Safety Railing Kit comes with pre-assembled uprights.
Safety Railing Kit comes with pre-assembled uprights. |
|
|
January 19, 2006 -
Kwik Kit® safety barrier system, used around areas where personnel access should be restricted due to safety concerns, complies with OSHA and BOCA standards. Requiring hex key to tighten set screws to assemble unit, product is put together by placing supplied horizontal rails through pipe fittings on pre-assembled uprights. Pipe fittings are supplied as Kee Klamp® malleable cast-iron or Kee Lite® aluminum, and 1.9 in. OD pipe is powder-coated in safety yellow finish.
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
Original Press release
Kee Safety, Inc. (formerly Kee Industrial Products, Inc.)
100 Stradtman St.
Buffalo, NY, 14206-2665
USA
Kee Industrial Products Introduces New Kwik Kit® Safety Railing Kits with Pre-Assembled Uprights for Faster, Easier Installation
(January 2006) - Kee Industrial Products, Inc., Buffalo, New York announces the introduction of its new Kwik Kit® safety railing kit featuring pre-assembled uprights to reduce installation time. Kwik Kit is a safety barrier system used around machinery and equipment or in other areas where personnel access should be restricted because of safety concerns. The new Kwik Kit with pre-assembled uprights complies with OSHA and BOCA standards, and includes 1.9" O.D. pipe that is powder-coated in an attractive, safety yellow finish.
Kee Industrial states that Kwik Kit can be assembled quickly by placing the supplied horizontal rails through the pipe fittings on the pre-assembled uprights and using only a hex key to tighten the set screws. No welding, threading or drilling is required, and Kwik Kit may be secured using bolts or chemical anchors attached to the base fittings. The pipe fittings can be specified as either Kee Klamp® malleable cast-iron, or Kee Lite® aluminum, structural slip-on pipe fittings. Both Kee Klamp and Kee Lite fittings are corrosion-resistant.
The rails included with Kwik Kit may be cut-to-size where shorter sections are desired. The entire kit is pre-packaged with six-foot post spacing and available in a straight section kit, corner section kit, and an extension kit. The company states that the six-foot post spacing yields a lower system cost-per-foot for safety railing.
For free literature and additional information, contact Kee Industrial Products, Inc., 100 Stradtman Street, Buffalo, NY 14206. Toll-Free: 800-851-5181. Phone: 716-896-4949. Fax: 716-896-5696. E-Mail: info@keeklamp.com. URL: KeeKlamp.com.
Please address reader service inquiries at the above address to:
April Stack, Marketing Coordinator, E-Mail: astack@keeklamp.com
(E-mail inquiries to fsanfillipo@keeklamp.com)
For additional information and electronic files, contact:
Kenneth A. Boos, Account Executive, Harold Warner Advertising, Inc.
Phone: 716-852-4410 o Fax: 716-852-4725 o E-Mail: extra@haroldwarner.com
|
|
|
|
|
|
|
| 
