 8mm Sub-Micro connectors connect valves using the DIN 43650/ISO 4400, EN175301-803:2000 specification and the Mini and 9.4mm Sub-Micro connectors are industry standards. These specifications permit industry interchangeability which has been embraced by the solenoid valve industry worldwide. Versions can either be pre-wired at the factory or wired into existing installations. Most are CSA approved for the US and Canada and all versions are NEMA 4 and IP/65 environment rated.
Canfield Connector's Series 5000 solenoid valve connectors are proudly manufactured in the USA to ISO 9001with the highest design quality standards. Complete specifications can be found at www.canfieldconnector.com or by calling Bob Howard at 330-758-8299 x 122.
|
|
|
|
|
|
|
| 
