OEM Panel-Mounted Spring Gage weighs 0.99 lb.
July 28, 2009 -
Measuring 7 x 1.4 x 3.5 in., Tiger CNC mounts directly on control panel of spring coiling machine. Digital gage allows spring manufacturers to sort springs directly through coiler's electronics without requiring separate computer interface. Unit is available with 2 software packages: Tiger and Super Tiger.
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
Original Press release
Larson Systems Inc
10073 Baltimore St N.E.
Minneapolis, MN, 55449
USA
Larson Systems Launches First OEM Panel-Mounted Spring Gage
MINNEAPOLIS, MINN.-Hot on the heels of the release of its new Tiger Spring Gage, Larson Systems announces the introduction of the Tiger CNC, the first OEM panel-mounted spring gage.
Measuring just 3.5 inches high by 7 inches wide by 1.4 inches deep and weighing a mere .99 lbs., the Tiger CNC mounts directly on the control panel of a spring coiling machine. The digital gage allows spring manufacturers to sort springs directly through the coiler's electronics-a separate computer interface is not required. Operators don't have to understand capacitance measurement-the Tiger CNC does it for them.
The Tiger CNC is available with two software packages (Tiger and Super Tiger) that give it comparable functionality to Larson's Lynx (Tiger) or Panther (Super Tiger) gages. Much faster than previous gages, the Tiger CNC uses standard LION protocols setups and techniques and is compatible with all LSI probes and sorters.
Minneapolis-based Larson Systems Inc. has been the leader in the spring-testing industry since 1979.
Contact:
Bruce Hill, Larson Systems Inc.
763-780-2131
brucehill@larsonsystems.com
|
|
|
|
|
|
|
|
|
| 
