Pump Controller is field programmable.

Press Release Summary:




NEMA 4x, set-point Model APC100 suits submersible pump applications when analog sensors are used for level detection. Signal selection ranges are 4-20 mA, 0-5 V, and 0-10 V. Controller offers full duplexing action for pump-up/pump-down functions, 2 relay outputs for level alarm indication, 2 meters to log hours of operation, run and fail status contacts, 2 runtime meters, 2 local HOA switches, and programmable time-delay function to sequence restart after power failure.



Original Press Release:



The APC100 duplexing pump controller



Lancaster, PA, Automatic Timing & Controls Instrumentation Division...The APC100 duplexing pump controller is a cost-effective, field-programmable, NEMA 4X set point controller for submersible pump applications when analog sensors are used for level detection. Standard options include a wide range of signal selection (4..20ma, 0..5V and 0..10V), full duplexing action for pump up / pump down functions, two relay outputs for over / under level alarm indication, two meters to log hours of operation, run and fail status contacts, two run time meters, two local HOA switches for easy troubleshooting, programmable time delay function to sequence restart when the power fails. The pump controller features the following options: analog outputs as well as serial for fault / status communication to PLCs and SCADA systems; strobe light or flasher with incandescent bulb; seal and temperature switch fault detection.

For more information contact:
Dean Garwick, Project Manager
800-441-8245, ext. 238 or
dgarwick@automatictiming.com.
Web: www.automatictiming.com.

All Topics