Silicone-Rubber Molding Compound has high-temperature formulation.
February 16, 2011 -
EZ-Cast(TM) 580N is used to fabricate high tear strength, flexible molds for casting ceramic fixtures. Silicone-rubber molding compound features maximum temperature resistance of 400ºF, Shore A Durometer of 40, tensile shear strength of 700 psi minimum, and tear strength of 110 lb-in. minimum. Supplied as 2-part system that mixes in ratio of 10 lb resin to 1 lb catalyst, product sets in 24 hr at room temperature or in 4 hr at 120ºF. It is available in pint, quart, and gallon kits.
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
Original Press release
Aremco Products, Inc.
707 Executive Blvd., Unit
Valley Cottage, NY, 10989
USA
EZ-Cast 580N Flex Molding Compoind Now Available
Valley Cottage, NY
SUMMARY
EZ-Casttm 580N, a new high temperature silicone-rubber molding compound produced by
Aremco Products, Inc., is now used to fabricate high tear strength, flexible molds for casting ceramic fixtures.
FEATURES
EZ-Cast(TM) 580N is a high temperature, flexible, high tear strength silicone-rubber molding compound ideal for producing high reliability master molds for casting ceramic fixtures. Material properties include a maximum temperature resistance of 400ºF (204ºC), Shore "A" Durometer of 40, tensile shear strength of 700 psi minimum, and tear strength of 110 minimum lb/in.
EZ-Cast 580N is supplied as a two-part system that mixes in a ratio of 10 lbs resin to 1 lb catalyst. It sets in 24 hours at room temperature or in 4 hours at 120ºF.
EZ-Cast 580N is available from stock in pint, quart, and gallon kits.
Please contact Aremco's Sales Engineering Department for more information about this
advanced new molding compound.
|
|
|
|
|
|
|
| 
