Press Fit Plunger accepts ball and nose type press fits.December 29, 2003 - Product uses same body as press fit ball plunger combined with spring plunger nose, allowing for interchangeability of ball and nose type press fits. Spring plunger nose is used when longer travel is needed. Plunger can be used when threaded adjustments are not required. It is available in 6 diameters from 1/8–½ in. with 2 spring pressures, steel or stainless steel.
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
Original Press release
Northwestern Tools Inc.
3128 Valleywood Dr.
Dayton, OH, 45429 3938
USA
Northwestern Tools, Inc. is Introducing a New Type of Press Fit Plunger
Northwestern Tools, Inc. is introducing a new type of press fit plunger. By using the same body as our press fit ball plunger, and combined it with a standard spring plunger nose, allows for interchangeability of the ball and nose type press fits. The spring plunger nose is used when longer travel is needed. These press fit plungers can be used when threaded adjustments are not required. These are available in six popular diameters from 1/8" thru 1/2", in two spring pressures, steel or stainless steel.
For additional information contact Northwestern Tools, Inc., 3130 Valleywood Drive, Kettering, OH, 45429, 937-298-9994, Fax 937-298-3715
www.northwesterntools.com krichardson@northwesterntools.com
|
|
|
|
|
|
|
| 
