Multi-Unwind/Rewind System features cantilevered design.October 29, 2009 -
Cantilevered Multi-Unwind and Rewind System offers auto edge control that is accurate to ±1 mm, and auto jog that allows material to automatically advance when pulled over load cell roll. System's auto run mode automatically unwinds start tension control when tension set point is reached. Configurable, PID-controlled product allows enable/disable, under/over-wind, tapering, and side-lay of each winder. It is suited for webs up to 18 in. wide with 20 in. roll dia and 100 lb roll weight.
(Archive News Story - Products mentioned in this Archive News Story may or may not be available from the manufacturer.)
Original Press release
Glenro, Inc.
39 McBride Ave.
Paterson, NJ, 07501 1799
USA
NEW! Glenro Cantilevered Multi-Unwind & Rewind System
Glenro material handling solutions, like our new system below, can be provided with our heat processing equipment. Whether you are consolidating multiple webs prior to lamination or in need of less complex roll to roll material handling components, Glenro will work with you to develop reliable and repeatable Proven Solutions® for your material handling and heat processing applications.
System Features:
Auto Edge Control, accurate to ±1 mm
Auto Jog, material automatically advances when pulled over load cell roll
Auto Run Mode, unwinds start tension control automatically when tension set point is reached
Completely Configurable
- Cantilevered Load Cell
- Tension Set Point
- PID Controlled
Each winder can be:
- Enabled or disabled
- Unwind or rewind
- Under-wind or over-wind
- Taper on or off
- Side-lay enabled or disabled
Use with narrow webs:
Up to 18" wide
20" Roll Diameters
100 lb Roll Weight (illustrated)
For more information, contact
Rich Hoffmann
Director of Sales
Email: richeh@glenro.com
"Celebrating 50 years of Proven Solutions®!" Come visit us at www.glenro.com or call direct at 1-888-GLENRO1
|
|
|
|
|
|
|
| 
