Signal Conditioning Module works with inductive transducers.September 30, 2008 -
Supplied in IP68 die-cast aluminum alloy housing, Universal Conditioning Module provides signal conditioning for range of analog inductive transducer types. It has current requirement of less than 10 mA and can be linked and synchronized with up to 50 modules in one network for multiple channel measurement systems. Flexible setup lets users adjust excitation voltage and frequency, operating mode, span output, and zero position as well as configuration for multiple synchronization.
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
 Additional information provided by manufacturer
Original Press release
Penny & Giles
12701 Schabarum Ave.
Irwindale, CA, 91706
USA
Penny & Giles Launches New Universal Conditioning Module for Inductive Transducers
Christchurch, UK - July 29, 2008 - Penny + Giles, designer and manufacturer of high precision position sensors, has launched a new Universal Conditioning Module (UCM) that provides reliable signal conditioning for a wide range of analogue inductive transducer types. The module can work with any manufacturer's transducer and is suitable to drive 4, 5 or 6 wire differential LVDTs, ratiometric LVDTs and 3 wire inductive half bridge transducers (or RVDT equivalents).
UCM has a low current requirement of less than 10mA and can be linked and synchronized with up to 50 modules in one network for multiple channel measurement systems. The UCM provides a simple 0.5 to 4.5Vdc analogue signal output, or by using additional module cards, into a variety of different voltage ranges, a current output, or digital PWM output. It normally operates from an unregulated 10 - 30Vdc supply.
The set-up is flexible, allowing users to adjust excitation voltage and frequency, operating mode, span output and zero position, as well as configuration for multiple synchronization. The unit is housed in a rugged die-cast aluminum alloy housing, suitable for harsh environmental conditions and electrically noisy installations, with EMC Immunity to 100V/m. The housing features an impressive environmental performance, with dust and fluid protection to IP68 and submersion to two meters. UCM is simple and easy to install. It is designed to be mounted on a bulkhead close to the transducer by using M5 screws through the mounting holes that are located under the housing lid. The supply, output and transducer connections are routed through two IP68 rated cable glands that can accommodate cable diameters of between three and eight mm.
For further information contact:
Mike Iles, Penny + Giles Controls Ltd, 15 Airfield Road, Christchurch, Dorset. UK. BH23 3TG. Tel : +44 (0) 1202 409409. email : mike.iles@pennyandgiles.com
About Curtiss-Wright Controls Integrated Sensing
Penny + Giles is a global leader in the design and manufacture of specialist avionics equipment, position sensors and control hardware for industrial, military and aerospace markets. Headquartered in Christchurch, Dorset, United Kingdom, Penny + Giles is part of Curtiss-Wright Controls Integrated Sensing, a business unit of Curtiss-Wright Controls, Inc. For more information, visit www.pennyandgiles.com
About Curtiss-Wright Controls, Inc.
Headquartered in Charlotte, North Carolina, Curtiss-Wright Controls is the motion control segment of Curtiss-Wright Corporation (NYSE: CW). With manufacturing facilities around the world, Curtiss-Wright Controls is a leading technology-based organization providing niche motion control products, subsystems and services internationally for the aerospace and defense markets. For more information, visit www.cwcontrols.com.
|
|
|
|
|
|
|
| 
